| /* SPDX-License-Identifier: GPL-2.0 */ |
| #ifndef _ASM_SPARC_DMA_H |
| #define _ASM_SPARC_DMA_H |
| |
| /* These are irrelevant for Sparc DMA, but we leave it in so that |
| * things can compile. |
| */ |
| #define MAX_DMA_CHANNELS 8 |
| #define DMA_MODE_READ 1 |
| #define DMA_MODE_WRITE 2 |
| #define MAX_DMA_ADDRESS (~0UL) |
| |
| /* Useful constants */ |
| #define SIZE_16MB (16*1024*1024) |
| #define SIZE_64K (64*1024) |
| |
| /* SBUS DMA controller reg offsets */ |
| #define DMA_CSR 0x00UL /* rw DMA control/status register 0x00 */ |
| #define DMA_ADDR 0x04UL /* rw DMA transfer address register 0x04 */ |
| #define DMA_COUNT 0x08UL /* rw DMA transfer count register 0x08 */ |
| #define DMA_TEST 0x0cUL /* rw DMA test/debug register 0x0c */ |
| |
| /* Fields in the cond_reg register */ |
| /* First, the version identification bits */ |
| #define DMA_DEVICE_ID 0xf0000000 /* Device identification bits */ |
| #define DMA_VERS0 0x00000000 /* Sunray DMA version */ |
| #define DMA_ESCV1 0x40000000 /* DMA ESC Version 1 */ |
| #define DMA_VERS1 0x80000000 /* DMA rev 1 */ |
| #define DMA_VERS2 0xa0000000 /* DMA rev 2 */ |
| #define DMA_VERHME 0xb0000000 /* DMA hme gate array */ |
| #define DMA_VERSPLUS 0x90000000 /* DMA rev 1 PLUS */ |
| |
| #define DMA_HNDL_INTR 0x00000001 /* An IRQ needs to be handled */ |
| #define DMA_HNDL_ERROR 0x00000002 /* We need to take an error */ |
| #define DMA_FIFO_ISDRAIN 0x0000000c /* The DMA FIFO is draining */ |
| #define DMA_INT_ENAB 0x00000010 /* Turn on interrupts */ |
| #define DMA_FIFO_INV 0x00000020 /* Invalidate the FIFO */ |
| #define DMA_ACC_SZ_ERR 0x00000040 /* The access size was bad */ |
| #define DMA_FIFO_STDRAIN 0x00000040 /* DMA_VERS1 Drain the FIFO */ |
| #define DMA_RST_SCSI 0x00000080 /* Reset the SCSI controller */ |
| #define DMA_RST_ENET DMA_RST_SCSI /* Reset the ENET controller */ |
| #define DMA_ST_WRITE 0x00000100 /* write from device to memory */ |
| #define DMA_ENABLE 0x00000200 /* Fire up DMA, handle requests */ |
| #define DMA_PEND_READ 0x00000400 /* DMA_VERS1/0/PLUS Pending Read */ |
| #define DMA_ESC_BURST 0x00000800 /* 1=16byte 0=32byte */ |
| #define DMA_READ_AHEAD 0x00001800 /* DMA read ahead partial longword */ |
| #define DMA_DSBL_RD_DRN 0x00001000 /* No EC drain on slave reads */ |
| #define DMA_BCNT_ENAB 0x00002000 /* If on, use the byte counter */ |
| #define DMA_TERM_CNTR 0x00004000 /* Terminal counter */ |
| #define DMA_SCSI_SBUS64 0x00008000 /* HME: Enable 64-bit SBUS mode. */ |
| #define DMA_CSR_DISAB 0x00010000 /* No FIFO drains during csr */ |
| #define DMA_SCSI_DISAB 0x00020000 /* No FIFO drains during reg */ |
| #define DMA_DSBL_WR_INV 0x00020000 /* No EC inval. on slave writes */ |
| #define DMA_ADD_ENABLE 0x00040000 /* Special ESC DVMA optimization */ |
| #define DMA_E_BURSTS 0x000c0000 /* ENET: SBUS r/w burst mask */ |
| #define DMA_E_BURST32 0x00040000 /* ENET: SBUS 32 byte r/w burst */ |
| #define DMA_E_BURST16 0x00000000 /* ENET: SBUS 16 byte r/w burst */ |
| #define DMA_BRST_SZ 0x000c0000 /* SCSI: SBUS r/w burst size */ |
| #define DMA_BRST64 0x000c0000 /* SCSI: 64byte bursts (HME on UltraSparc only) */ |
| #define DMA_BRST32 0x00040000 /* SCSI: 32byte bursts */ |
| #define DMA_BRST16 0x00000000 /* SCSI: 16byte bursts */ |
| #define DMA_BRST0 0x00080000 /* SCSI: no bursts (non-HME gate arrays) */ |
| #define DMA_ADDR_DISAB 0x00100000 /* No FIFO drains during addr */ |
| #define DMA_2CLKS 0x00200000 /* Each transfer = 2 clock ticks */ |
| #define DMA_3CLKS 0x00400000 /* Each transfer = 3 clock ticks */ |
| #define DMA_EN_ENETAUI DMA_3CLKS /* Put lance into AUI-cable mode */ |
| #define DMA_CNTR_DISAB 0x00800000 /* No IRQ when DMA_TERM_CNTR set */ |
| #define DMA_AUTO_NADDR 0x01000000 /* Use "auto nxt addr" feature */ |
| #define DMA_SCSI_ON 0x02000000 /* Enable SCSI dma */ |
| #define DMA_PARITY_OFF 0x02000000 /* HME: disable parity checking */ |
| #define DMA_LOADED_ADDR 0x04000000 /* Address has been loaded */ |
| #define DMA_LOADED_NADDR 0x08000000 /* Next address has been loaded */ |
| #define DMA_RESET_FAS366 0x08000000 /* HME: Assert RESET to FAS366 */ |
| |
| /* Values describing the burst-size property from the PROM */ |
| #define DMA_BURST1 0x01 |
| #define DMA_BURST2 0x02 |
| #define DMA_BURST4 0x04 |
| #define DMA_BURST8 0x08 |
| #define DMA_BURST16 0x10 |
| #define DMA_BURST32 0x20 |
| #define DMA_BURST64 0x40 |
| #define DMA_BURSTBITS 0x7f |
| |
| #ifdef CONFIG_SPARC32 |
| struct device; |
| |
| unsigned long sparc_dma_alloc_resource(struct device *dev, size_t len); |
| bool sparc_dma_free_resource(void *cpu_addr, size_t size); |
| #endif |
| |
| #endif /* !(_ASM_SPARC_DMA_H) */ |
