| // SPDX-License-Identifier: GPL-2.0+ |
| // |
| // Functions to access SY3686A power management chip voltages |
| // |
| // Copyright (C) 2019 reMarkable AS - http://www.remarkable.com/ |
| // |
| // Authors: Lars Ivar Miljeteig <lars.ivar.miljeteig@remarkable.com> |
| // Alistair Francis <alistair@alistair23.me> |
| |
| #include <linux/gpio/consumer.h> |
| #include <linux/i2c.h> |
| #include <linux/mfd/sy7636a.h> |
| #include <linux/module.h> |
| #include <linux/platform_device.h> |
| #include <linux/regulator/driver.h> |
| #include <linux/regulator/machine.h> |
| #include <linux/regmap.h> |
| |
| struct sy7636a_data { |
| struct regmap *regmap; |
| struct gpio_desc *pgood_gpio; |
| }; |
| |
| static int sy7636a_get_vcom_voltage_op(struct regulator_dev *rdev) |
| { |
| int ret; |
| unsigned int val, val_h; |
| |
| ret = regmap_read(rdev->regmap, SY7636A_REG_VCOM_ADJUST_CTRL_L, &val); |
| if (ret) |
| return ret; |
| |
| ret = regmap_read(rdev->regmap, SY7636A_REG_VCOM_ADJUST_CTRL_H, &val_h); |
| if (ret) |
| return ret; |
| |
| val |= (val_h << VCOM_ADJUST_CTRL_SHIFT); |
| |
| return (val & VCOM_ADJUST_CTRL_MASK) * VCOM_ADJUST_CTRL_SCAL; |
| } |
| |
| static int sy7636a_get_status(struct regulator_dev *rdev) |
| { |
| struct sy7636a_data *data = dev_get_drvdata(rdev->dev.parent); |
| int ret = 0; |
| |
| ret = gpiod_get_value_cansleep(data->pgood_gpio); |
| if (ret < 0) |
| dev_err(&rdev->dev, "Failed to read pgood gpio: %d\n", ret); |
| |
| return ret; |
| } |
| |
| static const struct regulator_ops sy7636a_vcom_volt_ops = { |
| .get_voltage = sy7636a_get_vcom_voltage_op, |
| .enable = regulator_enable_regmap, |
| .disable = regulator_disable_regmap, |
| .is_enabled = regulator_is_enabled_regmap, |
| .get_status = sy7636a_get_status, |
| }; |
| |
| static const struct regulator_desc desc = { |
| .name = "vcom", |
| .id = 0, |
| .ops = &sy7636a_vcom_volt_ops, |
| .type = REGULATOR_VOLTAGE, |
| .owner = THIS_MODULE, |
| .enable_reg = SY7636A_REG_OPERATION_MODE_CRL, |
| .enable_mask = SY7636A_OPERATION_MODE_CRL_ONOFF, |
| .regulators_node = of_match_ptr("regulators"), |
| .of_match = of_match_ptr("vcom"), |
| }; |
| |
| static int sy7636a_regulator_probe(struct platform_device *pdev) |
| { |
| struct regmap *regmap = dev_get_regmap(pdev->dev.parent, NULL); |
| struct regulator_config config = { }; |
| struct regulator_dev *rdev; |
| struct gpio_desc *gdp; |
| struct sy7636a_data *data; |
| int ret; |
| |
| if (!regmap) |
| return -EPROBE_DEFER; |
| |
| gdp = devm_gpiod_get(pdev->dev.parent, "epd-pwr-good", GPIOD_IN); |
| if (IS_ERR(gdp)) { |
| dev_err(pdev->dev.parent, "Power good GPIO fault %ld\n", PTR_ERR(gdp)); |
| return PTR_ERR(gdp); |
| } |
| |
| data = devm_kzalloc(&pdev->dev, sizeof(struct sy7636a_data), GFP_KERNEL); |
| if (!data) |
| return -ENOMEM; |
| |
| data->regmap = regmap; |
| data->pgood_gpio = gdp; |
| |
| platform_set_drvdata(pdev, data); |
| |
| ret = regmap_write(regmap, SY7636A_REG_POWER_ON_DELAY_TIME, 0x0); |
| if (ret) { |
| dev_err(pdev->dev.parent, "Failed to initialize regulator: %d\n", ret); |
| return ret; |
| } |
| |
| config.dev = &pdev->dev; |
| config.dev->of_node = pdev->dev.parent->of_node; |
| config.regmap = regmap; |
| |
| rdev = devm_regulator_register(&pdev->dev, &desc, &config); |
| if (IS_ERR(rdev)) { |
| dev_err(pdev->dev.parent, "Failed to register %s regulator\n", |
| pdev->name); |
| return PTR_ERR(rdev); |
| } |
| |
| return 0; |
| } |
| |
| static const struct platform_device_id sy7636a_regulator_id_table[] = { |
| { "sy7636a-regulator", }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(platform, sy7636a_regulator_id_table); |
| |
| static struct platform_driver sy7636a_regulator_driver = { |
| .driver = { |
| .name = "sy7636a-regulator", |
| .probe_type = PROBE_PREFER_ASYNCHRONOUS, |
| }, |
| .probe = sy7636a_regulator_probe, |
| .id_table = sy7636a_regulator_id_table, |
| }; |
| module_platform_driver(sy7636a_regulator_driver); |
| |
| MODULE_AUTHOR("Lars Ivar Miljeteig <lars.ivar.miljeteig@remarkable.com>"); |
| MODULE_DESCRIPTION("SY7636A voltage regulator driver"); |
| MODULE_LICENSE("GPL v2"); |