| // SPDX-License-Identifier: GPL-2.0-or-later |
| /* |
| * HiSilicon INNO USB2 PHY Driver. |
| * |
| * Copyright (c) 2016-2017 HiSilicon Technologies Co., Ltd. |
| */ |
| |
| #include <linux/clk.h> |
| #include <linux/delay.h> |
| #include <linux/io.h> |
| #include <linux/module.h> |
| #include <linux/platform_device.h> |
| #include <linux/phy/phy.h> |
| #include <linux/reset.h> |
| |
| #define INNO_PHY_PORT_NUM 2 |
| #define REF_CLK_STABLE_TIME 100 /* unit:us */ |
| #define UTMI_CLK_STABLE_TIME 200 /* unit:us */ |
| #define TEST_CLK_STABLE_TIME 2 /* unit:ms */ |
| #define PHY_CLK_STABLE_TIME 2 /* unit:ms */ |
| #define UTMI_RST_COMPLETE_TIME 2 /* unit:ms */ |
| #define POR_RST_COMPLETE_TIME 300 /* unit:us */ |
| #define PHY_TEST_DATA GENMASK(7, 0) |
| #define PHY_TEST_ADDR GENMASK(15, 8) |
| #define PHY_TEST_PORT GENMASK(18, 16) |
| #define PHY_TEST_WREN BIT(21) |
| #define PHY_TEST_CLK BIT(22) /* rising edge active */ |
| #define PHY_TEST_RST BIT(23) /* low active */ |
| #define PHY_CLK_ENABLE BIT(2) |
| |
| struct hisi_inno_phy_port { |
| struct reset_control *utmi_rst; |
| struct hisi_inno_phy_priv *priv; |
| }; |
| |
| struct hisi_inno_phy_priv { |
| void __iomem *mmio; |
| struct clk *ref_clk; |
| struct reset_control *por_rst; |
| struct hisi_inno_phy_port ports[INNO_PHY_PORT_NUM]; |
| }; |
| |
| static void hisi_inno_phy_write_reg(struct hisi_inno_phy_priv *priv, |
| u8 port, u32 addr, u32 data) |
| { |
| void __iomem *reg = priv->mmio; |
| u32 val; |
| |
| val = (data & PHY_TEST_DATA) | |
| ((addr << 8) & PHY_TEST_ADDR) | |
| ((port << 16) & PHY_TEST_PORT) | |
| PHY_TEST_WREN | PHY_TEST_RST; |
| writel(val, reg); |
| |
| val |= PHY_TEST_CLK; |
| writel(val, reg); |
| |
| val &= ~PHY_TEST_CLK; |
| writel(val, reg); |
| } |
| |
| static void hisi_inno_phy_setup(struct hisi_inno_phy_priv *priv) |
| { |
| /* The phy clk is controlled by the port0 register 0x06. */ |
| hisi_inno_phy_write_reg(priv, 0, 0x06, PHY_CLK_ENABLE); |
| msleep(PHY_CLK_STABLE_TIME); |
| } |
| |
| static int hisi_inno_phy_init(struct phy *phy) |
| { |
| struct hisi_inno_phy_port *port = phy_get_drvdata(phy); |
| struct hisi_inno_phy_priv *priv = port->priv; |
| int ret; |
| |
| ret = clk_prepare_enable(priv->ref_clk); |
| if (ret) |
| return ret; |
| udelay(REF_CLK_STABLE_TIME); |
| |
| reset_control_deassert(priv->por_rst); |
| udelay(POR_RST_COMPLETE_TIME); |
| |
| /* Set up phy registers */ |
| hisi_inno_phy_setup(priv); |
| |
| reset_control_deassert(port->utmi_rst); |
| udelay(UTMI_RST_COMPLETE_TIME); |
| |
| return 0; |
| } |
| |
| static int hisi_inno_phy_exit(struct phy *phy) |
| { |
| struct hisi_inno_phy_port *port = phy_get_drvdata(phy); |
| struct hisi_inno_phy_priv *priv = port->priv; |
| |
| reset_control_assert(port->utmi_rst); |
| reset_control_assert(priv->por_rst); |
| clk_disable_unprepare(priv->ref_clk); |
| |
| return 0; |
| } |
| |
| static const struct phy_ops hisi_inno_phy_ops = { |
| .init = hisi_inno_phy_init, |
| .exit = hisi_inno_phy_exit, |
| .owner = THIS_MODULE, |
| }; |
| |
| static int hisi_inno_phy_probe(struct platform_device *pdev) |
| { |
| struct device *dev = &pdev->dev; |
| struct device_node *np = dev->of_node; |
| struct hisi_inno_phy_priv *priv; |
| struct phy_provider *provider; |
| struct device_node *child; |
| struct resource *res; |
| int i = 0; |
| int ret; |
| |
| priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 0); |
| priv->mmio = devm_ioremap_resource(dev, res); |
| if (IS_ERR(priv->mmio)) { |
| ret = PTR_ERR(priv->mmio); |
| return ret; |
| } |
| |
| priv->ref_clk = devm_clk_get(dev, NULL); |
| if (IS_ERR(priv->ref_clk)) |
| return PTR_ERR(priv->ref_clk); |
| |
| priv->por_rst = devm_reset_control_get_exclusive(dev, NULL); |
| if (IS_ERR(priv->por_rst)) |
| return PTR_ERR(priv->por_rst); |
| |
| for_each_child_of_node(np, child) { |
| struct reset_control *rst; |
| struct phy *phy; |
| |
| rst = of_reset_control_get_exclusive(child, NULL); |
| if (IS_ERR(rst)) |
| return PTR_ERR(rst); |
| priv->ports[i].utmi_rst = rst; |
| priv->ports[i].priv = priv; |
| |
| phy = devm_phy_create(dev, child, &hisi_inno_phy_ops); |
| if (IS_ERR(phy)) |
| return PTR_ERR(phy); |
| |
| phy_set_bus_width(phy, 8); |
| phy_set_drvdata(phy, &priv->ports[i]); |
| i++; |
| |
| if (i > INNO_PHY_PORT_NUM) { |
| dev_warn(dev, "Support %d ports in maximum\n", i); |
| break; |
| } |
| } |
| |
| provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate); |
| return PTR_ERR_OR_ZERO(provider); |
| } |
| |
| static const struct of_device_id hisi_inno_phy_of_match[] = { |
| { .compatible = "hisilicon,inno-usb2-phy", }, |
| { .compatible = "hisilicon,hi3798cv200-usb2-phy", }, |
| { }, |
| }; |
| MODULE_DEVICE_TABLE(of, hisi_inno_phy_of_match); |
| |
| static struct platform_driver hisi_inno_phy_driver = { |
| .probe = hisi_inno_phy_probe, |
| .driver = { |
| .name = "hisi-inno-phy", |
| .of_match_table = hisi_inno_phy_of_match, |
| } |
| }; |
| module_platform_driver(hisi_inno_phy_driver); |
| |
| MODULE_DESCRIPTION("HiSilicon INNO USB2 PHY Driver"); |
| MODULE_LICENSE("GPL v2"); |