| * Microchip WILC wireless SDIO device |
| |
| The wilc1000 chips can be connected via SDIO. The node is used to specifiy |
| child node to the SDIO controller that connects the device to the system. |
| |
| Required properties: |
| - compatible : Should be "microchip,wilc1000-spi" |
| - irq-gpios : Connect to a host IRQ |
| - reg : Slot ID used in the controller |
| |
| Optional: |
| - bus-width : Number of data lines wired up the slot. Default 1 bit. |
| |
| |
| Examples: |
| mmc1: mmc@fc000000 { |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_mmc1_clk_cmd_dat0 &pinctrl_mmc1_dat1_3>; |
| non-removable; |
| vmmc-supply = <&vcc_mmc1_reg>; |
| vqmmc-supply = <&vcc_3v3_reg>; |
| status = "okay"; |
| |
| wilc_sdio@0 { |
| compatible = "microchip,wilc1000-sdio"; |
| irq-gpios = <&pioC 27 0>; |
| status = "okay"; |
| reg = <0>; |
| bus-width = <4>; |
| } |
| }; |
| } |
