| // SPDX-License-Identifier: GPL-2.0-or-later |
| /* |
| * Copyright (C) 2013 Aeroflex Gaisler |
| * |
| * This driver supports the APBPS2 PS/2 core available in the GRLIB |
| * VHDL IP core library. |
| * |
| * Full documentation of the APBPS2 core can be found here: |
| * http://www.gaisler.com/products/grlib/grip.pdf |
| * |
| * See "Documentation/devicetree/bindings/input/ps2keyb-mouse-apbps2.txt" for |
| * information on open firmware properties. |
| * |
| * Contributors: Daniel Hellstrom <daniel@gaisler.com> |
| */ |
| #include <linux/platform_device.h> |
| #include <linux/of_device.h> |
| #include <linux/module.h> |
| #include <linux/serio.h> |
| #include <linux/errno.h> |
| #include <linux/interrupt.h> |
| #include <linux/of_irq.h> |
| #include <linux/device.h> |
| #include <linux/delay.h> |
| #include <linux/err.h> |
| #include <linux/slab.h> |
| #include <linux/string.h> |
| #include <linux/kernel.h> |
| #include <linux/io.h> |
| |
| struct apbps2_regs { |
| u32 __iomem data; /* 0x00 */ |
| u32 __iomem status; /* 0x04 */ |
| u32 __iomem ctrl; /* 0x08 */ |
| u32 __iomem reload; /* 0x0c */ |
| }; |
| |
| #define APBPS2_STATUS_DR (1<<0) |
| #define APBPS2_STATUS_PE (1<<1) |
| #define APBPS2_STATUS_FE (1<<2) |
| #define APBPS2_STATUS_KI (1<<3) |
| #define APBPS2_STATUS_RF (1<<4) |
| #define APBPS2_STATUS_TF (1<<5) |
| #define APBPS2_STATUS_TCNT (0x1f<<22) |
| #define APBPS2_STATUS_RCNT (0x1f<<27) |
| |
| #define APBPS2_CTRL_RE (1<<0) |
| #define APBPS2_CTRL_TE (1<<1) |
| #define APBPS2_CTRL_RI (1<<2) |
| #define APBPS2_CTRL_TI (1<<3) |
| |
| struct apbps2_priv { |
| struct serio *io; |
| struct apbps2_regs __iomem *regs; |
| }; |
| |
| static int apbps2_idx; |
| |
| static irqreturn_t apbps2_isr(int irq, void *dev_id) |
| { |
| struct apbps2_priv *priv = dev_id; |
| unsigned long status, data, rxflags; |
| irqreturn_t ret = IRQ_NONE; |
| |
| while ((status = ioread32be(&priv->regs->status)) & APBPS2_STATUS_DR) { |
| data = ioread32be(&priv->regs->data); |
| rxflags = (status & APBPS2_STATUS_PE) ? SERIO_PARITY : 0; |
| rxflags |= (status & APBPS2_STATUS_FE) ? SERIO_FRAME : 0; |
| |
| /* clear error bits? */ |
| if (rxflags) |
| iowrite32be(0, &priv->regs->status); |
| |
| serio_interrupt(priv->io, data, rxflags); |
| |
| ret = IRQ_HANDLED; |
| } |
| |
| return ret; |
| } |
| |
| static int apbps2_write(struct serio *io, unsigned char val) |
| { |
| struct apbps2_priv *priv = io->port_data; |
| unsigned int tleft = 10000; /* timeout in 100ms */ |
| |
| /* delay until PS/2 controller has room for more chars */ |
| while ((ioread32be(&priv->regs->status) & APBPS2_STATUS_TF) && tleft--) |
| udelay(10); |
| |
| if ((ioread32be(&priv->regs->status) & APBPS2_STATUS_TF) == 0) { |
| iowrite32be(val, &priv->regs->data); |
| |
| iowrite32be(APBPS2_CTRL_RE | APBPS2_CTRL_RI | APBPS2_CTRL_TE, |
| &priv->regs->ctrl); |
| return 0; |
| } |
| |
| return -ETIMEDOUT; |
| } |
| |
| static int apbps2_open(struct serio *io) |
| { |
| struct apbps2_priv *priv = io->port_data; |
| int limit; |
| |
| /* clear error flags */ |
| iowrite32be(0, &priv->regs->status); |
| |
| /* Clear old data if available (unlikely) */ |
| limit = 1024; |
| while ((ioread32be(&priv->regs->status) & APBPS2_STATUS_DR) && --limit) |
| ioread32be(&priv->regs->data); |
| |
| /* Enable reciever and it's interrupt */ |
| iowrite32be(APBPS2_CTRL_RE | APBPS2_CTRL_RI, &priv->regs->ctrl); |
| |
| return 0; |
| } |
| |
| static void apbps2_close(struct serio *io) |
| { |
| struct apbps2_priv *priv = io->port_data; |
| |
| /* stop interrupts at PS/2 HW level */ |
| iowrite32be(0, &priv->regs->ctrl); |
| } |
| |
| /* Initialize one APBPS2 PS/2 core */ |
| static int apbps2_of_probe(struct platform_device *ofdev) |
| { |
| struct apbps2_priv *priv; |
| int irq, err; |
| u32 freq_hz; |
| struct resource *res; |
| |
| priv = devm_kzalloc(&ofdev->dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) { |
| dev_err(&ofdev->dev, "memory allocation failed\n"); |
| return -ENOMEM; |
| } |
| |
| /* Find Device Address */ |
| res = platform_get_resource(ofdev, IORESOURCE_MEM, 0); |
| priv->regs = devm_ioremap_resource(&ofdev->dev, res); |
| if (IS_ERR(priv->regs)) |
| return PTR_ERR(priv->regs); |
| |
| /* Reset hardware, disable interrupt */ |
| iowrite32be(0, &priv->regs->ctrl); |
| |
| /* IRQ */ |
| irq = irq_of_parse_and_map(ofdev->dev.of_node, 0); |
| err = devm_request_irq(&ofdev->dev, irq, apbps2_isr, |
| IRQF_SHARED, "apbps2", priv); |
| if (err) { |
| dev_err(&ofdev->dev, "request IRQ%d failed\n", irq); |
| return err; |
| } |
| |
| /* Get core frequency */ |
| if (of_property_read_u32(ofdev->dev.of_node, "freq", &freq_hz)) { |
| dev_err(&ofdev->dev, "unable to get core frequency\n"); |
| return -EINVAL; |
| } |
| |
| /* Set reload register to core freq in kHz/10 */ |
| iowrite32be(freq_hz / 10000, &priv->regs->reload); |
| |
| priv->io = kzalloc(sizeof(struct serio), GFP_KERNEL); |
| if (!priv->io) |
| return -ENOMEM; |
| |
| priv->io->id.type = SERIO_8042; |
| priv->io->open = apbps2_open; |
| priv->io->close = apbps2_close; |
| priv->io->write = apbps2_write; |
| priv->io->port_data = priv; |
| strscpy(priv->io->name, "APBPS2 PS/2", sizeof(priv->io->name)); |
| snprintf(priv->io->phys, sizeof(priv->io->phys), |
| "apbps2_%d", apbps2_idx++); |
| |
| dev_info(&ofdev->dev, "irq = %d, base = 0x%p\n", irq, priv->regs); |
| |
| serio_register_port(priv->io); |
| |
| platform_set_drvdata(ofdev, priv); |
| |
| return 0; |
| } |
| |
| static int apbps2_of_remove(struct platform_device *of_dev) |
| { |
| struct apbps2_priv *priv = platform_get_drvdata(of_dev); |
| |
| serio_unregister_port(priv->io); |
| |
| return 0; |
| } |
| |
| static const struct of_device_id apbps2_of_match[] = { |
| { .name = "GAISLER_APBPS2", }, |
| { .name = "01_060", }, |
| {} |
| }; |
| |
| MODULE_DEVICE_TABLE(of, apbps2_of_match); |
| |
| static struct platform_driver apbps2_of_driver = { |
| .driver = { |
| .name = "grlib-apbps2", |
| .of_match_table = apbps2_of_match, |
| }, |
| .probe = apbps2_of_probe, |
| .remove = apbps2_of_remove, |
| }; |
| |
| module_platform_driver(apbps2_of_driver); |
| |
| MODULE_AUTHOR("Aeroflex Gaisler AB."); |
| MODULE_DESCRIPTION("GRLIB APBPS2 PS/2 serial I/O"); |
| MODULE_LICENSE("GPL"); |