| /* SPDX-License-Identifier: GPL-2.0 */ |
| |
| /* Copyright (c) 2012-2018, The Linux Foundation. All rights reserved. |
| * Copyright (C) 2019-2020 Linaro Ltd. |
| */ |
| #ifndef _IPA_ENDPOINT_H_ |
| #define _IPA_ENDPOINT_H_ |
| |
| #include <linux/types.h> |
| #include <linux/workqueue.h> |
| #include <linux/if_ether.h> |
| |
| #include "gsi.h" |
| #include "ipa_reg.h" |
| |
| struct net_device; |
| struct sk_buff; |
| |
| struct ipa; |
| struct ipa_gsi_endpoint_data; |
| |
| /* Non-zero granularity of counter used to implement aggregation timeout */ |
| #define IPA_AGGR_GRANULARITY 500 /* microseconds */ |
| |
| #define IPA_MTU ETH_DATA_LEN |
| |
| enum ipa_endpoint_name { |
| IPA_ENDPOINT_AP_COMMAND_TX, |
| IPA_ENDPOINT_AP_LAN_RX, |
| IPA_ENDPOINT_AP_MODEM_TX, |
| IPA_ENDPOINT_AP_MODEM_RX, |
| IPA_ENDPOINT_MODEM_COMMAND_TX, |
| IPA_ENDPOINT_MODEM_LAN_TX, |
| IPA_ENDPOINT_MODEM_LAN_RX, |
| IPA_ENDPOINT_MODEM_AP_TX, |
| IPA_ENDPOINT_MODEM_AP_RX, |
| IPA_ENDPOINT_MODEM_DL_NLO_TX, |
| IPA_ENDPOINT_COUNT, /* Number of names (not an index) */ |
| }; |
| |
| #define IPA_ENDPOINT_MAX 32 /* Max supported by driver */ |
| |
| /** |
| * struct ipa_endpoint_tx - Endpoint configuration for TX endpoints |
| * @seq_type: primary packet processing sequencer type |
| * @seq_rep_type: sequencer type for replication processing |
| * @status_endpoint: endpoint to which status elements are sent |
| * |
| * The @status_endpoint is only valid if the endpoint's @status_enable |
| * flag is set. |
| */ |
| struct ipa_endpoint_tx { |
| enum ipa_seq_type seq_type; |
| enum ipa_seq_rep_type seq_rep_type; |
| enum ipa_endpoint_name status_endpoint; |
| }; |
| |
| /** |
| * struct ipa_endpoint_rx - Endpoint configuration for RX endpoints |
| * @buffer_size: requested receive buffer size (bytes) |
| * @pad_align: power-of-2 boundary to which packet payload is aligned |
| * @aggr_time_limit: time before aggregation closes (microseconds) |
| * @aggr_hard_limit: whether aggregation closes before or after boundary |
| * @aggr_close_eof: whether aggregation closes on end-of-frame |
| * @holb_drop: whether to drop packets to avoid head-of-line blocking |
| * |
| * The actual size of the receive buffer is rounded up if necessary |
| * to be a power-of-2 number of pages. |
| * |
| * With each packet it transfers, the IPA hardware can perform certain |
| * transformations of its packet data. One of these is adding pad bytes |
| * to the end of the packet data so the result ends on a power-of-2 boundary. |
| * |
| * It is also able to aggregate multiple packets into a single receive buffer. |
| * Aggregation is "open" while a buffer is being filled, and "closes" when |
| * certain criteria are met. |
| * |
| * A time limit can be specified to close aggregation. Aggregation will be |
| * closed if this period passes after data is first written into a receive |
| * buffer. If not specified, no time limit is imposed. |
| * |
| * Insufficient space available in the receive buffer can close aggregation. |
| * The aggregation byte limit defines the point (in units of 1024 bytes) in |
| * the buffer where aggregation closes. With a "soft" aggregation limit, |
| * aggregation closes when a packet written to the buffer *crosses* that |
| * aggregation limit. With a "hard" aggregation limit, aggregation will |
| * close *before* writing a packet that would cross that boundary. |
| */ |
| struct ipa_endpoint_rx { |
| u32 buffer_size; |
| u32 pad_align; |
| u32 aggr_time_limit; |
| bool aggr_hard_limit; |
| bool aggr_close_eof; |
| bool holb_drop; |
| }; |
| |
| /** |
| * struct ipa_endpoint_config - IPA endpoint hardware configuration |
| * @resource_group: resource group to assign endpoint to |
| * @checksum: whether checksum offload is enabled |
| * @qmap: whether endpoint uses QMAP protocol |
| * @aggregation: whether endpoint supports aggregation |
| * @status_enable: whether endpoint uses status elements |
| * @dma_mode: whether endpoint operates in DMA mode |
| * @dma_endpoint: peer endpoint, if operating in DMA mode |
| * @tx: TX-specific endpoint information (see above) |
| * @rx: RX-specific endpoint information (see above) |
| */ |
| struct ipa_endpoint_config { |
| u32 resource_group; |
| bool checksum; |
| bool qmap; |
| bool aggregation; |
| bool status_enable; |
| bool dma_mode; |
| enum ipa_endpoint_name dma_endpoint; |
| union { |
| struct ipa_endpoint_tx tx; |
| struct ipa_endpoint_rx rx; |
| }; |
| }; |
| |
| /** |
| * enum ipa_replenish_flag: RX buffer replenish flags |
| * |
| * @IPA_REPLENISH_ENABLED: Whether receive buffer replenishing is enabled |
| * @IPA_REPLENISH_ACTIVE: Whether replenishing is underway |
| * @IPA_REPLENISH_COUNT: Number of defined replenish flags |
| */ |
| enum ipa_replenish_flag { |
| IPA_REPLENISH_ENABLED, |
| IPA_REPLENISH_ACTIVE, |
| IPA_REPLENISH_COUNT, /* Number of flags (must be last) */ |
| }; |
| |
| /** |
| * struct ipa_endpoint - IPA endpoint information |
| * @ipa: IPA pointer |
| * @ee_id: Execution environmnent endpoint is associated with |
| * @channel_id: GSI channel used by the endpoint |
| * @endpoint_id: IPA endpoint number |
| * @toward_ipa: Endpoint direction (true = TX, false = RX) |
| * @config: Default endpoint configuration |
| * @trans_tre_max: Maximum number of TRE descriptors per transaction |
| * @evt_ring_id: GSI event ring used by the endpoint |
| * @netdev: Network device pointer, if endpoint uses one |
| * @replenish_flags: Replenishing state flags |
| * @replenish_count: Total number of replenish transactions committed |
| * @replenish_work: Work item used for repeated replenish failures |
| */ |
| struct ipa_endpoint { |
| struct ipa *ipa; |
| enum gsi_ee_id ee_id; |
| u32 channel_id; |
| u32 endpoint_id; |
| bool toward_ipa; |
| struct ipa_endpoint_config config; |
| |
| u32 trans_tre_max; |
| u32 evt_ring_id; |
| |
| /* Net device this endpoint is associated with, if any */ |
| struct net_device *netdev; |
| |
| /* Receive buffer replenishing for RX endpoints */ |
| DECLARE_BITMAP(replenish_flags, IPA_REPLENISH_COUNT); |
| u64 replenish_count; |
| struct delayed_work replenish_work; /* global wq */ |
| }; |
| |
| void ipa_endpoint_modem_hol_block_clear_all(struct ipa *ipa); |
| |
| void ipa_endpoint_modem_pause_all(struct ipa *ipa, bool enable); |
| |
| int ipa_endpoint_modem_exception_reset_all(struct ipa *ipa); |
| |
| int ipa_endpoint_skb_tx(struct ipa_endpoint *endpoint, struct sk_buff *skb); |
| |
| int ipa_endpoint_enable_one(struct ipa_endpoint *endpoint); |
| void ipa_endpoint_disable_one(struct ipa_endpoint *endpoint); |
| |
| void ipa_endpoint_suspend_one(struct ipa_endpoint *endpoint); |
| void ipa_endpoint_resume_one(struct ipa_endpoint *endpoint); |
| |
| void ipa_endpoint_suspend(struct ipa *ipa); |
| void ipa_endpoint_resume(struct ipa *ipa); |
| |
| void ipa_endpoint_setup(struct ipa *ipa); |
| void ipa_endpoint_teardown(struct ipa *ipa); |
| |
| int ipa_endpoint_config(struct ipa *ipa); |
| void ipa_endpoint_deconfig(struct ipa *ipa); |
| |
| void ipa_endpoint_default_route_set(struct ipa *ipa, u32 endpoint_id); |
| void ipa_endpoint_default_route_clear(struct ipa *ipa); |
| |
| u32 ipa_endpoint_init(struct ipa *ipa, u32 count, |
| const struct ipa_gsi_endpoint_data *data); |
| void ipa_endpoint_exit(struct ipa *ipa); |
| |
| void ipa_endpoint_trans_complete(struct ipa_endpoint *ipa, |
| struct gsi_trans *trans); |
| void ipa_endpoint_trans_release(struct ipa_endpoint *ipa, |
| struct gsi_trans *trans); |
| |
| #endif /* _IPA_ENDPOINT_H_ */ |