blob: b0a262566eb95abdde4a5606f2e364156c00869a [file] [log] [blame]
/* SPDX-License-Identifier: GPL-2.0-only */
/*
* arch/arm/include/asm/pgtable-2level.h
*
* Copyright (C) 1995-2002 Russell King
*/
#ifndef _ASM_PGTABLE_2LEVEL_H
#define _ASM_PGTABLE_2LEVEL_H
#define __PAGETABLE_PMD_FOLDED 1
/*
* Hardware-wise, we have a two level page table structure, where the first
* level has 4096 entries, and the second level has 256 entries. Each entry
* is one 32-bit word. Most of the bits in the second level entry are used
* by hardware, and there aren't any "accessed" and "dirty" bits.
*
* Linux on the other hand has a three level page table structure, which can
* be wrapped to fit a two level page table structure easily - using the PGD
* and PTE only. However, Linux also expects one "PTE" table per page, and
* at least a "dirty" bit.
*
* Therefore, we tweak the implementation slightly - we tell Linux that we
* have 2048 entries in the first level, each of which is 8 bytes (iow, two
* hardware pointers to the second level.) The second level contains two
* hardware PTE tables arranged contiguously, preceded by Linux versions
* which contain the state information Linux needs. We, therefore, end up
* with 512 entries in the "PTE" level.
*
* This leads to the page tables having the following layout:
*
* pgd pte
* | |
* +--------+
* | | +------------+ +0
* +- - - - + | Linux pt 0 |
* | | +------------+ +1024
* +--------+ +0 | Linux pt 1 |
* | |-----> +------------+ +2048
* +- - - - + +4 | h/w pt 0 |
* | |-----> +------------+ +3072
* +--------+ +8 | h/w pt 1 |
* | | +------------+ +4096
*
* See L_PTE_xxx below for definitions of bits in the "Linux pt", and
* PTE_xxx for definitions of bits appearing in the "h/w pt".
*
* PMD_xxx definitions refer to bits in the first level page table.
*
* The "dirty" bit is emulated by only granting hardware write permission
* iff the page is marked "writable" and "dirty" in the Linux PTE. This
* means that a write to a clean page will cause a permission fault, and
* the Linux MM layer will mark the page dirty via handle_pte_fault().
* For the hardware to notice the permission change, the TLB entry must
* be flushed, and ptep_set_access_flags() does that for us.
*
* The "accessed" or "young" bit is emulated by a similar method; we only
* allow accesses to the page if the "young" bit is set. Accesses to the
* page will cause a fault, and handle_pte_fault() will set the young bit
* for us as long as the page is marked present in the corresponding Linux
* PTE entry. Again, ptep_set_access_flags() will ensure that the TLB is
* up to date.
*
* However, when the "young" bit is cleared, we deny access to the page
* by clearing the hardware PTE. Currently Linux does not flush the TLB
* for us in this case, which means the TLB will retain the transation
* until either the TLB entry is evicted under pressure, or a context
* switch which changes the user space mapping occurs.
*/
#define PTRS_PER_PTE 512
#define PTRS_PER_PMD 1
#define PTRS_PER_PGD 2048
#define PTE_HWTABLE_PTRS (PTRS_PER_PTE)
#define PTE_HWTABLE_OFF (PTE_HWTABLE_PTRS * sizeof(pte_t))
#define PTE_HWTABLE_SIZE (PTRS_PER_PTE * sizeof(u32))
#define MAX_POSSIBLE_PHYSMEM_BITS 32
/*
* PMD_SHIFT determines the size of the area a second-level page table can map
* PGDIR_SHIFT determines what a third-level page table entry can map
*/
#define PMD_SHIFT 21
#define PGDIR_SHIFT 21
#define PMD_SIZE (1UL << PMD_SHIFT)
#define PMD_MASK (~(PMD_SIZE-1))
#define PGDIR_SIZE (1UL << PGDIR_SHIFT)
#define PGDIR_MASK (~(PGDIR_SIZE-1))
/*
* section address mask and size definitions.
*/
#define SECTION_SHIFT 20
#define SECTION_SIZE (1UL << SECTION_SHIFT)
#define SECTION_MASK (~(SECTION_SIZE-1))
/*
* ARMv6 supersection address mask and size definitions.
*/
#define SUPERSECTION_SHIFT 24
#define SUPERSECTION_SIZE (1UL << SUPERSECTION_SHIFT)
#define SUPERSECTION_MASK (~(SUPERSECTION_SIZE-1))
#define USER_PTRS_PER_PGD (TASK_SIZE / PGDIR_SIZE)
/*
* "Linux" PTE definitions.
*
* We keep two sets of PTEs - the hardware and the linux version.
* This allows greater flexibility in the way we map the Linux bits
* onto the hardware tables, and allows us to have YOUNG and DIRTY
* bits.
*
* The PTE table pointer refers to the hardware entries; the "Linux"
* entries are stored 1024 bytes below.
*/
#define L_PTE_VALID (_AT(pteval_t, 1) << 0) /* Valid */
#define L_PTE_PRESENT (_AT(pteval_t, 1) << 0)
#define L_PTE_YOUNG (_AT(pteval_t, 1) << 1)
#define L_PTE_DIRTY (_AT(pteval_t, 1) << 6)
#define L_PTE_RDONLY (_AT(pteval_t, 1) << 7)
#define L_PTE_USER (_AT(pteval_t, 1) << 8)
#define L_PTE_XN (_AT(pteval_t, 1) << 9)
#define L_PTE_SHARED (_AT(pteval_t, 1) << 10) /* shared(v6), coherent(xsc3) */
#define L_PTE_NONE (_AT(pteval_t, 1) << 11)
/* We borrow bit 7 to store the exclusive marker in swap PTEs. */
#define L_PTE_SWP_EXCLUSIVE L_PTE_RDONLY
/*
* These are the memory types, defined to be compatible with
* pre-ARMv6 CPUs cacheable and bufferable bits: n/a,n/a,C,B
* ARMv6+ without TEX remapping, they are a table index.
* ARMv6+ with TEX remapping, they correspond to n/a,TEX(0),C,B
*
* MT type Pre-ARMv6 ARMv6+ type / cacheable status
* UNCACHED Uncached Strongly ordered
* BUFFERABLE Bufferable Normal memory / non-cacheable
* WRITETHROUGH Writethrough Normal memory / write through
* WRITEBACK Writeback Normal memory / write back, read alloc
* MINICACHE Minicache N/A
* WRITEALLOC Writeback Normal memory / write back, write alloc
* DEV_SHARED Uncached Device memory (shared)
* DEV_NONSHARED Uncached Device memory (non-shared)
* DEV_WC Bufferable Normal memory / non-cacheable
* DEV_CACHED Writeback Normal memory / write back, read alloc
* VECTORS Variable Normal memory / variable
*
* All normal memory mappings have the following properties:
* - reads can be repeated with no side effects
* - repeated reads return the last value written
* - reads can fetch additional locations without side effects
* - writes can be repeated (in certain cases) with no side effects
* - writes can be merged before accessing the target
* - unaligned accesses can be supported
*
* All device mappings have the following properties:
* - no access speculation
* - no repetition (eg, on return from an exception)
* - number, order and size of accesses are maintained
* - unaligned accesses are "unpredictable"
*/
#define L_PTE_MT_UNCACHED (_AT(pteval_t, 0x00) << 2) /* 0000 */
#define L_PTE_MT_BUFFERABLE (_AT(pteval_t, 0x01) << 2) /* 0001 */
#define L_PTE_MT_WRITETHROUGH (_AT(pteval_t, 0x02) << 2) /* 0010 */
#define L_PTE_MT_WRITEBACK (_AT(pteval_t, 0x03) << 2) /* 0011 */
#define L_PTE_MT_MINICACHE (_AT(pteval_t, 0x06) << 2) /* 0110 (sa1100, xscale) */
#define L_PTE_MT_WRITEALLOC (_AT(pteval_t, 0x07) << 2) /* 0111 */
#define L_PTE_MT_DEV_SHARED (_AT(pteval_t, 0x04) << 2) /* 0100 */
#define L_PTE_MT_DEV_NONSHARED (_AT(pteval_t, 0x0c) << 2) /* 1100 */
#define L_PTE_MT_DEV_WC (_AT(pteval_t, 0x09) << 2) /* 1001 */
#define L_PTE_MT_DEV_CACHED (_AT(pteval_t, 0x0b) << 2) /* 1011 */
#define L_PTE_MT_VECTORS (_AT(pteval_t, 0x0f) << 2) /* 1111 */
#define L_PTE_MT_MASK (_AT(pteval_t, 0x0f) << 2)
#ifndef __ASSEMBLY__
/*
* The "pud_xxx()" functions here are trivial when the pmd is folded into
* the pud: the pud entry is never bad, always exists, and can't be set or
* cleared.
*/
static inline int pud_none(pud_t pud)
{
return 0;
}
static inline int pud_bad(pud_t pud)
{
return 0;
}
static inline int pud_present(pud_t pud)
{
return 1;
}
static inline void pud_clear(pud_t *pudp)
{
}
static inline void set_pud(pud_t *pudp, pud_t pud)
{
}
static inline pmd_t *pmd_offset(pud_t *pud, unsigned long addr)
{
return (pmd_t *)pud;
}
#define pmd_offset pmd_offset
#define pmd_pfn(pmd) (__phys_to_pfn(pmd_val(pmd) & PHYS_MASK))
#define pmd_leaf(pmd) (pmd_val(pmd) & 2)
#define pmd_bad(pmd) (pmd_val(pmd) & 2)
#define pmd_present(pmd) (pmd_val(pmd))
#define copy_pmd(pmdpd,pmdps) \
do { \
pmdpd[0] = pmdps[0]; \
pmdpd[1] = pmdps[1]; \
flush_pmd_entry(pmdpd); \
} while (0)
#define pmd_clear(pmdp) \
do { \
pmdp[0] = __pmd(0); \
pmdp[1] = __pmd(0); \
clean_pmd_entry(pmdp); \
} while (0)
/* we don't need complex calculations here as the pmd is folded into the pgd */
#define pmd_addr_end(addr,end) (end)
#define set_pte_ext(ptep,pte,ext) cpu_set_pte_ext(ptep,pte,ext)
/*
* We don't have huge page support for short descriptors, for the moment
* define empty stubs for use by pin_page_for_write.
*/
#define pmd_hugewillfault(pmd) (0)
#define pmd_thp_or_huge(pmd) (0)
#endif /* __ASSEMBLY__ */
#endif /* _ASM_PGTABLE_2LEVEL_H */