Documentation/devicetree/bindings/serial/rs485.yaml

# SPDX-License-Identifier: GPL-2.0
%YAML 1.2
---
$id: http://devicetree.org/schemas/serial/rs485.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#

title: RS485 serial communications Bindings

description: The RTS signal is capable of automatically controlling line
  direction for the built-in half-duplex mode. The properties described
  hereafter shall be given to a half-duplex capable UART node.

maintainers:
  - Rob Herring <robh@kernel.org>

properties:
  rs485-rts-delay:
    description: prop-encoded-array <a b>
    $ref: /schemas/types.yaml#/definitions/uint32-array
    items:
      items:
        - description: Delay between rts signal and beginning of data sent in
            milliseconds. It corresponds to the delay before sending data.
          default: 0
          maximum: 1000
        - description: Delay between end of data sent and rts signal in milliseconds.
            It corresponds to the delay after sending data and actual release
            of the line.
          default: 0
          maximum: 1000

  rs485-rts-active-low:
    description: drive RTS low when sending (default is high).
    $ref: /schemas/types.yaml#/definitions/flag

  linux,rs485-enabled-at-boot-time:
    description: enables the rs485 feature at boot time. It can be disabled
      later with proper ioctl.
    $ref: /schemas/types.yaml#/definitions/flag

  rs485-rx-during-tx:
    description: enables the receiving of data even while sending data.
    $ref: /schemas/types.yaml#/definitions/flag

  rs485-term-gpios:
    description: GPIO pin to enable RS485 bus termination.
    maxItems: 1

additionalProperties: true

...