blob: f4fb1a92ab55a51a65638e7696ab245e91c8b240 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0
#include <dt-bindings/iio/qcom,spmi-vadc.h>
#include <dt-bindings/input/linux-event-codes.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
&spmi_bus {
pm8916_0: pmic@0 {
compatible = "qcom,pm8916", "qcom,spmi-pmic";
reg = <0x0 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pon@800 {
compatible = "qcom,pm8916-pon";
reg = <0x800>;
mode-bootloader = <0x2>;
mode-recovery = <0x1>;
pwrkey {
compatible = "qcom,pm8941-pwrkey";
interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
linux,code = <KEY_POWER>;
};
pm8916_resin: resin {
compatible = "qcom,pm8941-resin";
interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
status = "disabled";
};
watchdog {
compatible = "qcom,pm8916-wdt";
interrupts = <0x0 0x8 6 IRQ_TYPE_EDGE_RISING>;
timeout-sec = <60>;
};
};
pm8916_usbin: usb-detect@1300 {
compatible = "qcom,pm8941-misc";
reg = <0x1300>;
interrupts = <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>;
interrupt-names = "usb_vbus";
status = "disabled";
};
pm8916_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
reg = <0x2400>;
interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
io-channel-names = "thermal";
#thermal-sensor-cells = <0>;
};
pm8916_vadc: adc@3100 {
compatible = "qcom,spmi-vadc";
reg = <0x3100>;
interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
adc-chan@0 {
reg = <VADC_USBIN>;
qcom,pre-scaling = <1 10>;
};
adc-chan@7 {
reg = <VADC_VSYS>;
qcom,pre-scaling = <1 3>;
};
adc-chan@8 {
reg = <VADC_DIE_TEMP>;
};
adc-chan@9 {
reg = <VADC_REF_625MV>;
};
adc-chan@a {
reg = <VADC_REF_1250MV>;
};
adc-chan@e {
reg = <VADC_GND_REF>;
};
adc-chan@f {
reg = <VADC_VDD_VADC>;
};
};
rtc@6000 {
compatible = "qcom,pm8941-rtc";
reg = <0x6000>, <0x6100>;
reg-names = "rtc", "alarm";
interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
};
pm8916_mpps: mpps@a000 {
compatible = "qcom,pm8916-mpp", "qcom,spmi-mpp";
reg = <0xa000>;
gpio-controller;
#gpio-cells = <2>;
gpio-ranges = <&pm8916_mpps 0 0 4>;
interrupt-controller;
#interrupt-cells = <2>;
};
pm8916_gpios: gpio@c000 {
compatible = "qcom,pm8916-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
gpio-controller;
gpio-ranges = <&pm8916_gpios 0 0 4>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
};
pm8916_1: pmic@1 {
compatible = "qcom,pm8916", "qcom,spmi-pmic";
reg = <0x1 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pm8916_pwm: pwm {
compatible = "qcom,pm8916-pwm";
#pwm-cells = <2>;
status = "disabled";
};
pm8916_vib: vibrator@c000 {
compatible = "qcom,pm8916-vib";
reg = <0xc000>;
status = "disabled";
};
wcd_codec: audio-codec@f000 {
compatible = "qcom,pm8916-wcd-analog-codec";
reg = <0xf000>;
reg-names = "pmic-codec-core";
clocks = <&gcc GCC_CODEC_DIGCODEC_CLK>;
clock-names = "mclk";
interrupt-parent = <&spmi_bus>;
interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>,
<0x1 0xf0 0x1 IRQ_TYPE_NONE>,
<0x1 0xf0 0x2 IRQ_TYPE_NONE>,
<0x1 0xf0 0x3 IRQ_TYPE_NONE>,
<0x1 0xf0 0x4 IRQ_TYPE_NONE>,
<0x1 0xf0 0x5 IRQ_TYPE_NONE>,
<0x1 0xf0 0x6 IRQ_TYPE_NONE>,
<0x1 0xf0 0x7 IRQ_TYPE_NONE>,
<0x1 0xf1 0x0 IRQ_TYPE_NONE>,
<0x1 0xf1 0x1 IRQ_TYPE_NONE>,
<0x1 0xf1 0x2 IRQ_TYPE_NONE>,
<0x1 0xf1 0x3 IRQ_TYPE_NONE>,
<0x1 0xf1 0x4 IRQ_TYPE_NONE>,
<0x1 0xf1 0x5 IRQ_TYPE_NONE>;
interrupt-names = "cdc_spk_cnp_int",
"cdc_spk_clip_int",
"cdc_spk_ocp_int",
"mbhc_ins_rem_det1",
"mbhc_but_rel_det",
"mbhc_but_press_det",
"mbhc_ins_rem_det",
"mbhc_switch_int",
"cdc_ear_ocp_int",
"cdc_hphr_ocp_int",
"cdc_hphl_ocp_det",
"cdc_ear_cnp_int",
"cdc_hphr_cnp_int",
"cdc_hphl_cnp_int";
vdd-cdc-io-supply = <&pm8916_l5>;
vdd-cdc-tx-rx-cx-supply = <&pm8916_l5>;
vdd-micbias-supply = <&pm8916_l13>;
#sound-dai-cells = <1>;
};
};
};