| * PTN5150 CC (Configuration Channel) Logic device |
| |
| PTN5150 is a small thin low power CC logic chip supporting the USB Type-C |
| connector application with CC control logic detection and indication functions. |
| It is interfaced to the host controller using an I2C interface. |
| |
| Required properties: |
| - compatible: should be "nxp,ptn5150" |
| - reg: specifies the I2C slave address of the device |
| - int-gpio: should contain a phandle and GPIO specifier for the GPIO pin |
| connected to the PTN5150's INTB pin. |
| - vbus-gpio: should contain a phandle and GPIO specifier for the GPIO pin which |
| is used to control VBUS. |
| - pinctrl-names : a pinctrl state named "default" must be defined. |
| - pinctrl-0 : phandle referencing pin configuration of interrupt and vbus |
| control. |
| |
| Example: |
| ptn5150@1d { |
| compatible = "nxp,ptn5150"; |
| reg = <0x1d>; |
| int-gpio = <&msmgpio 78 GPIO_ACTIVE_HIGH>; |
| vbus-gpio = <&msmgpio 148 GPIO_ACTIVE_HIGH>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&ptn5150_default>; |
| status = "okay"; |
| }; |
