| /* SPDX-License-Identifier: GPL-2.0 */ |
| /* |
| * Support for Intel Camera Imaging ISP subsystem. |
| * Copyright (c) 2015, Intel Corporation. |
| * |
| * This program is free software; you can redistribute it and/or modify it |
| * under the terms and conditions of the GNU General Public License, |
| * version 2, as published by the Free Software Foundation. |
| * |
| * This program is distributed in the hope it will be useful, but WITHOUT |
| * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or |
| * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for |
| * more details. |
| */ |
| |
| #ifndef HRT_GDC_v2_defs_h_ |
| #define HRT_GDC_v2_defs_h_ |
| |
| #define HRT_GDC_IS_V2 |
| |
| #define HRT_GDC_N 1024 /* Top-level design constant, equal to the number of entries in the LUT */ |
| #define HRT_GDC_FRAC_BITS 10 /* Number of fractional bits in the GDC block, driven by the size of the LUT */ |
| |
| #define HRT_GDC_BLI_FRAC_BITS 4 /* Number of fractional bits for the bi-linear interpolation type */ |
| #define HRT_GDC_BLI_COEF_ONE BIT(HRT_GDC_BLI_FRAC_BITS) |
| |
| #define HRT_GDC_BCI_COEF_BITS 14 /* 14 bits per coefficient */ |
| #define HRT_GDC_BCI_COEF_ONE (1 << (HRT_GDC_BCI_COEF_BITS - 2)) /* We represent signed 10 bit coefficients. */ |
| /* The supported range is [-256, .., +256] */ |
| /* in 14-bit signed notation, */ |
| /* We need all ten bits (MSB must be zero). */ |
| /* -s is inserted to solve this issue, and */ |
| /* therefore "1" is equal to +256. */ |
| #define HRT_GDC_BCI_COEF_MASK ((1 << HRT_GDC_BCI_COEF_BITS) - 1) |
| |
| #define HRT_GDC_LUT_BYTES (HRT_GDC_N * 4 * 2) /* 1024 addresses, 4 coefficients per address, */ |
| /* 2 bytes per coefficient */ |
| |
| #define _HRT_GDC_REG_ALIGN 4 |
| |
| // 31 30 29 25 24 0 |
| // |-----|---|--------|------------------------| |
| // | CMD | C | Reg_ID | Value | |
| |
| // There are just two commands possible for the GDC block: |
| // 1 - Configure reg |
| // 0 - Data token |
| |
| // C - Reserved bit |
| // Used in protocol to indicate whether it is C-run or other type of runs |
| // In case of C-run, this bit has a value of 1, for all the other runs, it is 0. |
| |
| // Reg_ID - Address of the register to be configured |
| |
| // Value - Value to store to the addressed register, maximum of 24 bits |
| |
| // Configure reg command is not followed by any other token. |
| // The address of the register and the data to be filled in is contained in the same token |
| |
| // When the first data token is received, it must be: |
| // 1. FRX and FRY (device configured in one of the scaling modes) ***DEFAULT MODE***, or, |
| // 2. P0'X (device configured in one of the tetragon modes) |
| // After the first data token is received, pre-defined number of tokens with the following meaning follow: |
| // 1. two tokens: SRC address ; DST address |
| // 2. nine tokens: P0'Y, .., P3'Y ; SRC address ; DST address |
| |
| #define HRT_GDC_CONFIG_CMD 1 |
| #define HRT_GDC_DATA_CMD 0 |
| |
| #define HRT_GDC_CMD_POS 31 |
| #define HRT_GDC_CMD_BITS 1 |
| #define HRT_GDC_CRUN_POS 30 |
| #define HRT_GDC_REG_ID_POS 25 |
| #define HRT_GDC_REG_ID_BITS 5 |
| #define HRT_GDC_DATA_POS 0 |
| #define HRT_GDC_DATA_BITS 25 |
| |
| #define HRT_GDC_FRYIPXFRX_BITS 26 |
| #define HRT_GDC_P0X_BITS 23 |
| |
| #define HRT_GDC_MAX_OXDIM (8192 - 64) |
| #define HRT_GDC_MAX_OYDIM 4095 |
| #define HRT_GDC_MAX_IXDIM (8192 - 64) |
| #define HRT_GDC_MAX_IYDIM 4095 |
| #define HRT_GDC_MAX_DS_FAC 16 |
| #define HRT_GDC_MAX_DX (HRT_GDC_MAX_DS_FAC * HRT_GDC_N - 1) |
| #define HRT_GDC_MAX_DY HRT_GDC_MAX_DX |
| |
| /* GDC lookup tables entries are 10 bits values, but they're |
| stored 2 by 2 as 32 bit values, yielding 16 bits per entry. |
| A GDC lookup table contains 64 * 4 elements */ |
| |
| #define HRT_GDC_PERF_1_1_pix 0 |
| #define HRT_GDC_PERF_2_1_pix 1 |
| #define HRT_GDC_PERF_1_2_pix 2 |
| #define HRT_GDC_PERF_2_2_pix 3 |
| |
| #define HRT_GDC_NND_MODE 0 |
| #define HRT_GDC_BLI_MODE 1 |
| #define HRT_GDC_BCI_MODE 2 |
| #define HRT_GDC_LUT_MODE 3 |
| |
| #define HRT_GDC_SCAN_STB 0 |
| #define HRT_GDC_SCAN_STR 1 |
| |
| #define HRT_GDC_MODE_SCALING 0 |
| #define HRT_GDC_MODE_TETRAGON 1 |
| |
| #define HRT_GDC_LUT_COEFF_OFFSET 16 |
| #define HRT_GDC_FRY_BIT_OFFSET 16 |
| // FRYIPXFRX is the only register where we store two values in one field, |
| // to save one token in the scaling protocol. |
| // Like this, we have three tokens in the scaling protocol, |
| // Otherwise, we would have had four. |
| // The register bit-map is: |
| // 31 26 25 16 15 10 9 0 |
| // |------|----------|------|----------| |
| // | XXXX | FRY | IPX | FRX | |
| |
| #define HRT_GDC_CE_FSM0_POS 0 |
| #define HRT_GDC_CE_FSM0_LEN 2 |
| #define HRT_GDC_CE_OPY_POS 2 |
| #define HRT_GDC_CE_OPY_LEN 14 |
| #define HRT_GDC_CE_OPX_POS 16 |
| #define HRT_GDC_CE_OPX_LEN 16 |
| // CHK_ENGINE register bit-map: |
| // 31 16 15 2 1 0 |
| // |----------------|-----------|----| |
| // | OPX | OPY |FSM0| |
| // However, for the time being at least, |
| // this implementation is meaningless in hss model, |
| // So, we just return 0 |
| |
| #define HRT_GDC_CHK_ENGINE_IDX 0 |
| #define HRT_GDC_WOIX_IDX 1 |
| #define HRT_GDC_WOIY_IDX 2 |
| #define HRT_GDC_BPP_IDX 3 |
| #define HRT_GDC_FRYIPXFRX_IDX 4 |
| #define HRT_GDC_OXDIM_IDX 5 |
| #define HRT_GDC_OYDIM_IDX 6 |
| #define HRT_GDC_SRC_ADDR_IDX 7 |
| #define HRT_GDC_SRC_END_ADDR_IDX 8 |
| #define HRT_GDC_SRC_WRAP_ADDR_IDX 9 |
| #define HRT_GDC_SRC_STRIDE_IDX 10 |
| #define HRT_GDC_DST_ADDR_IDX 11 |
| #define HRT_GDC_DST_STRIDE_IDX 12 |
| #define HRT_GDC_DX_IDX 13 |
| #define HRT_GDC_DY_IDX 14 |
| #define HRT_GDC_P0X_IDX 15 |
| #define HRT_GDC_P0Y_IDX 16 |
| #define HRT_GDC_P1X_IDX 17 |
| #define HRT_GDC_P1Y_IDX 18 |
| #define HRT_GDC_P2X_IDX 19 |
| #define HRT_GDC_P2Y_IDX 20 |
| #define HRT_GDC_P3X_IDX 21 |
| #define HRT_GDC_P3Y_IDX 22 |
| #define HRT_GDC_PERF_POINT_IDX 23 // 1x1 ; 1x2 ; 2x1 ; 2x2 pixels per cc |
| #define HRT_GDC_INTERP_TYPE_IDX 24 // NND ; BLI ; BCI ; LUT |
| #define HRT_GDC_SCAN_IDX 25 // 0 = STB (Slide To Bottom) ; 1 = STR (Slide To Right) |
| #define HRT_GDC_PROC_MODE_IDX 26 // 0 = Scaling ; 1 = Tetragon |
| |
| #define HRT_GDC_LUT_IDX 32 |
| |
| #endif /* HRT_GDC_v2_defs_h_ */ |