| // SPDX-License-Identifier: BSD-3-Clause |
| /* |
| * Copyright (c) 2020, Konrad Dybcio |
| */ |
| |
| #include <dt-bindings/iio/qcom,spmi-vadc.h> |
| #include <dt-bindings/input/linux-event-codes.h> |
| #include <dt-bindings/interrupt-controller/irq.h> |
| #include <dt-bindings/spmi/spmi.h> |
| #include <dt-bindings/thermal/thermal.h> |
| |
| / { |
| thermal-zones { |
| pm660 { |
| polling-delay-passive = <250>; |
| polling-delay = <1000>; |
| |
| thermal-sensors = <&pm660_temp>; |
| |
| trips { |
| pm660_alert0: pm660-alert0 { |
| temperature = <95000>; |
| hysteresis = <2000>; |
| type = "passive"; |
| }; |
| pm660_crit: pm660-crit { |
| temperature = <125000>; |
| hysteresis = <2000>; |
| type = "critical"; |
| }; |
| }; |
| }; |
| }; |
| }; |
| |
| &spmi_bus { |
| |
| pmic@0 { |
| compatible = "qcom,pm660", "qcom,spmi-pmic"; |
| reg = <0x0 SPMI_USID>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| rtc@6000 { |
| compatible = "qcom,pm8941-rtc"; |
| reg = <0x6000>, <0x6100>; |
| reg-names = "rtc", "alarm"; |
| interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>; |
| }; |
| |
| pon: pon@800 { |
| compatible = "qcom,pm8998-pon"; |
| reg = <0x800>; |
| mode-bootloader = <0x2>; |
| mode-recovery = <0x1>; |
| |
| pwrkey { |
| compatible = "qcom,pm8941-pwrkey"; |
| interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>; |
| debounce = <15625>; |
| bias-pull-up; |
| linux,code = <KEY_POWER>; |
| }; |
| |
| }; |
| |
| pm660_temp: temp-alarm@2400 { |
| compatible = "qcom,spmi-temp-alarm"; |
| reg = <0x2400>; |
| interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_RISING>; |
| io-channels = <&pm660_adc ADC5_DIE_TEMP>; |
| io-channel-names = "thermal"; |
| #thermal-sensor-cells = <0>; |
| }; |
| |
| pm660_adc: adc@3100 { |
| compatible = "qcom,spmi-adc-rev2"; |
| reg = <0x3100>; |
| interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| #io-channel-cells = <1>; |
| |
| ref_gnd: ref_gnd@0 { |
| reg = <ADC5_REF_GND>; |
| qcom,decimation = <1024>; |
| qcom,pre-scaling = <1 1>; |
| }; |
| |
| vref_1p25: vref_1p25@1 { |
| reg = <ADC5_1P25VREF>; |
| qcom,decimation = <1024>; |
| qcom,pre-scaling = <1 1>; |
| }; |
| |
| die_temp: die_temp@6 { |
| reg = <ADC5_DIE_TEMP>; |
| qcom,decimation = <1024>; |
| qcom,pre-scaling = <1 1>; |
| }; |
| |
| xo_therm: xo_therm@4c { |
| reg = <ADC5_XO_THERM_100K_PU>; |
| qcom,pre-scaling = <1 1>; |
| qcom,decimation = <1024>; |
| qcom,hw-settle-time = <200>; |
| qcom,ratiometric; |
| }; |
| |
| msm_therm: msm_therm@4d { |
| reg = <ADC5_AMUX_THM1_100K_PU>; |
| qcom,pre-scaling = <1 1>; |
| qcom,decimation = <1024>; |
| qcom,hw-settle-time = <200>; |
| qcom,ratiometric; |
| }; |
| |
| emmc_therm: emmc_therm@4e { |
| reg = <ADC5_AMUX_THM2_100K_PU>; |
| qcom,pre-scaling = <1 1>; |
| qcom,decimation = <1024>; |
| qcom,hw-settle-time = <200>; |
| qcom,ratiometric; |
| }; |
| |
| pa_therm0: thermistor0@4f { |
| reg = <ADC5_AMUX_THM3_100K_PU>; |
| qcom,pre-scaling = <1 1>; |
| qcom,decimation = <1024>; |
| qcom,hw-settle-time = <200>; |
| qcom,ratiometric; |
| }; |
| |
| pa_therm1: thermistor1@50 { |
| reg = <ADC5_AMUX_THM4_100K_PU>; |
| qcom,pre-scaling = <1 1>; |
| qcom,decimation = <1024>; |
| qcom,hw-settle-time = <200>; |
| qcom,ratiometric; |
| }; |
| |
| quiet_therm: quiet_therm@51 { |
| reg = <ADC5_AMUX_THM5_100K_PU>; |
| qcom,pre-scaling = <1 1>; |
| qcom,decimation = <1024>; |
| qcom,hw-settle-time = <200>; |
| qcom,ratiometric; |
| }; |
| |
| vadc_vph_pwr: vph_pwr@83 { |
| reg = <ADC5_VPH_PWR>; |
| qcom,decimation = <1024>; |
| qcom,pre-scaling = <1 3>; |
| }; |
| |
| vcoin: vcoin@83 { |
| reg = <ADC5_VCOIN>; |
| qcom,decimation = <1024>; |
| qcom,pre-scaling = <1 3>; |
| }; |
| }; |
| |
| pm660_gpios: gpios@c000 { |
| compatible = "qcom,pm660-gpio"; |
| reg = <0xc000>; |
| gpio-controller; |
| gpio-ranges = <&pm660_gpios 0 0 13>; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| }; |
| }; |
| |
| pmic@1 { |
| compatible = "qcom,pm660", "qcom,spmi-pmic"; |
| reg = <0x1 SPMI_USID>; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| pm660_spmi_regulators: pm660-regulators { |
| compatible = "qcom,pm660-regulators"; |
| }; |
| }; |
| }; |