| # SPDX-License-Identifier: GPL-2.0-only |
| |
| comment "Texas Instruments drivers" |
| |
| # TI VIDEO PORT Helper Modules |
| # These will be selected by VPE and VIP |
| config VIDEO_TI_VPDMA |
| tristate |
| |
| config VIDEO_TI_SC |
| tristate |
| |
| config VIDEO_TI_CSC |
| tristate |
| |
| # V4L drivers |
| |
| config VIDEO_TI_CAL |
| tristate "TI CAL (Camera Adaptation Layer) driver" |
| depends on VIDEO_DEV |
| depends on V4L_PLATFORM_DRIVERS |
| select MEDIA_CONTROLLER |
| select VIDEO_V4L2_SUBDEV_API |
| depends on SOC_DRA7XX || ARCH_K3 || COMPILE_TEST |
| select VIDEOBUF2_DMA_CONTIG |
| select V4L2_FWNODE |
| help |
| Support for the TI CAL (Camera Adaptation Layer) block |
| found on DRA72X SoC. |
| In TI Technical Reference Manual this module is referred as |
| Camera Interface Subsystem (CAMSS). |
| |
| config VIDEO_TI_CAL_MC |
| bool "Media Controller centric mode by default" |
| depends on VIDEO_TI_CAL |
| default n |
| help |
| Enables Media Controller centric mode by default. |
| |
| If set, CAL driver will start in Media Controller mode by |
| default. Note that this behavior can be overridden via |
| module parameter 'mc_api'. |
| |
| # Mem2mem drivers |
| |
| config VIDEO_TI_VPE |
| tristate "TI VPE (Video Processing Engine) driver" |
| depends on V4L_MEM2MEM_DRIVERS |
| depends on VIDEO_DEV |
| depends on SOC_DRA7XX || COMPILE_TEST |
| select VIDEOBUF2_DMA_CONTIG |
| select V4L2_MEM2MEM_DEV |
| select VIDEO_TI_VPDMA |
| select VIDEO_TI_SC |
| select VIDEO_TI_CSC |
| help |
| Support for the TI VPE(Video Processing Engine) block |
| found on DRA7XX SoC. |
| |
| config VIDEO_TI_VPE_DEBUG |
| bool "VPE debug messages" |
| depends on VIDEO_TI_VPE |
| help |
| Enable debug messages on VPE driver. |
| |
| config VIDEO_TI_J721E_CSI2RX |
| tristate "TI J721E CSI2RX wrapper layer driver" |
| depends on VIDEO_DEV && VIDEO_V4L2_SUBDEV_API |
| depends on MEDIA_SUPPORT && MEDIA_CONTROLLER |
| depends on (PHY_CADENCE_DPHY_RX && VIDEO_CADENCE_CSI2RX) || COMPILE_TEST |
| depends on ARCH_K3 || COMPILE_TEST |
| select VIDEOBUF2_DMA_CONTIG |
| select V4L2_FWNODE |
| help |
| Support for TI CSI2RX wrapper layer. This just enables the wrapper driver. |
| The Cadence CSI2RX bridge driver needs to be enabled separately. |
| |
| source "drivers/media/platform/ti/am437x/Kconfig" |
| source "drivers/media/platform/ti/davinci/Kconfig" |
| source "drivers/media/platform/ti/omap/Kconfig" |
| source "drivers/media/platform/ti/omap3isp/Kconfig" |
