| * Dialog Semiconductor SLG51000 Voltage Regulator |
| |
| Required properties: |
| - compatible : Should be "dlg,slg51000" for SLG51000 |
| - reg : Specifies the I2C slave address. |
| - xxx-supply: Input voltage supply regulator for ldo3 to ldo7. |
| These entries are required if regulators are enabled for a device. |
| An absence of these properties can cause the regulator registration to fail. |
| If some of input supply is powered through battery or always-on supply then |
| also it is required to have these parameters with proper node handle of always |
| on power supply. |
| vin3-supply: Input supply for ldo3 |
| vin4-supply: Input supply for ldo4 |
| vin5-supply: Input supply for ldo5 |
| vin6-supply: Input supply for ldo6 |
| vin7-supply: Input supply for ldo7 |
| |
| Optional properties: |
| - interrupt-parent : Specifies the reference to the interrupt controller. |
| - interrupts : IRQ line information. |
| - dlg,cs-gpios : Specify a valid GPIO for chip select |
| |
| Sub-nodes: |
| - regulators : This node defines the settings for the regulators. |
| The content of the sub-node is defined by the standard binding |
| for regulators; see regulator.txt. |
| |
| The SLG51000 regulators are bound using their names listed below: |
| ldo1 |
| ldo2 |
| ldo3 |
| ldo4 |
| ldo5 |
| ldo6 |
| ldo7 |
| |
| Optional properties for regulators: |
| - enable-gpios : Specify a valid GPIO for platform control of the regulator. |
| |
| Example: |
| pmic: slg51000@75 { |
| compatible = "dlg,slg51000"; |
| reg = <0x75>; |
| |
| regulators { |
| ldo1 { |
| regulator-name = "ldo1"; |
| regulator-min-microvolt = <2400000>; |
| regulator-max-microvolt = <3300000>; |
| }; |
| |
| ldo2 { |
| regulator-name = "ldo2"; |
| regulator-min-microvolt = <2400000>; |
| regulator-max-microvolt = <3300000>; |
| }; |
| |
| ldo3 { |
| regulator-name = "ldo3"; |
| regulator-min-microvolt = <1200000>; |
| regulator-max-microvolt = <3750000>; |
| }; |
| |
| ldo4 { |
| regulator-name = "ldo4"; |
| regulator-min-microvolt = <1200000>; |
| regulator-max-microvolt = <3750000>; |
| }; |
| |
| ldo5 { |
| regulator-name = "ldo5"; |
| regulator-min-microvolt = <500000>; |
| regulator-max-microvolt = <1200000>; |
| }; |
| |
| ldo6 { |
| regulator-name = "ldo6"; |
| regulator-min-microvolt = <500000>; |
| regulator-max-microvolt = <1200000>; |
| }; |
| |
| ldo7 { |
| regulator-name = "ldo7"; |
| regulator-min-microvolt = <1200000>; |
| regulator-max-microvolt = <3750000>; |
| }; |
| }; |
| }; |
