| /* SPDX-License-Identifier: GPL-2.0 */ |
| /* |
| * xHCI host controller driver |
| * |
| * Copyright (C) 2008 Intel Corp. |
| * |
| * Author: Sarah Sharp |
| * Some code borrowed from the Linux EHCI driver. |
| */ |
| |
| /* HC should halt within 16 ms, but use 32 ms as some hosts take longer */ |
| #define XHCI_MAX_HALT_USEC (32 * 1000) |
| /* HC not running - set to 1 when run/stop bit is cleared. */ |
| #define XHCI_STS_HALT (1<<0) |
| |
| /* HCCPARAMS offset from PCI base address */ |
| #define XHCI_HCC_PARAMS_OFFSET 0x10 |
| /* HCCPARAMS contains the first extended capability pointer */ |
| #define XHCI_HCC_EXT_CAPS(p) (((p)>>16)&0xffff) |
| |
| /* Command and Status registers offset from the Operational Registers address */ |
| #define XHCI_CMD_OFFSET 0x00 |
| #define XHCI_STS_OFFSET 0x04 |
| |
| #define XHCI_MAX_EXT_CAPS 50 |
| |
| /* Capability Register */ |
| /* bits 7:0 - how long is the Capabilities register */ |
| #define XHCI_HC_LENGTH(p) (((p)>>00)&0x00ff) |
| |
| /* Extended capability register fields */ |
| #define XHCI_EXT_CAPS_ID(p) (((p)>>0)&0xff) |
| #define XHCI_EXT_CAPS_NEXT(p) (((p)>>8)&0xff) |
| #define XHCI_EXT_CAPS_VAL(p) ((p)>>16) |
| /* Extended capability IDs - ID 0 reserved */ |
| #define XHCI_EXT_CAPS_LEGACY 1 |
| #define XHCI_EXT_CAPS_PROTOCOL 2 |
| #define XHCI_EXT_CAPS_PM 3 |
| #define XHCI_EXT_CAPS_VIRT 4 |
| #define XHCI_EXT_CAPS_ROUTE 5 |
| /* IDs 6-9 reserved */ |
| #define XHCI_EXT_CAPS_DEBUG 10 |
| /* Vendor caps */ |
| #define XHCI_EXT_CAPS_VENDOR_INTEL 192 |
| /* USB Legacy Support Capability - section 7.1.1 */ |
| #define XHCI_HC_BIOS_OWNED (1 << 16) |
| #define XHCI_HC_OS_OWNED (1 << 24) |
| |
| /* USB Legacy Support Capability - section 7.1.1 */ |
| /* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ |
| #define XHCI_LEGACY_SUPPORT_OFFSET (0x00) |
| |
| /* USB Legacy Support Control and Status Register - section 7.1.2 */ |
| /* Add this offset, plus the value of xECP in HCCPARAMS to the base address */ |
| #define XHCI_LEGACY_CONTROL_OFFSET (0x04) |
| /* bits 1:3, 5:12, and 17:19 need to be preserved; bits 21:28 should be zero */ |
| #define XHCI_LEGACY_DISABLE_SMI ((0x7 << 1) + (0xff << 5) + (0x7 << 17)) |
| #define XHCI_LEGACY_SMI_EVENTS (0x7 << 29) |
| |
| /* USB 2.0 xHCI 0.96 L1C capability - section 7.2.2.1.3.2 */ |
| #define XHCI_L1C (1 << 16) |
| |
| /* USB 2.0 xHCI 1.0 hardware LMP capability - section 7.2.2.1.3.2 */ |
| #define XHCI_HLC (1 << 19) |
| #define XHCI_BLC (1 << 20) |
| |
| /* command register values to disable interrupts and halt the HC */ |
| /* start/stop HC execution - do not write unless HC is halted*/ |
| #define XHCI_CMD_RUN (1 << 0) |
| /* Event Interrupt Enable - get irq when EINT bit is set in USBSTS register */ |
| #define XHCI_CMD_EIE (1 << 2) |
| /* Host System Error Interrupt Enable - get irq when HSEIE bit set in USBSTS */ |
| #define XHCI_CMD_HSEIE (1 << 3) |
| /* Enable Wrap Event - '1' means xHC generates an event when MFINDEX wraps. */ |
| #define XHCI_CMD_EWE (1 << 10) |
| |
| #define XHCI_IRQS (XHCI_CMD_EIE | XHCI_CMD_HSEIE | XHCI_CMD_EWE) |
| |
| /* true: Controller Not Ready to accept doorbell or op reg writes after reset */ |
| #define XHCI_STS_CNR (1 << 11) |
| |
| /** |
| * struct xhci_protocol_caps |
| * @revision: major revision, minor revision, capability ID, |
| * and next capability pointer. |
| * @name_string: Four ASCII characters to say which spec this xHC |
| * follows, typically "USB ". |
| * @port_info: Port offset, count, and protocol-defined information. |
| */ |
| struct xhci_protocol_caps { |
| u32 revision; |
| u32 name_string; |
| u32 port_info; |
| }; |
| |
| #define XHCI_EXT_PORT_MAJOR(x) (((x) >> 24) & 0xff) |
| #define XHCI_EXT_PORT_MINOR(x) (((x) >> 16) & 0xff) |
| #define XHCI_EXT_PORT_PSIC(x) (((x) >> 28) & 0x0f) |
| #define XHCI_EXT_PORT_OFF(x) ((x) & 0xff) |
| #define XHCI_EXT_PORT_COUNT(x) (((x) >> 8) & 0xff) |
| |
| #define XHCI_EXT_PORT_PSIV(x) (((x) >> 0) & 0x0f) |
| #define XHCI_EXT_PORT_PSIE(x) (((x) >> 4) & 0x03) |
| #define XHCI_EXT_PORT_PLT(x) (((x) >> 6) & 0x03) |
| #define XHCI_EXT_PORT_PFD(x) (((x) >> 8) & 0x01) |
| #define XHCI_EXT_PORT_LP(x) (((x) >> 14) & 0x03) |
| #define XHCI_EXT_PORT_PSIM(x) (((x) >> 16) & 0xffff) |
| |
| #include <linux/io.h> |
| |
| /** |
| * Find the offset of the extended capabilities with capability ID id. |
| * |
| * @base PCI MMIO registers base address. |
| * @start address at which to start looking, (0 or HCC_PARAMS to start at |
| * beginning of list) |
| * @id Extended capability ID to search for, or 0 for the next |
| * capability |
| * |
| * Returns the offset of the next matching extended capability structure. |
| * Some capabilities can occur several times, e.g., the XHCI_EXT_CAPS_PROTOCOL, |
| * and this provides a way to find them all. |
| */ |
| |
| static inline int xhci_find_next_ext_cap(void __iomem *base, u32 start, int id) |
| { |
| u32 val; |
| u32 next; |
| u32 offset; |
| |
| offset = start; |
| if (!start || start == XHCI_HCC_PARAMS_OFFSET) { |
| val = readl(base + XHCI_HCC_PARAMS_OFFSET); |
| if (val == ~0) |
| return 0; |
| offset = XHCI_HCC_EXT_CAPS(val) << 2; |
| if (!offset) |
| return 0; |
| } |
| do { |
| val = readl(base + offset); |
| if (val == ~0) |
| return 0; |
| if (offset != start && (id == 0 || XHCI_EXT_CAPS_ID(val) == id)) |
| return offset; |
| |
| next = XHCI_EXT_CAPS_NEXT(val); |
| offset += next << 2; |
| } while (next); |
| |
| return 0; |
| } |