| // SPDX-License-Identifier: GPL-2.0-only |
| #include <linux/types.h> |
| #include <linux/init.h> |
| #include <linux/interrupt.h> |
| #include <linux/mm.h> |
| #include <linux/slab.h> |
| #include <linux/spinlock.h> |
| #include <linux/zorro.h> |
| #include <linux/module.h> |
| |
| #include <asm/page.h> |
| #include <asm/amigaints.h> |
| #include <asm/amigahw.h> |
| |
| #include <scsi/scsi.h> |
| #include <scsi/scsi_cmnd.h> |
| #include <scsi/scsi_device.h> |
| #include <scsi/scsi_eh.h> |
| #include <scsi/scsi_tcq.h> |
| #include "wd33c93.h" |
| #include "a2091.h" |
| |
| |
| struct a2091_hostdata { |
| struct WD33C93_hostdata wh; |
| struct a2091_scsiregs *regs; |
| struct device *dev; |
| }; |
| |
| #define DMA_DIR(d) ((d == DATA_OUT_DIR) ? DMA_TO_DEVICE : DMA_FROM_DEVICE) |
| |
| static irqreturn_t a2091_intr(int irq, void *data) |
| { |
| struct Scsi_Host *instance = data; |
| struct a2091_hostdata *hdata = shost_priv(instance); |
| unsigned int status = hdata->regs->ISTR; |
| unsigned long flags; |
| |
| if (!(status & (ISTR_INT_F | ISTR_INT_P)) || !(status & ISTR_INTS)) |
| return IRQ_NONE; |
| |
| spin_lock_irqsave(instance->host_lock, flags); |
| wd33c93_intr(instance); |
| spin_unlock_irqrestore(instance->host_lock, flags); |
| return IRQ_HANDLED; |
| } |
| |
| static int dma_setup(struct scsi_cmnd *cmd, int dir_in) |
| { |
| struct scsi_pointer *scsi_pointer = WD33C93_scsi_pointer(cmd); |
| unsigned long len = scsi_pointer->this_residual; |
| struct Scsi_Host *instance = cmd->device->host; |
| struct a2091_hostdata *hdata = shost_priv(instance); |
| struct WD33C93_hostdata *wh = &hdata->wh; |
| struct a2091_scsiregs *regs = hdata->regs; |
| unsigned short cntr = CNTR_PDMD | CNTR_INTEN; |
| dma_addr_t addr; |
| |
| addr = dma_map_single(hdata->dev, scsi_pointer->ptr, |
| len, DMA_DIR(dir_in)); |
| if (dma_mapping_error(hdata->dev, addr)) { |
| dev_warn(hdata->dev, "cannot map SCSI data block %p\n", |
| scsi_pointer->ptr); |
| return 1; |
| } |
| scsi_pointer->dma_handle = addr; |
| |
| /* don't allow DMA if the physical address is bad */ |
| if (addr & A2091_XFER_MASK) { |
| /* drop useless mapping */ |
| dma_unmap_single(hdata->dev, scsi_pointer->dma_handle, |
| scsi_pointer->this_residual, |
| DMA_DIR(dir_in)); |
| scsi_pointer->dma_handle = (dma_addr_t) NULL; |
| |
| wh->dma_bounce_len = (scsi_pointer->this_residual + 511) & ~0x1ff; |
| wh->dma_bounce_buffer = kmalloc(wh->dma_bounce_len, |
| GFP_KERNEL); |
| |
| /* can't allocate memory; use PIO */ |
| if (!wh->dma_bounce_buffer) { |
| wh->dma_bounce_len = 0; |
| return 1; |
| } |
| |
| if (!dir_in) { |
| /* copy to bounce buffer for a write */ |
| memcpy(wh->dma_bounce_buffer, scsi_pointer->ptr, |
| scsi_pointer->this_residual); |
| } |
| |
| /* will flush/invalidate cache for us */ |
| addr = dma_map_single(hdata->dev, wh->dma_bounce_buffer, |
| wh->dma_bounce_len, DMA_DIR(dir_in)); |
| /* can't map buffer; use PIO */ |
| if (dma_mapping_error(hdata->dev, addr)) { |
| dev_warn(hdata->dev, "cannot map bounce buffer %p\n", |
| wh->dma_bounce_buffer); |
| return 1; |
| } |
| |
| /* the bounce buffer may not be in the first 16M of physmem */ |
| if (addr & A2091_XFER_MASK) { |
| /* we could use chipmem... maybe later */ |
| kfree(wh->dma_bounce_buffer); |
| wh->dma_bounce_buffer = NULL; |
| wh->dma_bounce_len = 0; |
| return 1; |
| } |
| |
| scsi_pointer->dma_handle = addr; |
| } |
| |
| /* setup dma direction */ |
| if (!dir_in) |
| cntr |= CNTR_DDIR; |
| |
| /* remember direction */ |
| wh->dma_dir = dir_in; |
| |
| regs->CNTR = cntr; |
| |
| /* setup DMA *physical* address */ |
| regs->ACR = addr; |
| |
| /* no more cache flush here - dma_map_single() takes care */ |
| |
| /* start DMA */ |
| regs->ST_DMA = 1; |
| |
| /* return success */ |
| return 0; |
| } |
| |
| static void dma_stop(struct Scsi_Host *instance, struct scsi_cmnd *SCpnt, |
| int status) |
| { |
| struct scsi_pointer *scsi_pointer = WD33C93_scsi_pointer(SCpnt); |
| struct a2091_hostdata *hdata = shost_priv(instance); |
| struct WD33C93_hostdata *wh = &hdata->wh; |
| struct a2091_scsiregs *regs = hdata->regs; |
| |
| /* disable SCSI interrupts */ |
| unsigned short cntr = CNTR_PDMD; |
| |
| if (!wh->dma_dir) |
| cntr |= CNTR_DDIR; |
| |
| /* disable SCSI interrupts */ |
| regs->CNTR = cntr; |
| |
| /* flush if we were reading */ |
| if (wh->dma_dir) { |
| regs->FLUSH = 1; |
| while (!(regs->ISTR & ISTR_FE_FLG)) |
| ; |
| } |
| |
| /* clear a possible interrupt */ |
| regs->CINT = 1; |
| |
| /* stop DMA */ |
| regs->SP_DMA = 1; |
| |
| /* restore the CONTROL bits (minus the direction flag) */ |
| regs->CNTR = CNTR_PDMD | CNTR_INTEN; |
| |
| dma_unmap_single(hdata->dev, scsi_pointer->dma_handle, |
| scsi_pointer->this_residual, |
| DMA_DIR(wh->dma_dir)); |
| |
| /* copy from a bounce buffer, if necessary */ |
| if (status && wh->dma_bounce_buffer) { |
| if (wh->dma_dir) |
| memcpy(scsi_pointer->ptr, wh->dma_bounce_buffer, |
| scsi_pointer->this_residual); |
| kfree(wh->dma_bounce_buffer); |
| wh->dma_bounce_buffer = NULL; |
| wh->dma_bounce_len = 0; |
| } |
| } |
| |
| static const struct scsi_host_template a2091_scsi_template = { |
| .module = THIS_MODULE, |
| .name = "Commodore A2091/A590 SCSI", |
| .show_info = wd33c93_show_info, |
| .write_info = wd33c93_write_info, |
| .proc_name = "A2901", |
| .queuecommand = wd33c93_queuecommand, |
| .eh_abort_handler = wd33c93_abort, |
| .eh_host_reset_handler = wd33c93_host_reset, |
| .can_queue = CAN_QUEUE, |
| .this_id = 7, |
| .sg_tablesize = SG_ALL, |
| .cmd_per_lun = CMD_PER_LUN, |
| .dma_boundary = PAGE_SIZE - 1, |
| .cmd_size = sizeof(struct scsi_pointer), |
| }; |
| |
| static int a2091_probe(struct zorro_dev *z, const struct zorro_device_id *ent) |
| { |
| struct Scsi_Host *instance; |
| int error; |
| struct a2091_scsiregs *regs; |
| wd33c93_regs wdregs; |
| struct a2091_hostdata *hdata; |
| |
| if (dma_set_mask_and_coherent(&z->dev, DMA_BIT_MASK(24))) { |
| dev_warn(&z->dev, "cannot use 24 bit DMA\n"); |
| return -ENODEV; |
| } |
| |
| if (!request_mem_region(z->resource.start, 256, "wd33c93")) |
| return -EBUSY; |
| |
| instance = scsi_host_alloc(&a2091_scsi_template, |
| sizeof(struct a2091_hostdata)); |
| if (!instance) { |
| error = -ENOMEM; |
| goto fail_alloc; |
| } |
| |
| instance->irq = IRQ_AMIGA_PORTS; |
| instance->unique_id = z->slotaddr; |
| |
| regs = ZTWO_VADDR(z->resource.start); |
| regs->DAWR = DAWR_A2091; |
| |
| wdregs.SASR = ®s->SASR; |
| wdregs.SCMD = ®s->SCMD; |
| |
| hdata = shost_priv(instance); |
| hdata->dev = &z->dev; |
| hdata->wh.no_sync = 0xff; |
| hdata->wh.fast = 0; |
| hdata->wh.dma_mode = CTRL_DMA; |
| hdata->regs = regs; |
| |
| wd33c93_init(instance, wdregs, dma_setup, dma_stop, WD33C93_FS_8_10); |
| error = request_irq(IRQ_AMIGA_PORTS, a2091_intr, IRQF_SHARED, |
| "A2091 SCSI", instance); |
| if (error) |
| goto fail_irq; |
| |
| regs->CNTR = CNTR_PDMD | CNTR_INTEN; |
| |
| error = scsi_add_host(instance, NULL); |
| if (error) |
| goto fail_host; |
| |
| zorro_set_drvdata(z, instance); |
| |
| scsi_scan_host(instance); |
| return 0; |
| |
| fail_host: |
| free_irq(IRQ_AMIGA_PORTS, instance); |
| fail_irq: |
| scsi_host_put(instance); |
| fail_alloc: |
| release_mem_region(z->resource.start, 256); |
| return error; |
| } |
| |
| static void a2091_remove(struct zorro_dev *z) |
| { |
| struct Scsi_Host *instance = zorro_get_drvdata(z); |
| struct a2091_hostdata *hdata = shost_priv(instance); |
| |
| hdata->regs->CNTR = 0; |
| scsi_remove_host(instance); |
| free_irq(IRQ_AMIGA_PORTS, instance); |
| scsi_host_put(instance); |
| release_mem_region(z->resource.start, 256); |
| } |
| |
| static struct zorro_device_id a2091_zorro_tbl[] = { |
| { ZORRO_PROD_CBM_A590_A2091_1 }, |
| { ZORRO_PROD_CBM_A590_A2091_2 }, |
| { 0 } |
| }; |
| MODULE_DEVICE_TABLE(zorro, a2091_zorro_tbl); |
| |
| static struct zorro_driver a2091_driver = { |
| .name = "a2091", |
| .id_table = a2091_zorro_tbl, |
| .probe = a2091_probe, |
| .remove = a2091_remove, |
| }; |
| |
| static int __init a2091_init(void) |
| { |
| return zorro_register_driver(&a2091_driver); |
| } |
| module_init(a2091_init); |
| |
| static void __exit a2091_exit(void) |
| { |
| zorro_unregister_driver(&a2091_driver); |
| } |
| module_exit(a2091_exit); |
| |
| MODULE_DESCRIPTION("Commodore A2091/A590 SCSI"); |
| MODULE_LICENSE("GPL"); |