arch/arm/boot/dts/am335x-netcan-plus-1xx.dts

// SPDX-License-Identifier: GPL-2.0-only
/*
 * Copyright (C) 2012 Texas Instruments Incorporated - http://www.ti.com/
 */

/*
 * VScom OnRISC
 * http://www.vscom.de
 */

/dts-v1/;

#include "am335x-baltos.dtsi"
#include "am335x-baltos-leds.dtsi"

/ {
	model = "NetCAN";

	leds {
		pinctrl-names = "default";
		pinctrl-0 = <&user_leds_s0>;

		compatible = "gpio-leds";

		led@1 {
			label = "can_data";
			linux,default-trigger = "netdev";
			gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
			default-state = "off";
		};
		led@2 {
			label = "can_error";
			gpios = <&gpio0 15 GPIO_ACTIVE_LOW>;
			default-state = "off";
		};
	};
};

&am33xx_pinmux {
	user_leds_s0: user_leds_s0 {
		pinctrl-single,pins = <
			AM33XX_PADCONF(AM335X_PIN_UART1_RXD, PIN_OUTPUT_PULLDOWN, MUX_MODE7)	/* CAN Data LED */
			AM33XX_PADCONF(AM335X_PIN_UART1_TXD, PIN_OUTPUT_PULLDOWN, MUX_MODE7)	/* CAN Error LED */
		>;
	};

	dcan1_pins: pinmux_dcan1_pins {
		pinctrl-single,pins = <
			AM33XX_PADCONF(AM335X_PIN_UART0_CTSN, PIN_OUTPUT, MUX_MODE2)	/* CAN TX */
			AM33XX_PADCONF(AM335X_PIN_UART0_RTSN, PIN_INPUT, MUX_MODE2)	/* CAN RX */
		>;
	};
};

&usb0_phy {
	status = "okay";
};

&usb0 {
	status = "okay";
	dr_mode = "host";
};

&davinci_mdio {
	phy0: ethernet-phy@0 {
		reg = <1>;
	};
};

&cpsw_emac0 {
	phy-mode = "rmii";
	dual_emac_res_vlan = <1>;
	phy-handle = <&phy0>;
};

&cpsw_emac1 {
	phy-mode = "rgmii-id";
	dual_emac_res_vlan = <2>;
	phy-handle = <&phy1>;
};

&dcan1 {
	pinctrl-names = "default";
	pinctrl-0 = <&dcan1_pins>;

	status = "okay";
};