| /* SPDX-License-Identifier: GPL-2.0-only */ |
| /* |
| * Kernel page table mapping |
| * |
| * Copyright (C) 2015 ARM Ltd. |
| */ |
| |
| #ifndef __ASM_KERNEL_PGTABLE_H |
| #define __ASM_KERNEL_PGTABLE_H |
| |
| #include <asm/pgtable-hwdef.h> |
| #include <asm/sparsemem.h> |
| |
| /* |
| * The linear mapping and the start of memory are both 2M aligned (per |
| * the arm64 booting.txt requirements). Hence we can use section mapping |
| * with 4K (section size = 2M) but not with 16K (section size = 32M) or |
| * 64K (section size = 512M). |
| */ |
| #ifdef CONFIG_ARM64_4K_PAGES |
| #define ARM64_SWAPPER_USES_SECTION_MAPS 1 |
| #else |
| #define ARM64_SWAPPER_USES_SECTION_MAPS 0 |
| #endif |
| |
| /* |
| * The idmap and swapper page tables need some space reserved in the kernel |
| * image. Both require pgd, pud (4 levels only) and pmd tables to (section) |
| * map the kernel. With the 64K page configuration, swapper and idmap need to |
| * map to pte level. The swapper also maps the FDT (see __create_page_tables |
| * for more information). Note that the number of ID map translation levels |
| * could be increased on the fly if system RAM is out of reach for the default |
| * VA range, so pages required to map highest possible PA are reserved in all |
| * cases. |
| */ |
| #if ARM64_SWAPPER_USES_SECTION_MAPS |
| #define SWAPPER_PGTABLE_LEVELS (CONFIG_PGTABLE_LEVELS - 1) |
| #define IDMAP_PGTABLE_LEVELS (ARM64_HW_PGTABLE_LEVELS(PHYS_MASK_SHIFT) - 1) |
| #else |
| #define SWAPPER_PGTABLE_LEVELS (CONFIG_PGTABLE_LEVELS) |
| #define IDMAP_PGTABLE_LEVELS (ARM64_HW_PGTABLE_LEVELS(PHYS_MASK_SHIFT)) |
| #endif |
| |
| |
| /* |
| * If KASLR is enabled, then an offset K is added to the kernel address |
| * space. The bottom 21 bits of this offset are zero to guarantee 2MB |
| * alignment for PA and VA. |
| * |
| * For each pagetable level of the swapper, we know that the shift will |
| * be larger than 21 (for the 4KB granule case we use section maps thus |
| * the smallest shift is actually 30) thus there is the possibility that |
| * KASLR can increase the number of pagetable entries by 1, so we make |
| * room for this extra entry. |
| * |
| * Note KASLR cannot increase the number of required entries for a level |
| * by more than one because it increments both the virtual start and end |
| * addresses equally (the extra entry comes from the case where the end |
| * address is just pushed over a boundary and the start address isn't). |
| */ |
| |
| #ifdef CONFIG_RANDOMIZE_BASE |
| #define EARLY_KASLR (1) |
| #else |
| #define EARLY_KASLR (0) |
| #endif |
| |
| #define EARLY_ENTRIES(vstart, vend, shift) (((vend) >> (shift)) \ |
| - ((vstart) >> (shift)) + 1 + EARLY_KASLR) |
| |
| #define EARLY_PGDS(vstart, vend) (EARLY_ENTRIES(vstart, vend, PGDIR_SHIFT)) |
| |
| #if SWAPPER_PGTABLE_LEVELS > 3 |
| #define EARLY_PUDS(vstart, vend) (EARLY_ENTRIES(vstart, vend, PUD_SHIFT)) |
| #else |
| #define EARLY_PUDS(vstart, vend) (0) |
| #endif |
| |
| #if SWAPPER_PGTABLE_LEVELS > 2 |
| #define EARLY_PMDS(vstart, vend) (EARLY_ENTRIES(vstart, vend, SWAPPER_TABLE_SHIFT)) |
| #else |
| #define EARLY_PMDS(vstart, vend) (0) |
| #endif |
| |
| #define EARLY_PAGES(vstart, vend) ( 1 /* PGDIR page */ \ |
| + EARLY_PGDS((vstart), (vend)) /* each PGDIR needs a next level page table */ \ |
| + EARLY_PUDS((vstart), (vend)) /* each PUD needs a next level page table */ \ |
| + EARLY_PMDS((vstart), (vend))) /* each PMD needs a next level page table */ |
| #define INIT_DIR_SIZE (PAGE_SIZE * EARLY_PAGES(KIMAGE_VADDR + TEXT_OFFSET, _end)) |
| #define IDMAP_DIR_SIZE (IDMAP_PGTABLE_LEVELS * PAGE_SIZE) |
| |
| #ifdef CONFIG_ARM64_SW_TTBR0_PAN |
| #define RESERVED_TTBR0_SIZE (PAGE_SIZE) |
| #else |
| #define RESERVED_TTBR0_SIZE (0) |
| #endif |
| |
| /* Initial memory map size */ |
| #if ARM64_SWAPPER_USES_SECTION_MAPS |
| #define SWAPPER_BLOCK_SHIFT SECTION_SHIFT |
| #define SWAPPER_BLOCK_SIZE SECTION_SIZE |
| #define SWAPPER_TABLE_SHIFT PUD_SHIFT |
| #else |
| #define SWAPPER_BLOCK_SHIFT PAGE_SHIFT |
| #define SWAPPER_BLOCK_SIZE PAGE_SIZE |
| #define SWAPPER_TABLE_SHIFT PMD_SHIFT |
| #endif |
| |
| /* The size of the initial kernel direct mapping */ |
| #define SWAPPER_INIT_MAP_SIZE (_AC(1, UL) << SWAPPER_TABLE_SHIFT) |
| |
| /* |
| * Initial memory map attributes. |
| */ |
| #define SWAPPER_PTE_FLAGS (PTE_TYPE_PAGE | PTE_AF | PTE_SHARED) |
| #define SWAPPER_PMD_FLAGS (PMD_TYPE_SECT | PMD_SECT_AF | PMD_SECT_S) |
| |
| #if ARM64_SWAPPER_USES_SECTION_MAPS |
| #define SWAPPER_MM_MMUFLAGS (PMD_ATTRINDX(MT_NORMAL) | SWAPPER_PMD_FLAGS) |
| #else |
| #define SWAPPER_MM_MMUFLAGS (PTE_ATTRINDX(MT_NORMAL) | SWAPPER_PTE_FLAGS) |
| #endif |
| |
| /* |
| * To make optimal use of block mappings when laying out the linear |
| * mapping, round down the base of physical memory to a size that can |
| * be mapped efficiently, i.e., either PUD_SIZE (4k granule) or PMD_SIZE |
| * (64k granule), or a multiple that can be mapped using contiguous bits |
| * in the page tables: 32 * PMD_SIZE (16k granule) |
| */ |
| #if defined(CONFIG_ARM64_4K_PAGES) |
| #define ARM64_MEMSTART_SHIFT PUD_SHIFT |
| #elif defined(CONFIG_ARM64_16K_PAGES) |
| #define ARM64_MEMSTART_SHIFT (PMD_SHIFT + 5) |
| #else |
| #define ARM64_MEMSTART_SHIFT PMD_SHIFT |
| #endif |
| |
| /* |
| * sparsemem vmemmap imposes an additional requirement on the alignment of |
| * memstart_addr, due to the fact that the base of the vmemmap region |
| * has a direct correspondence, and needs to appear sufficiently aligned |
| * in the virtual address space. |
| */ |
| #if defined(CONFIG_SPARSEMEM_VMEMMAP) && ARM64_MEMSTART_SHIFT < SECTION_SIZE_BITS |
| #define ARM64_MEMSTART_ALIGN (1UL << SECTION_SIZE_BITS) |
| #else |
| #define ARM64_MEMSTART_ALIGN (1UL << ARM64_MEMSTART_SHIFT) |
| #endif |
| |
| #endif /* __ASM_KERNEL_PGTABLE_H */ |