blob: e8cfbf4ff1b53da7ab73cc8d16718ff3a37b0ae9 [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0-or-later
/* atlx.c -- common functions for Attansic network drivers
*
* Copyright(c) 2005 - 2006 Attansic Corporation. All rights reserved.
* Copyright(c) 2006 - 2007 Chris Snook <csnook@redhat.com>
* Copyright(c) 2006 - 2008 Jay Cliburn <jcliburn@gmail.com>
* Copyright(c) 2007 Atheros Corporation. All rights reserved.
*
* Derived from Intel e1000 driver
* Copyright(c) 1999 - 2005 Intel Corporation. All rights reserved.
*/
/* Including this file like a header is a temporary hack, I promise. -- CHS */
#ifndef ATLX_C
#define ATLX_C
#include <linux/device.h>
#include <linux/errno.h>
#include <linux/etherdevice.h>
#include <linux/if.h>
#include <linux/netdevice.h>
#include <linux/socket.h>
#include <linux/sockios.h>
#include <linux/spinlock.h>
#include <linux/string.h>
#include <linux/types.h>
#include <linux/workqueue.h>
#include "atlx.h"
static s32 atlx_read_phy_reg(struct atl1_hw *hw, u16 reg_addr, u16 *phy_data);
static u32 atlx_hash_mc_addr(struct atl1_hw *hw, u8 *mc_addr);
static void atlx_set_mac_addr(struct atl1_hw *hw);
static struct atlx_spi_flash_dev flash_table[] = {
/* MFR_NAME WRSR READ PRGM WREN WRDI RDSR RDID SEC_ERS CHIP_ERS */
{"Atmel", 0x00, 0x03, 0x02, 0x06, 0x04, 0x05, 0x15, 0x52, 0x62},
{"SST", 0x01, 0x03, 0x02, 0x06, 0x04, 0x05, 0x90, 0x20, 0x60},
{"ST", 0x01, 0x03, 0x02, 0x06, 0x04, 0x05, 0xAB, 0xD8, 0xC7},
};
static int atlx_ioctl(struct net_device *netdev, struct ifreq *ifr, int cmd)
{
switch (cmd) {
case SIOCGMIIPHY:
case SIOCGMIIREG:
case SIOCSMIIREG:
return atlx_mii_ioctl(netdev, ifr, cmd);
default:
return -EOPNOTSUPP;
}
}
/**
* atlx_set_mac - Change the Ethernet Address of the NIC
* @netdev: network interface device structure
* @p: pointer to an address structure
*
* Returns 0 on success, negative on failure
*/
static int atlx_set_mac(struct net_device *netdev, void *p)
{
struct atlx_adapter *adapter = netdev_priv(netdev);
struct sockaddr *addr = p;
if (netif_running(netdev))
return -EBUSY;
if (!is_valid_ether_addr(addr->sa_data))
return -EADDRNOTAVAIL;
eth_hw_addr_set(netdev, addr->sa_data);
memcpy(adapter->hw.mac_addr, addr->sa_data, netdev->addr_len);
atlx_set_mac_addr(&adapter->hw);
return 0;
}
static void atlx_check_for_link(struct atlx_adapter *adapter)
{
struct net_device *netdev = adapter->netdev;
u16 phy_data = 0;
spin_lock(&adapter->lock);
adapter->phy_timer_pending = false;
atlx_read_phy_reg(&adapter->hw, MII_BMSR, &phy_data);
atlx_read_phy_reg(&adapter->hw, MII_BMSR, &phy_data);
spin_unlock(&adapter->lock);
/* notify upper layer link down ASAP */
if (!(phy_data & BMSR_LSTATUS)) {
/* Link Down */
if (netif_carrier_ok(netdev)) {
/* old link state: Up */
dev_info(&adapter->pdev->dev, "%s link is down\n",
netdev->name);
adapter->link_speed = SPEED_0;
netif_carrier_off(netdev);
}
}
schedule_work(&adapter->link_chg_task);
}
/**
* atlx_set_multi - Multicast and Promiscuous mode set
* @netdev: network interface device structure
*
* The set_multi entry point is called whenever the multicast address
* list or the network interface flags are updated. This routine is
* responsible for configuring the hardware for proper multicast,
* promiscuous mode, and all-multi behavior.
*/
static void atlx_set_multi(struct net_device *netdev)
{
struct atlx_adapter *adapter = netdev_priv(netdev);
struct atlx_hw *hw = &adapter->hw;
struct netdev_hw_addr *ha;
u32 rctl;
u32 hash_value;
/* Check for Promiscuous and All Multicast modes */
rctl = ioread32(hw->hw_addr + REG_MAC_CTRL);
if (netdev->flags & IFF_PROMISC)
rctl |= MAC_CTRL_PROMIS_EN;
else if (netdev->flags & IFF_ALLMULTI) {
rctl |= MAC_CTRL_MC_ALL_EN;
rctl &= ~MAC_CTRL_PROMIS_EN;
} else
rctl &= ~(MAC_CTRL_PROMIS_EN | MAC_CTRL_MC_ALL_EN);
iowrite32(rctl, hw->hw_addr + REG_MAC_CTRL);
/* clear the old settings from the multicast hash table */
iowrite32(0, hw->hw_addr + REG_RX_HASH_TABLE);
iowrite32(0, (hw->hw_addr + REG_RX_HASH_TABLE) + (1 << 2));
/* compute mc addresses' hash value ,and put it into hash table */
netdev_for_each_mc_addr(ha, netdev) {
hash_value = atlx_hash_mc_addr(hw, ha->addr);
atlx_hash_set(hw, hash_value);
}
}
static inline void atlx_imr_set(struct atlx_adapter *adapter,
unsigned int imr)
{
iowrite32(imr, adapter->hw.hw_addr + REG_IMR);
ioread32(adapter->hw.hw_addr + REG_IMR);
}
/**
* atlx_irq_enable - Enable default interrupt generation settings
* @adapter: board private structure
*/
static void atlx_irq_enable(struct atlx_adapter *adapter)
{
atlx_imr_set(adapter, IMR_NORMAL_MASK);
adapter->int_enabled = true;
}
/**
* atlx_irq_disable - Mask off interrupt generation on the NIC
* @adapter: board private structure
*/
static void atlx_irq_disable(struct atlx_adapter *adapter)
{
adapter->int_enabled = false;
atlx_imr_set(adapter, 0);
synchronize_irq(adapter->pdev->irq);
}
static void atlx_clear_phy_int(struct atlx_adapter *adapter)
{
u16 phy_data;
unsigned long flags;
spin_lock_irqsave(&adapter->lock, flags);
atlx_read_phy_reg(&adapter->hw, 19, &phy_data);
spin_unlock_irqrestore(&adapter->lock, flags);
}
/**
* atlx_tx_timeout - Respond to a Tx Hang
* @netdev: network interface device structure
*/
static void atlx_tx_timeout(struct net_device *netdev, unsigned int txqueue)
{
struct atlx_adapter *adapter = netdev_priv(netdev);
/* Do the reset outside of interrupt context */
schedule_work(&adapter->reset_dev_task);
}
/*
* atlx_link_chg_task - deal with link change event Out of interrupt context
*/
static void atlx_link_chg_task(struct work_struct *work)
{
struct atlx_adapter *adapter;
unsigned long flags;
adapter = container_of(work, struct atlx_adapter, link_chg_task);
spin_lock_irqsave(&adapter->lock, flags);
atlx_check_link(adapter);
spin_unlock_irqrestore(&adapter->lock, flags);
}
static void __atlx_vlan_mode(netdev_features_t features, u32 *ctrl)
{
if (features & NETIF_F_HW_VLAN_CTAG_RX) {
/* enable VLAN tag insert/strip */
*ctrl |= MAC_CTRL_RMV_VLAN;
} else {
/* disable VLAN tag insert/strip */
*ctrl &= ~MAC_CTRL_RMV_VLAN;
}
}
static void atlx_vlan_mode(struct net_device *netdev,
netdev_features_t features)
{
struct atlx_adapter *adapter = netdev_priv(netdev);
unsigned long flags;
u32 ctrl;
spin_lock_irqsave(&adapter->lock, flags);
/* atlx_irq_disable(adapter); FIXME: confirm/remove */
ctrl = ioread32(adapter->hw.hw_addr + REG_MAC_CTRL);
__atlx_vlan_mode(features, &ctrl);
iowrite32(ctrl, adapter->hw.hw_addr + REG_MAC_CTRL);
/* atlx_irq_enable(adapter); FIXME */
spin_unlock_irqrestore(&adapter->lock, flags);
}
static void atlx_restore_vlan(struct atlx_adapter *adapter)
{
atlx_vlan_mode(adapter->netdev, adapter->netdev->features);
}
static netdev_features_t atlx_fix_features(struct net_device *netdev,
netdev_features_t features)
{
/*
* Since there is no support for separate rx/tx vlan accel
* enable/disable make sure tx flag is always in same state as rx.
*/
if (features & NETIF_F_HW_VLAN_CTAG_RX)
features |= NETIF_F_HW_VLAN_CTAG_TX;
else
features &= ~NETIF_F_HW_VLAN_CTAG_TX;
return features;
}
static int atlx_set_features(struct net_device *netdev,
netdev_features_t features)
{
netdev_features_t changed = netdev->features ^ features;
if (changed & NETIF_F_HW_VLAN_CTAG_RX)
atlx_vlan_mode(netdev, features);
return 0;
}
#endif /* ATLX_C */