blob: e10b6eb955e1823bd5d1dc287c34dbbb1dbb6b27 [file] [log] [blame]
Flexcan CAN controller on Freescale's ARM and PowerPC system-on-a-chip (SOC).
Required properties:
- compatible : Should be "fsl,<processor>-flexcan"
where <processor> is imx8qm, imx6q, imx28, imx53, imx35, imx25, p1010,
vf610, ls1021ar2, lx2160ar1, ls1028ar1.
The ls1028ar1 must be followed by lx2160ar1, e.g.
- "fsl,ls1028ar1-flexcan", "fsl,lx2160ar1-flexcan"
An implementation should also claim any of the following compatibles
that it is fully backwards compatible with:
- fsl,p1010-flexcan
- reg : Offset and length of the register set for this device
- interrupts : Interrupt tuple for this device
Optional properties:
- clock-frequency : The oscillator frequency driving the flexcan device
- xceiver-supply: Regulator that powers the CAN transceiver
- big-endian: This means the registers of FlexCAN controller are big endian.
This is optional property.i.e. if this property is not present in
device tree node then controller is assumed to be little endian.
if this property is present then controller is assumed to be big
endian.
- fsl,stop-mode: register bits of stop mode control, the format is
<&gpr req_gpr req_bit>.
gpr is the phandle to general purpose register node.
req_gpr is the gpr register offset of CAN stop request.
req_bit is the bit offset of CAN stop request.
- fsl,clk-source: Select the clock source to the CAN Protocol Engine (PE).
It's SoC Implementation dependent. Refer to RM for detailed
definition. If this property is not set in device tree node
then driver selects clock source 1 by default.
0: clock source 0 (oscillator clock)
1: clock source 1 (peripheral clock)
- wakeup-source: enable CAN remote wakeup
Example:
can@1c000 {
compatible = "fsl,p1010-flexcan";
reg = <0x1c000 0x1000>;
interrupts = <48 0x2>;
interrupt-parent = <&mpic>;
clock-frequency = <200000000>; // filled in by bootloader
fsl,clk-source = <0>; // select clock source 0 for PE
};