| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Copyright (C) 2011 - 2012 Cavium, Inc. |
| */ |
| |
| #include <linux/module.h> |
| #include <linux/phy.h> |
| #include <linux/of.h> |
| |
| #define PHY_ID_BCM8706 0x0143bdc1 |
| #define PHY_ID_BCM8727 0x0143bff0 |
| |
| #define BCM87XX_PMD_RX_SIGNAL_DETECT (MII_ADDR_C45 | 0x1000a) |
| #define BCM87XX_10GBASER_PCS_STATUS (MII_ADDR_C45 | 0x30020) |
| #define BCM87XX_XGXS_LANE_STATUS (MII_ADDR_C45 | 0x40018) |
| |
| #define BCM87XX_LASI_CONTROL (MII_ADDR_C45 | 0x39002) |
| #define BCM87XX_LASI_STATUS (MII_ADDR_C45 | 0x39005) |
| |
| #if IS_ENABLED(CONFIG_OF_MDIO) |
| /* Set and/or override some configuration registers based on the |
| * broadcom,c45-reg-init property stored in the of_node for the phydev. |
| * |
| * broadcom,c45-reg-init = <devid reg mask value>,...; |
| * |
| * There may be one or more sets of <devid reg mask value>: |
| * |
| * devid: which sub-device to use. |
| * reg: the register. |
| * mask: if non-zero, ANDed with existing register value. |
| * value: ORed with the masked value and written to the regiser. |
| * |
| */ |
| static int bcm87xx_of_reg_init(struct phy_device *phydev) |
| { |
| const __be32 *paddr; |
| const __be32 *paddr_end; |
| int len, ret; |
| |
| if (!phydev->mdio.dev.of_node) |
| return 0; |
| |
| paddr = of_get_property(phydev->mdio.dev.of_node, |
| "broadcom,c45-reg-init", &len); |
| if (!paddr) |
| return 0; |
| |
| paddr_end = paddr + (len /= sizeof(*paddr)); |
| |
| ret = 0; |
| |
| while (paddr + 3 < paddr_end) { |
| u16 devid = be32_to_cpup(paddr++); |
| u16 reg = be32_to_cpup(paddr++); |
| u16 mask = be32_to_cpup(paddr++); |
| u16 val_bits = be32_to_cpup(paddr++); |
| int val; |
| u32 regnum = MII_ADDR_C45 | (devid << 16) | reg; |
| val = 0; |
| if (mask) { |
| val = phy_read(phydev, regnum); |
| if (val < 0) { |
| ret = val; |
| goto err; |
| } |
| val &= mask; |
| } |
| val |= val_bits; |
| |
| ret = phy_write(phydev, regnum, val); |
| if (ret < 0) |
| goto err; |
| } |
| err: |
| return ret; |
| } |
| #else |
| static int bcm87xx_of_reg_init(struct phy_device *phydev) |
| { |
| return 0; |
| } |
| #endif /* CONFIG_OF_MDIO */ |
| |
| static int bcm87xx_config_init(struct phy_device *phydev) |
| { |
| linkmode_zero(phydev->supported); |
| linkmode_set_bit(ETHTOOL_LINK_MODE_10000baseR_FEC_BIT, |
| phydev->supported); |
| linkmode_zero(phydev->advertising); |
| linkmode_set_bit(ETHTOOL_LINK_MODE_10000baseR_FEC_BIT, |
| phydev->advertising); |
| phydev->state = PHY_NOLINK; |
| phydev->autoneg = AUTONEG_DISABLE; |
| |
| bcm87xx_of_reg_init(phydev); |
| |
| return 0; |
| } |
| |
| static int bcm87xx_config_aneg(struct phy_device *phydev) |
| { |
| return -EINVAL; |
| } |
| |
| static int bcm87xx_read_status(struct phy_device *phydev) |
| { |
| int rx_signal_detect; |
| int pcs_status; |
| int xgxs_lane_status; |
| |
| rx_signal_detect = phy_read(phydev, BCM87XX_PMD_RX_SIGNAL_DETECT); |
| if (rx_signal_detect < 0) |
| return rx_signal_detect; |
| |
| if ((rx_signal_detect & 1) == 0) |
| goto no_link; |
| |
| pcs_status = phy_read(phydev, BCM87XX_10GBASER_PCS_STATUS); |
| if (pcs_status < 0) |
| return pcs_status; |
| |
| if ((pcs_status & 1) == 0) |
| goto no_link; |
| |
| xgxs_lane_status = phy_read(phydev, BCM87XX_XGXS_LANE_STATUS); |
| if (xgxs_lane_status < 0) |
| return xgxs_lane_status; |
| |
| if ((xgxs_lane_status & 0x1000) == 0) |
| goto no_link; |
| |
| phydev->speed = 10000; |
| phydev->link = 1; |
| phydev->duplex = 1; |
| return 0; |
| |
| no_link: |
| phydev->link = 0; |
| return 0; |
| } |
| |
| static int bcm87xx_config_intr(struct phy_device *phydev) |
| { |
| int reg, err; |
| |
| reg = phy_read(phydev, BCM87XX_LASI_CONTROL); |
| |
| if (reg < 0) |
| return reg; |
| |
| if (phydev->interrupts == PHY_INTERRUPT_ENABLED) |
| reg |= 1; |
| else |
| reg &= ~1; |
| |
| err = phy_write(phydev, BCM87XX_LASI_CONTROL, reg); |
| return err; |
| } |
| |
| static int bcm87xx_did_interrupt(struct phy_device *phydev) |
| { |
| int reg; |
| |
| reg = phy_read(phydev, BCM87XX_LASI_STATUS); |
| |
| if (reg < 0) { |
| phydev_err(phydev, |
| "Error: Read of BCM87XX_LASI_STATUS failed: %d\n", |
| reg); |
| return 0; |
| } |
| return (reg & 1) != 0; |
| } |
| |
| static int bcm87xx_ack_interrupt(struct phy_device *phydev) |
| { |
| /* Reading the LASI status clears it. */ |
| bcm87xx_did_interrupt(phydev); |
| return 0; |
| } |
| |
| static int bcm8706_match_phy_device(struct phy_device *phydev) |
| { |
| return phydev->c45_ids.device_ids[4] == PHY_ID_BCM8706; |
| } |
| |
| static int bcm8727_match_phy_device(struct phy_device *phydev) |
| { |
| return phydev->c45_ids.device_ids[4] == PHY_ID_BCM8727; |
| } |
| |
| static struct phy_driver bcm87xx_driver[] = { |
| { |
| .phy_id = PHY_ID_BCM8706, |
| .phy_id_mask = 0xffffffff, |
| .name = "Broadcom BCM8706", |
| .features = PHY_10GBIT_FEC_FEATURES, |
| .config_init = bcm87xx_config_init, |
| .config_aneg = bcm87xx_config_aneg, |
| .read_status = bcm87xx_read_status, |
| .ack_interrupt = bcm87xx_ack_interrupt, |
| .config_intr = bcm87xx_config_intr, |
| .did_interrupt = bcm87xx_did_interrupt, |
| .match_phy_device = bcm8706_match_phy_device, |
| }, { |
| .phy_id = PHY_ID_BCM8727, |
| .phy_id_mask = 0xffffffff, |
| .name = "Broadcom BCM8727", |
| .features = PHY_10GBIT_FEC_FEATURES, |
| .config_init = bcm87xx_config_init, |
| .config_aneg = bcm87xx_config_aneg, |
| .read_status = bcm87xx_read_status, |
| .ack_interrupt = bcm87xx_ack_interrupt, |
| .config_intr = bcm87xx_config_intr, |
| .did_interrupt = bcm87xx_did_interrupt, |
| .match_phy_device = bcm8727_match_phy_device, |
| } }; |
| |
| module_phy_driver(bcm87xx_driver); |
| |
| MODULE_LICENSE("GPL v2"); |