| Hisilicon Hip04 Soc NAND controller DT binding |
| |
| Required properties: |
| |
| - compatible: Should be "hisilicon,504-nfc". |
| - reg: The first contains base physical address and size of |
| NAND controller's registers. The second contains base |
| physical address and size of NAND controller's buffer. |
| - interrupts: Interrupt number for nfc. |
| - nand-bus-width: See nand-controller.yaml. |
| - nand-ecc-mode: Support none and hw ecc mode. |
| - #address-cells: Partition address, should be set 1. |
| - #size-cells: Partition size, should be set 1. |
| |
| Optional properties: |
| |
| - nand-ecc-strength: Number of bits to correct per ECC step. |
| - nand-ecc-step-size: Number of data bytes covered by a single ECC step. |
| |
| The following ECC strength and step size are currently supported: |
| |
| - nand-ecc-strength = <16>, nand-ecc-step-size = <1024> |
| |
| Flash chip may optionally contain additional sub-nodes describing partitions of |
| the address space. See partition.txt for more detail. |
| |
| Example: |
| |
| nand: nand@4020000 { |
| compatible = "hisilicon,504-nfc"; |
| reg = <0x4020000 0x10000>, <0x5000000 0x1000>; |
| interrupts = <0 379 4>; |
| nand-bus-width = <8>; |
| nand-ecc-mode = "hw"; |
| nand-ecc-strength = <16>; |
| nand-ecc-step-size = <1024>; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| |
| partition@0 { |
| label = "nand_text"; |
| reg = <0x00000000 0x00400000>; |
| }; |
| |
| ... |
| |
| }; |
