| # SPDX-License-Identifier: GPL-2.0-only |
| # |
| # Microchip network device configuration |
| # |
| |
| config NET_VENDOR_MICROCHIP |
| bool "Microchip devices" |
| default y |
| help |
| If you have a network (Ethernet) card belonging to this class, say Y. |
| |
| Note that the answer to this question doesn't directly affect the |
| kernel: saying N will just cause the configurator to skip all |
| the questions about Microchip cards. If you say Y, you will be asked |
| for your specific card in the following questions. |
| |
| if NET_VENDOR_MICROCHIP |
| |
| config ENC28J60 |
| tristate "ENC28J60 support" |
| depends on SPI |
| select CRC32 |
| help |
| Support for the Microchip EN28J60 ethernet chip. |
| |
| To compile this driver as a module, choose M here. The module will be |
| called enc28j60. |
| |
| config ENC28J60_WRITEVERIFY |
| bool "Enable write verify" |
| depends on ENC28J60 |
| help |
| Enable the verify after the buffer write useful for debugging purpose. |
| If unsure, say N. |
| |
| config ENCX24J600 |
| tristate "ENCX24J600 support" |
| depends on SPI |
| help |
| Support for the Microchip ENC424J600/624J600 ethernet chip. |
| |
| To compile this driver as a module, choose M here. The module will be |
| called encx24j600. |
| |
| config LAN743X |
| tristate "LAN743x support" |
| depends on PCI |
| select PHYLIB |
| select CRC16 |
| select CRC32 |
| help |
| Support for the Microchip LAN743x PCI Express Gigabit Ethernet chip |
| |
| To compile this driver as a module, choose M here. The module will be |
| called lan743x. |
| |
| endif # NET_VENDOR_MICROCHIP |
