| // SPDX-License-Identifier: GPL-2.0+ |
| // Copyright 2018 IBM Corporation |
| |
| #include <linux/clk.h> |
| #include <linux/reset.h> |
| #include <linux/regmap.h> |
| |
| #include <drm/drm_device.h> |
| #include <drm/drm_fb_dma_helper.h> |
| #include <drm/drm_fourcc.h> |
| #include <drm/drm_framebuffer.h> |
| #include <drm/drm_gem_atomic_helper.h> |
| #include <drm/drm_gem_dma_helper.h> |
| #include <drm/drm_panel.h> |
| #include <drm/drm_simple_kms_helper.h> |
| #include <drm/drm_vblank.h> |
| |
| #include "aspeed_gfx.h" |
| |
| static struct aspeed_gfx * |
| drm_pipe_to_aspeed_gfx(struct drm_simple_display_pipe *pipe) |
| { |
| return container_of(pipe, struct aspeed_gfx, pipe); |
| } |
| |
| static int aspeed_gfx_set_pixel_fmt(struct aspeed_gfx *priv, u32 *bpp) |
| { |
| struct drm_crtc *crtc = &priv->pipe.crtc; |
| struct drm_device *drm = crtc->dev; |
| const u32 format = crtc->primary->state->fb->format->format; |
| u32 ctrl1; |
| |
| ctrl1 = readl(priv->base + CRT_CTRL1); |
| ctrl1 &= ~CRT_CTRL_COLOR_MASK; |
| |
| switch (format) { |
| case DRM_FORMAT_RGB565: |
| dev_dbg(drm->dev, "Setting up RGB565 mode\n"); |
| ctrl1 |= CRT_CTRL_COLOR_RGB565; |
| *bpp = 16; |
| break; |
| case DRM_FORMAT_XRGB8888: |
| dev_dbg(drm->dev, "Setting up XRGB8888 mode\n"); |
| ctrl1 |= CRT_CTRL_COLOR_XRGB8888; |
| *bpp = 32; |
| break; |
| default: |
| dev_err(drm->dev, "Unhandled pixel format %08x\n", format); |
| return -EINVAL; |
| } |
| |
| writel(ctrl1, priv->base + CRT_CTRL1); |
| |
| return 0; |
| } |
| |
| static void aspeed_gfx_enable_controller(struct aspeed_gfx *priv) |
| { |
| u32 ctrl1 = readl(priv->base + CRT_CTRL1); |
| u32 ctrl2 = readl(priv->base + CRT_CTRL2); |
| |
| /* Set DAC source for display output to Graphics CRT (GFX) */ |
| regmap_update_bits(priv->scu, priv->dac_reg, BIT(16), BIT(16)); |
| |
| writel(ctrl1 | CRT_CTRL_EN, priv->base + CRT_CTRL1); |
| writel(ctrl2 | CRT_CTRL_DAC_EN, priv->base + CRT_CTRL2); |
| } |
| |
| static void aspeed_gfx_disable_controller(struct aspeed_gfx *priv) |
| { |
| u32 ctrl1 = readl(priv->base + CRT_CTRL1); |
| u32 ctrl2 = readl(priv->base + CRT_CTRL2); |
| |
| writel(ctrl1 & ~CRT_CTRL_EN, priv->base + CRT_CTRL1); |
| writel(ctrl2 & ~CRT_CTRL_DAC_EN, priv->base + CRT_CTRL2); |
| |
| regmap_update_bits(priv->scu, priv->dac_reg, BIT(16), 0); |
| } |
| |
| static void aspeed_gfx_crtc_mode_set_nofb(struct aspeed_gfx *priv) |
| { |
| struct drm_display_mode *m = &priv->pipe.crtc.state->adjusted_mode; |
| u32 ctrl1, d_offset, t_count, bpp; |
| int err; |
| |
| err = aspeed_gfx_set_pixel_fmt(priv, &bpp); |
| if (err) |
| return; |
| |
| #if 0 |
| /* TODO: we have only been able to test with the 40MHz USB clock. The |
| * clock is fixed, so we cannot adjust it here. */ |
| clk_set_rate(priv->pixel_clk, m->crtc_clock * 1000); |
| #endif |
| |
| ctrl1 = readl(priv->base + CRT_CTRL1); |
| ctrl1 &= ~(CRT_CTRL_INTERLACED | |
| CRT_CTRL_HSYNC_NEGATIVE | |
| CRT_CTRL_VSYNC_NEGATIVE); |
| |
| if (m->flags & DRM_MODE_FLAG_INTERLACE) |
| ctrl1 |= CRT_CTRL_INTERLACED; |
| |
| if (!(m->flags & DRM_MODE_FLAG_PHSYNC)) |
| ctrl1 |= CRT_CTRL_HSYNC_NEGATIVE; |
| |
| if (!(m->flags & DRM_MODE_FLAG_PVSYNC)) |
| ctrl1 |= CRT_CTRL_VSYNC_NEGATIVE; |
| |
| writel(ctrl1, priv->base + CRT_CTRL1); |
| |
| /* Horizontal timing */ |
| writel(CRT_H_TOTAL(m->htotal - 1) | CRT_H_DE(m->hdisplay - 1), |
| priv->base + CRT_HORIZ0); |
| writel(CRT_H_RS_START(m->hsync_start - 1) | CRT_H_RS_END(m->hsync_end), |
| priv->base + CRT_HORIZ1); |
| |
| |
| /* Vertical timing */ |
| writel(CRT_V_TOTAL(m->vtotal - 1) | CRT_V_DE(m->vdisplay - 1), |
| priv->base + CRT_VERT0); |
| writel(CRT_V_RS_START(m->vsync_start) | CRT_V_RS_END(m->vsync_end), |
| priv->base + CRT_VERT1); |
| |
| /* |
| * Display Offset: address difference between consecutive scan lines |
| * Terminal Count: memory size of one scan line |
| */ |
| d_offset = m->hdisplay * bpp / 8; |
| t_count = DIV_ROUND_UP(m->hdisplay * bpp, priv->scan_line_max); |
| |
| writel(CRT_DISP_OFFSET(d_offset) | CRT_TERM_COUNT(t_count), |
| priv->base + CRT_OFFSET); |
| |
| /* |
| * Threshold: FIFO thresholds of refill and stop (16 byte chunks |
| * per line, rounded up) |
| */ |
| writel(priv->throd_val, priv->base + CRT_THROD); |
| } |
| |
| static void aspeed_gfx_pipe_enable(struct drm_simple_display_pipe *pipe, |
| struct drm_crtc_state *crtc_state, |
| struct drm_plane_state *plane_state) |
| { |
| struct aspeed_gfx *priv = drm_pipe_to_aspeed_gfx(pipe); |
| struct drm_crtc *crtc = &pipe->crtc; |
| |
| aspeed_gfx_crtc_mode_set_nofb(priv); |
| aspeed_gfx_enable_controller(priv); |
| drm_crtc_vblank_on(crtc); |
| } |
| |
| static void aspeed_gfx_pipe_disable(struct drm_simple_display_pipe *pipe) |
| { |
| struct aspeed_gfx *priv = drm_pipe_to_aspeed_gfx(pipe); |
| struct drm_crtc *crtc = &pipe->crtc; |
| |
| drm_crtc_vblank_off(crtc); |
| aspeed_gfx_disable_controller(priv); |
| } |
| |
| static void aspeed_gfx_pipe_update(struct drm_simple_display_pipe *pipe, |
| struct drm_plane_state *plane_state) |
| { |
| struct aspeed_gfx *priv = drm_pipe_to_aspeed_gfx(pipe); |
| struct drm_crtc *crtc = &pipe->crtc; |
| struct drm_framebuffer *fb = pipe->plane.state->fb; |
| struct drm_pending_vblank_event *event; |
| struct drm_gem_dma_object *gem; |
| |
| spin_lock_irq(&crtc->dev->event_lock); |
| event = crtc->state->event; |
| if (event) { |
| crtc->state->event = NULL; |
| |
| if (drm_crtc_vblank_get(crtc) == 0) |
| drm_crtc_arm_vblank_event(crtc, event); |
| else |
| drm_crtc_send_vblank_event(crtc, event); |
| } |
| spin_unlock_irq(&crtc->dev->event_lock); |
| |
| if (!fb) |
| return; |
| |
| gem = drm_fb_dma_get_gem_obj(fb, 0); |
| if (!gem) |
| return; |
| writel(gem->dma_addr, priv->base + CRT_ADDR); |
| } |
| |
| static int aspeed_gfx_enable_vblank(struct drm_simple_display_pipe *pipe) |
| { |
| struct aspeed_gfx *priv = drm_pipe_to_aspeed_gfx(pipe); |
| u32 reg = readl(priv->base + CRT_CTRL1); |
| |
| /* Clear pending VBLANK IRQ */ |
| writel(reg | CRT_CTRL_VERTICAL_INTR_STS, priv->base + CRT_CTRL1); |
| |
| reg |= CRT_CTRL_VERTICAL_INTR_EN; |
| writel(reg, priv->base + CRT_CTRL1); |
| |
| return 0; |
| } |
| |
| static void aspeed_gfx_disable_vblank(struct drm_simple_display_pipe *pipe) |
| { |
| struct aspeed_gfx *priv = drm_pipe_to_aspeed_gfx(pipe); |
| u32 reg = readl(priv->base + CRT_CTRL1); |
| |
| reg &= ~CRT_CTRL_VERTICAL_INTR_EN; |
| writel(reg, priv->base + CRT_CTRL1); |
| |
| /* Clear pending VBLANK IRQ */ |
| writel(reg | CRT_CTRL_VERTICAL_INTR_STS, priv->base + CRT_CTRL1); |
| } |
| |
| static const struct drm_simple_display_pipe_funcs aspeed_gfx_funcs = { |
| .enable = aspeed_gfx_pipe_enable, |
| .disable = aspeed_gfx_pipe_disable, |
| .update = aspeed_gfx_pipe_update, |
| .enable_vblank = aspeed_gfx_enable_vblank, |
| .disable_vblank = aspeed_gfx_disable_vblank, |
| }; |
| |
| static const uint32_t aspeed_gfx_formats[] = { |
| DRM_FORMAT_XRGB8888, |
| DRM_FORMAT_RGB565, |
| }; |
| |
| int aspeed_gfx_create_pipe(struct drm_device *drm) |
| { |
| struct aspeed_gfx *priv = to_aspeed_gfx(drm); |
| |
| return drm_simple_display_pipe_init(drm, &priv->pipe, &aspeed_gfx_funcs, |
| aspeed_gfx_formats, |
| ARRAY_SIZE(aspeed_gfx_formats), |
| NULL, |
| &priv->connector); |
| } |