|  | /* | 
|  | * linux/arch/arm/mach-omap2/gpmc-smsc911x.c | 
|  | * | 
|  | * Copyright (C) 2009 Li-Pro.Net | 
|  | * Stephan Linz <linz@li-pro.net> | 
|  | * | 
|  | * Modified from linux/arch/arm/mach-omap2/gpmc-smc91x.c | 
|  | * | 
|  | * This program is free software; you can redistribute it and/or modify | 
|  | * it under the terms of the GNU General Public License version 2 as | 
|  | * published by the Free Software Foundation. | 
|  | */ | 
|  | #define pr_fmt(fmt) "%s: " fmt, __func__ | 
|  |  | 
|  | #include <linux/kernel.h> | 
|  | #include <linux/platform_device.h> | 
|  | #include <linux/gpio.h> | 
|  | #include <linux/delay.h> | 
|  | #include <linux/interrupt.h> | 
|  | #include <linux/io.h> | 
|  | #include <linux/smsc911x.h> | 
|  |  | 
|  | #include "gpmc.h" | 
|  | #include "gpmc-smsc911x.h" | 
|  |  | 
|  | static struct resource gpmc_smsc911x_resources[] = { | 
|  | [0] = { | 
|  | .flags		= IORESOURCE_MEM, | 
|  | }, | 
|  | [1] = { | 
|  | .flags		= IORESOURCE_IRQ | IORESOURCE_IRQ_LOWLEVEL, | 
|  | }, | 
|  | }; | 
|  |  | 
|  | static struct smsc911x_platform_config gpmc_smsc911x_config = { | 
|  | .phy_interface	= PHY_INTERFACE_MODE_MII, | 
|  | .irq_polarity	= SMSC911X_IRQ_POLARITY_ACTIVE_LOW, | 
|  | .irq_type	= SMSC911X_IRQ_TYPE_OPEN_DRAIN, | 
|  | }; | 
|  |  | 
|  | /* | 
|  | * Initialize smsc911x device connected to the GPMC. Note that we | 
|  | * assume that pin multiplexing is done in the board-*.c file, | 
|  | * or in the bootloader. | 
|  | */ | 
|  | void __init gpmc_smsc911x_init(struct omap_smsc911x_platform_data *gpmc_cfg) | 
|  | { | 
|  | struct platform_device *pdev; | 
|  | unsigned long cs_mem_base; | 
|  | int ret; | 
|  |  | 
|  | if (gpmc_cs_request(gpmc_cfg->cs, SZ_16M, &cs_mem_base) < 0) { | 
|  | pr_err("Failed to request GPMC mem region\n"); | 
|  | return; | 
|  | } | 
|  |  | 
|  | gpmc_smsc911x_resources[0].start = cs_mem_base + 0x0; | 
|  | gpmc_smsc911x_resources[0].end = cs_mem_base + 0xff; | 
|  |  | 
|  | if (gpio_request_one(gpmc_cfg->gpio_irq, GPIOF_IN, "smsc911x irq")) { | 
|  | pr_err("Failed to request IRQ GPIO%d\n", gpmc_cfg->gpio_irq); | 
|  | goto free1; | 
|  | } | 
|  |  | 
|  | gpmc_smsc911x_resources[1].start = gpio_to_irq(gpmc_cfg->gpio_irq); | 
|  |  | 
|  | if (gpio_is_valid(gpmc_cfg->gpio_reset)) { | 
|  | ret = gpio_request_one(gpmc_cfg->gpio_reset, | 
|  | GPIOF_OUT_INIT_HIGH, "smsc911x reset"); | 
|  | if (ret) { | 
|  | pr_err("Failed to request reset GPIO%d\n", | 
|  | gpmc_cfg->gpio_reset); | 
|  | goto free2; | 
|  | } | 
|  |  | 
|  | gpio_set_value(gpmc_cfg->gpio_reset, 0); | 
|  | msleep(100); | 
|  | gpio_set_value(gpmc_cfg->gpio_reset, 1); | 
|  | } | 
|  |  | 
|  | gpmc_smsc911x_config.flags = gpmc_cfg->flags ? : SMSC911X_USE_16BIT; | 
|  |  | 
|  | pdev = platform_device_register_resndata(NULL, "smsc911x", gpmc_cfg->id, | 
|  | gpmc_smsc911x_resources, ARRAY_SIZE(gpmc_smsc911x_resources), | 
|  | &gpmc_smsc911x_config, sizeof(gpmc_smsc911x_config)); | 
|  | if (IS_ERR(pdev)) { | 
|  | pr_err("Unable to register platform device\n"); | 
|  | gpio_free(gpmc_cfg->gpio_reset); | 
|  | goto free2; | 
|  | } | 
|  |  | 
|  | return; | 
|  |  | 
|  | free2: | 
|  | gpio_free(gpmc_cfg->gpio_irq); | 
|  | free1: | 
|  | gpmc_cs_free(gpmc_cfg->cs); | 
|  |  | 
|  | pr_err("Could not initialize smsc911x device\n"); | 
|  | } |