| PXA3xx NAND DT bindings |
| |
| Required properties: |
| |
| - compatible: Should be set to one of the following: |
| marvell,pxa3xx-nand |
| marvell,armada370-nand |
| - reg: The register base for the controller |
| - interrupts: The interrupt to map |
| - #address-cells: Set to <1> if the node includes partitions |
| |
| Optional properties: |
| |
| - marvell,nand-enable-arbiter: Set to enable the bus arbiter |
| - marvell,nand-keep-config: Set to keep the NAND controller config as set |
| by the bootloader |
| - num-cs: Number of chipselect lines to use |
| - nand-on-flash-bbt: boolean to enable on flash bbt option if |
| not present false |
| - nand-ecc-strength: number of bits to correct per ECC step |
| - nand-ecc-step-size: number of data bytes covered by a single ECC step |
| |
| The following ECC strength and step size are currently supported: |
| |
| - nand-ecc-strength = <1>, nand-ecc-step-size = <512> |
| - nand-ecc-strength = <4>, nand-ecc-step-size = <512> |
| - nand-ecc-strength = <8>, nand-ecc-step-size = <512> |
| |
| Example: |
| |
| nand0: nand@43100000 { |
| compatible = "marvell,pxa3xx-nand"; |
| reg = <0x43100000 90>; |
| interrupts = <45>; |
| #address-cells = <1>; |
| |
| marvell,nand-enable-arbiter; |
| marvell,nand-keep-config; |
| num-cs = <1>; |
| |
| /* partitions (optional) */ |
| }; |
| |
