| What: /sys/class/power_supply/ltc4162-l/charge_status |
| Date: Januari 2021 |
| KernelVersion: 5.11 |
| Description: |
| Detailed charge status information as reported by the chip. |
| |
| Access: Read |
| |
| Valid values: |
| ilim_reg_active |
| thermal_reg_active |
| vin_uvcl_active |
| iin_limit_active |
| constant_current |
| constant_voltage |
| charger_off |
| |
| What: /sys/class/power_supply/ltc4162-l/ibat |
| Date: Januari 2021 |
| KernelVersion: 5.11 |
| Description: |
| Battery input current as measured by the charger. Negative value |
| means that the battery is discharging. |
| |
| Access: Read |
| |
| Valid values: Signed value in microamps |
| |
| What: /sys/class/power_supply/ltc4162-l/vbat |
| Date: Januari 2021 |
| KernelVersion: 5.11 |
| Description: |
| Battery voltage as measured by the charger. |
| |
| Access: Read |
| |
| Valid values: In microvolts |
| |
| What: /sys/class/power_supply/ltc4162-l/vbat_avg |
| Date: Januari 2021 |
| KernelVersion: 5.11 |
| Description: |
| Battery voltage, averaged over time, as measured by the charger. |
| |
| Access: Read |
| |
| Valid values: In microvolts |
| |
| What: /sys/class/power_supply/ltc4162-l/force_telemetry |
| Date: Januari 2021 |
| KernelVersion: 5.11 |
| Description: |
| To save battery current, the measurement system is disabled if |
| the battery is the only source of power. This affects all |
| voltage, current and temperature measurements. |
| Write a "1" to this to keep performing telemetry once every few |
| seconds, even when running on battery (as reported by the online |
| property, which is "1" when external power is available and "0" |
| when the system runs on battery). |
| |
| Access: Read, Write |
| |
| Valid values: 0 (disabled) or 1 (enabled) |
| |
| What: /sys/class/power_supply/ltc4162-l/arm_ship_mode |
| Date: Januari 2021 |
| KernelVersion: 5.11 |
| Description: |
| The charger will normally drain the battery while inactive, |
| typically drawing about 54 microamps. Write a "1" to this |
| property to arm a special "ship" mode that extends shelf life |
| by reducing the leakage to about 2.8 microamps. The chip will |
| remain in this mode (and no longer respond to I2C commands) |
| until some external power-supply is attached raising the input |
| voltage above 1V. It will then automatically revert to "0". |
| Writing a "0" to the property cancels the "ship" mode request. |
| The ship mode, when armed, activates once the input voltage |
| drops below 1V. |
| |
| Access: Read, Write |
| |
| Valid values: 0 (disable) or 1 (enable) |
