blob: e9665798c4be639e40c25e78a36fbac0ef1f0d74 [file] [log] [blame]
* Wiznet w5x00
This is a standalone 10/100 MBit Ethernet controller with SPI interface.
For each device connected to a SPI bus, define a child node within
the SPI master node.
Required properties:
- compatible: Should be one of the following strings:
- reg: Specify the SPI chip select the chip is wired to.
- interrupts: Specify the interrupt index within the interrupt controller (referred
to above in interrupt-parent) and interrupt type. w5x00 natively
generates falling edge interrupts, however, additional board logic
might invert the signal.
- pinctrl-names: List of assigned state names, see pinctrl binding documentation.
- pinctrl-0: List of phandles to configure the GPIO pin used as interrupt line,
see also generic and your platform specific pinctrl binding
Optional properties:
- spi-max-frequency: Maximum frequency of the SPI bus when accessing the w5500.
According to the w5500 datasheet, the chip allows a maximum of 80 MHz, however,
board designs may need to limit this value.
- local-mac-address: See ethernet.txt in the same directory.
Example (for Raspberry Pi with pin control stuff for GPIO irq):
&spi {
ethernet@0: w5500@0 {
compatible = "wiznet,w5500";
reg = <0>;
pinctrl-names = "default";
pinctrl-0 = <&eth1_pins>;
interrupt-parent = <&gpio>;
interrupts = <25 IRQ_TYPE_EDGE_FALLING>;
spi-max-frequency = <30000000>;
&gpio {
eth1_pins: eth1_pins {
brcm,pins = <25>;
brcm,function = <0>; /* in */
brcm,pull = <0>; /* none */