| /* SPDX-License-Identifier: GPL-2.0 OR BSD-3-Clause */ |
| /* |
| * Copyright (C) 2012-2014, 2019-2021 Intel Corporation |
| * Copyright (C) 2013-2015 Intel Mobile Communications GmbH |
| * Copyright (C) 2016-2017 Intel Deutschland GmbH |
| */ |
| #ifndef __iwl_fw_api_phy_h__ |
| #define __iwl_fw_api_phy_h__ |
| |
| /** |
| * enum iwl_phy_ops_subcmd_ids - PHY group commands |
| */ |
| enum iwl_phy_ops_subcmd_ids { |
| /** |
| * @CMD_DTS_MEASUREMENT_TRIGGER_WIDE: |
| * Uses either &struct iwl_dts_measurement_cmd or |
| * &struct iwl_ext_dts_measurement_cmd |
| */ |
| CMD_DTS_MEASUREMENT_TRIGGER_WIDE = 0x0, |
| |
| /** |
| * @CTDP_CONFIG_CMD: &struct iwl_mvm_ctdp_cmd |
| */ |
| CTDP_CONFIG_CMD = 0x03, |
| |
| /** |
| * @TEMP_REPORTING_THRESHOLDS_CMD: &struct temp_report_ths_cmd |
| */ |
| TEMP_REPORTING_THRESHOLDS_CMD = 0x04, |
| |
| /** |
| * @PER_CHAIN_LIMIT_OFFSET_CMD: &struct iwl_geo_tx_power_profiles_cmd |
| */ |
| PER_CHAIN_LIMIT_OFFSET_CMD = 0x05, |
| |
| /** |
| * @PER_PLATFORM_ANT_GAIN_CMD: &struct iwl_ppag_table_cmd |
| */ |
| PER_PLATFORM_ANT_GAIN_CMD = 0x07, |
| |
| /** |
| * @CT_KILL_NOTIFICATION: &struct ct_kill_notif |
| */ |
| CT_KILL_NOTIFICATION = 0xFE, |
| |
| /** |
| * @DTS_MEASUREMENT_NOTIF_WIDE: |
| * &struct iwl_dts_measurement_notif_v1 or |
| * &struct iwl_dts_measurement_notif_v2 |
| */ |
| DTS_MEASUREMENT_NOTIF_WIDE = 0xFF, |
| }; |
| |
| /* DTS measurements */ |
| |
| enum iwl_dts_measurement_flags { |
| DTS_TRIGGER_CMD_FLAGS_TEMP = BIT(0), |
| DTS_TRIGGER_CMD_FLAGS_VOLT = BIT(1), |
| }; |
| |
| /** |
| * struct iwl_dts_measurement_cmd - request DTS temp and/or voltage measurements |
| * |
| * @flags: indicates which measurements we want as specified in |
| * &enum iwl_dts_measurement_flags |
| */ |
| struct iwl_dts_measurement_cmd { |
| __le32 flags; |
| } __packed; /* TEMPERATURE_MEASUREMENT_TRIGGER_CMD_S */ |
| |
| /** |
| * enum iwl_dts_control_measurement_mode - DTS measurement type |
| * @DTS_AUTOMATIC: Automatic mode (full SW control). Provide temperature read |
| * back (latest value. Not waiting for new value). Use automatic |
| * SW DTS configuration. |
| * @DTS_REQUEST_READ: Request DTS read. Configure DTS with manual settings, |
| * trigger DTS reading and provide read back temperature read |
| * when available. |
| * @DTS_OVER_WRITE: over-write the DTS temperatures in the SW until next read |
| * @DTS_DIRECT_WITHOUT_MEASURE: DTS returns its latest temperature result, |
| * without measurement trigger. |
| */ |
| enum iwl_dts_control_measurement_mode { |
| DTS_AUTOMATIC = 0, |
| DTS_REQUEST_READ = 1, |
| DTS_OVER_WRITE = 2, |
| DTS_DIRECT_WITHOUT_MEASURE = 3, |
| }; |
| |
| /** |
| * enum iwl_dts_used - DTS to use or used for measurement in the DTS request |
| * @DTS_USE_TOP: Top |
| * @DTS_USE_CHAIN_A: chain A |
| * @DTS_USE_CHAIN_B: chain B |
| * @DTS_USE_CHAIN_C: chain C |
| * @XTAL_TEMPERATURE: read temperature from xtal |
| */ |
| enum iwl_dts_used { |
| DTS_USE_TOP = 0, |
| DTS_USE_CHAIN_A = 1, |
| DTS_USE_CHAIN_B = 2, |
| DTS_USE_CHAIN_C = 3, |
| XTAL_TEMPERATURE = 4, |
| }; |
| |
| /** |
| * enum iwl_dts_bit_mode - bit-mode to use in DTS request read mode |
| * @DTS_BIT6_MODE: bit 6 mode |
| * @DTS_BIT8_MODE: bit 8 mode |
| */ |
| enum iwl_dts_bit_mode { |
| DTS_BIT6_MODE = 0, |
| DTS_BIT8_MODE = 1, |
| }; |
| |
| /** |
| * struct iwl_ext_dts_measurement_cmd - request extended DTS temp measurements |
| * @control_mode: see &enum iwl_dts_control_measurement_mode |
| * @temperature: used when over write DTS mode is selected |
| * @sensor: set temperature sensor to use. See &enum iwl_dts_used |
| * @avg_factor: average factor to DTS in request DTS read mode |
| * @bit_mode: value defines the DTS bit mode to use. See &enum iwl_dts_bit_mode |
| * @step_duration: step duration for the DTS |
| */ |
| struct iwl_ext_dts_measurement_cmd { |
| __le32 control_mode; |
| __le32 temperature; |
| __le32 sensor; |
| __le32 avg_factor; |
| __le32 bit_mode; |
| __le32 step_duration; |
| } __packed; /* XVT_FW_DTS_CONTROL_MEASUREMENT_REQUEST_API_S */ |
| |
| /** |
| * struct iwl_dts_measurement_notif_v1 - measurements notification |
| * |
| * @temp: the measured temperature |
| * @voltage: the measured voltage |
| */ |
| struct iwl_dts_measurement_notif_v1 { |
| __le32 temp; |
| __le32 voltage; |
| } __packed; /* TEMPERATURE_MEASUREMENT_TRIGGER_NTFY_S_VER_1*/ |
| |
| /** |
| * struct iwl_dts_measurement_notif_v2 - measurements notification |
| * |
| * @temp: the measured temperature |
| * @voltage: the measured voltage |
| * @threshold_idx: the trip index that was crossed |
| */ |
| struct iwl_dts_measurement_notif_v2 { |
| __le32 temp; |
| __le32 voltage; |
| __le32 threshold_idx; |
| } __packed; /* TEMPERATURE_MEASUREMENT_TRIGGER_NTFY_S_VER_2 */ |
| |
| /** |
| * struct iwl_dts_measurement_resp - measurements response |
| * |
| * @temp: the measured temperature |
| */ |
| struct iwl_dts_measurement_resp { |
| __le32 temp; |
| } __packed; /* CMD_DTS_MEASUREMENT_RSP_API_S_VER_1 */ |
| |
| /** |
| * struct ct_kill_notif - CT-kill entry notification |
| * |
| * @temperature: the current temperature in celsius |
| * @reserved: reserved |
| */ |
| struct ct_kill_notif { |
| __le16 temperature; |
| __le16 reserved; |
| } __packed; /* GRP_PHY_CT_KILL_NTF */ |
| |
| /** |
| * enum ctdp_cmd_operation - CTDP command operations |
| * @CTDP_CMD_OPERATION_START: update the current budget |
| * @CTDP_CMD_OPERATION_STOP: stop ctdp |
| * @CTDP_CMD_OPERATION_REPORT: get the average budget |
| */ |
| enum iwl_mvm_ctdp_cmd_operation { |
| CTDP_CMD_OPERATION_START = 0x1, |
| CTDP_CMD_OPERATION_STOP = 0x2, |
| CTDP_CMD_OPERATION_REPORT = 0x4, |
| };/* CTDP_CMD_OPERATION_TYPE_E */ |
| |
| /** |
| * struct iwl_mvm_ctdp_cmd - track and manage the FW power consumption budget |
| * |
| * @operation: see &enum iwl_mvm_ctdp_cmd_operation |
| * @budget: the budget in milliwatt |
| * @window_size: defined in API but not used |
| */ |
| struct iwl_mvm_ctdp_cmd { |
| __le32 operation; |
| __le32 budget; |
| __le32 window_size; |
| } __packed; |
| |
| #define IWL_MAX_DTS_TRIPS 8 |
| |
| /** |
| * struct temp_report_ths_cmd - set temperature thresholds |
| * |
| * @num_temps: number of temperature thresholds passed |
| * @thresholds: array with the thresholds to be configured |
| */ |
| struct temp_report_ths_cmd { |
| __le32 num_temps; |
| __le16 thresholds[IWL_MAX_DTS_TRIPS]; |
| } __packed; /* GRP_PHY_TEMP_REPORTING_THRESHOLDS_CMD */ |
| |
| #endif /* __iwl_fw_api_phy_h__ */ |