blob: 2559ada7e40104da777b07cb2adaa21e6629c01d [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0+
//
// Copyright 2023 Linaro Ltd.
/dts-v1/;
#include <dt-bindings/pwm/pwm.h>
#include "imx53-sk-imx53-atm0700d4.dtsi"
/ {
display: disp0 {
compatible = "fsl,imx-parallel-display";
interface-pix-fmt = "rgb24";
pinctrl-0 = <&pinctrl_rgb24>;
pinctrl-names = "default";
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
display0_in: endpoint {
remote-endpoint = <&ipu_di0_disp0>;
};
};
port@1 {
reg = <1>;
display_out: endpoint {
remote-endpoint = <&panel_rgb_in>;
};
};
};
};
&iomuxc {
pinctrl_rgb24: rgb24grp {
fsl,pins = <
MX53_PAD_DI0_DISP_CLK__IPU_DI0_DISP_CLK 0x5
MX53_PAD_DI0_PIN15__IPU_DI0_PIN15 0x5
MX53_PAD_DI0_PIN2__IPU_DI0_PIN2 0x5
MX53_PAD_DI0_PIN3__IPU_DI0_PIN3 0x5
MX53_PAD_DISP0_DAT0__IPU_DISP0_DAT_0 0x5
MX53_PAD_DISP0_DAT1__IPU_DISP0_DAT_1 0x5
MX53_PAD_DISP0_DAT2__IPU_DISP0_DAT_2 0x5
MX53_PAD_DISP0_DAT3__IPU_DISP0_DAT_3 0x5
MX53_PAD_DISP0_DAT4__IPU_DISP0_DAT_4 0x5
MX53_PAD_DISP0_DAT5__IPU_DISP0_DAT_5 0x5
MX53_PAD_DISP0_DAT6__IPU_DISP0_DAT_6 0x5
MX53_PAD_DISP0_DAT7__IPU_DISP0_DAT_7 0x5
MX53_PAD_DISP0_DAT8__IPU_DISP0_DAT_8 0x5
MX53_PAD_DISP0_DAT9__IPU_DISP0_DAT_9 0x5
MX53_PAD_DISP0_DAT10__IPU_DISP0_DAT_10 0x5
MX53_PAD_DISP0_DAT11__IPU_DISP0_DAT_11 0x5
MX53_PAD_DISP0_DAT12__IPU_DISP0_DAT_12 0x5
MX53_PAD_DISP0_DAT13__IPU_DISP0_DAT_13 0x5
MX53_PAD_DISP0_DAT14__IPU_DISP0_DAT_14 0x5
MX53_PAD_DISP0_DAT15__IPU_DISP0_DAT_15 0x5
MX53_PAD_DISP0_DAT16__IPU_DISP0_DAT_16 0x5
MX53_PAD_DISP0_DAT17__IPU_DISP0_DAT_17 0x5
MX53_PAD_DISP0_DAT18__IPU_DISP0_DAT_18 0x5
MX53_PAD_DISP0_DAT19__IPU_DISP0_DAT_19 0x5
MX53_PAD_DISP0_DAT20__IPU_DISP0_DAT_20 0x5
MX53_PAD_DISP0_DAT21__IPU_DISP0_DAT_21 0x5
MX53_PAD_DISP0_DAT22__IPU_DISP0_DAT_22 0x5
MX53_PAD_DISP0_DAT23__IPU_DISP0_DAT_23 0x5
>;
};
pinctrl_spi_gpio: spigrp {
fsl,pins = <
MX53_PAD_SD1_DATA1__GPIO1_17 0x1f4
MX53_PAD_GPIO_7__GPIO1_7 0x1f4
MX53_PAD_PATA_DATA3__GPIO2_3 0x1f4
MX53_PAD_PATA_DATA8__GPIO2_8 0x1f4
>;
};
};
&ipu_di0_disp0 {
remote-endpoint = <&display0_in>;
};
&panel {
enable-gpios = <&gpio1 9 GPIO_ACTIVE_HIGH>;
};
&panel_rgb_in {
remote-endpoint = <&display_out>;
};
&pwm1 {
status = "disabled";
};
&spi_ts {
pinctrl-0 = <&pinctrl_spi_gpio>;
pinctrl-names = "default";
sck-gpios = <&gpio1 7 GPIO_ACTIVE_HIGH>;
mosi-gpios = <&gpio2 3 GPIO_ACTIVE_HIGH>;
miso-gpios = <&gpio1 17 GPIO_ACTIVE_HIGH>;
cs-gpios = <&gpio2 8 GPIO_ACTIVE_HIGH>;
};
&touchscreen {
interrupts-extended = <&gpio2 6 IRQ_TYPE_EDGE_BOTH>;
pendown-gpio = <&gpio2 6 GPIO_ACTIVE_LOW>;
};