| # SPDX-License-Identifier: ISC |
| config WIL6210 |
| tristate "Wilocity 60g WiFi card wil6210 support" |
| select WANT_DEV_COREDUMP |
| select CRC32 |
| depends on CFG80211 |
| depends on PCI |
| default n |
| help |
| This module adds support for wireless adapter based on |
| wil6210 chip by Wilocity. It supports operation on the |
| 60 GHz band, covered by the IEEE802.11ad standard. |
| |
| https://wireless.wiki.kernel.org/en/users/Drivers/wil6210 |
| |
| If you choose to build it as a module, it will be called |
| wil6210 |
| |
| config WIL6210_ISR_COR |
| bool "Use Clear-On-Read mode for ISR registers for wil6210" |
| depends on WIL6210 |
| default y |
| help |
| ISR registers on wil6210 chip may operate in either |
| COR (Clear-On-Read) or W1C (Write-1-to-Clear) mode. |
| For production code, use COR (say y); is default since |
| it saves extra target transaction; |
| For ISR debug, use W1C (say n); is allows to monitor ISR |
| registers with debugfs. If COR were used, ISR would |
| self-clear when accessed for debug purposes, it makes |
| such monitoring impossible. |
| Say y unless you debug interrupts |
| |
| config WIL6210_TRACING |
| bool "wil6210 tracing support" |
| depends on WIL6210 |
| depends on EVENT_TRACING |
| default n |
| help |
| Say Y here to enable tracepoints for the wil6210 driver |
| using the kernel tracing infrastructure. Select this |
| option if you are interested in debugging the driver. |
| |
| If unsure, say Y to make it easier to debug problems. |
| |
| config WIL6210_DEBUGFS |
| bool "wil6210 debugfs support" |
| depends on WIL6210 |
| depends on DEBUG_FS |
| default y |
| help |
| Say Y here to enable wil6210 debugfs support, using the |
| kernel debugfs infrastructure. Select this |
| option if you are interested in debugging the driver. |
| |
| If unsure, say Y to make it easier to debug problems. |
