| * STMicroelectronics : NFC Transceiver ST95HF |
| ST NFC Transceiver is required to attach with SPI bus. |
| ST95HF node should be defined in DT as SPI slave device of SPI |
| master with which ST95HF transceiver is physically connected. |
| The properties defined below are required to be the part of DT |
| to include ST95HF transceiver into the platform. |
| - reg: Address of SPI slave "ST95HF transceiver" on SPI master bus. |
| - compatible: should be "st,st95hf" for ST95HF NFC transceiver |
| - spi-max-frequency: Max. operating SPI frequency for ST95HF |
| - enable-gpio: GPIO line to enable ST95HF transceiver. |
| - interrupt-parent : Standard way to specify the controller to which |
| ST95HF transceiver's interrupt is routed. |
| - interrupts : Standard way to define ST95HF transceiver's out |
| - st95hfvin-supply : This is an optional property. It contains a |
| phandle to ST95HF transceiver's regulator supply node in DT. |
| compatible = "st,st95hf"; |
| spi-max-frequency = <1000000>; |
| interrupt-parent = <&pio0>; |
| interrupts = <7 IRQ_TYPE_EDGE_FALLING>; |