| /* |
| * arch/arm/mach-ep93xx/edb93xx.c |
| * Cirrus Logic EDB93xx Development Board support. |
| * |
| * EDB93XX, EDB9301, EDB9307A |
| * Copyright (C) 2008-2009 H Hartley Sweeten <hsweeten@visionengravers.com> |
| * |
| * EDB9302 |
| * Copyright (C) 2006 George Kashperko <george@chas.com.ua> |
| * |
| * EDB9302A, EDB9315, EDB9315A |
| * Copyright (C) 2006 Lennert Buytenhek <buytenh@wantstofly.org> |
| * |
| * EDB9307 |
| * Copyright (C) 2007 Herbert Valerio Riedel <hvr@gnu.org> |
| * |
| * EDB9312 |
| * Copyright (C) 2006 Infosys Technologies Limited |
| * Toufeeq Hussain <toufeeq_hussain@infosys.com> |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License as published by |
| * the Free Software Foundation; either version 2 of the License, or (at |
| * your option) any later version. |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/init.h> |
| #include <linux/platform_device.h> |
| #include <linux/mtd/physmap.h> |
| #include <linux/gpio.h> |
| #include <linux/i2c.h> |
| #include <linux/i2c-gpio.h> |
| |
| #include <mach/hardware.h> |
| |
| #include <asm/mach-types.h> |
| #include <asm/mach/arch.h> |
| |
| |
| static struct physmap_flash_data edb93xx_flash_data; |
| |
| static struct resource edb93xx_flash_resource = { |
| .flags = IORESOURCE_MEM, |
| }; |
| |
| static struct platform_device edb93xx_flash = { |
| .name = "physmap-flash", |
| .id = 0, |
| .dev = { |
| .platform_data = &edb93xx_flash_data, |
| }, |
| .num_resources = 1, |
| .resource = &edb93xx_flash_resource, |
| }; |
| |
| static void __init __edb93xx_register_flash(unsigned int width, |
| resource_size_t start, resource_size_t size) |
| { |
| edb93xx_flash_data.width = width; |
| edb93xx_flash_resource.start = start; |
| edb93xx_flash_resource.end = start + size - 1; |
| |
| platform_device_register(&edb93xx_flash); |
| } |
| |
| static void __init edb93xx_register_flash(void) |
| { |
| if (machine_is_edb9307() || machine_is_edb9312() || |
| machine_is_edb9315()) { |
| __edb93xx_register_flash(4, EP93XX_CS6_PHYS_BASE, SZ_32M); |
| } else { |
| __edb93xx_register_flash(2, EP93XX_CS6_PHYS_BASE, SZ_16M); |
| } |
| } |
| |
| static struct ep93xx_eth_data edb93xx_eth_data = { |
| .phy_id = 1, |
| }; |
| |
| |
| /************************************************************************* |
| * EDB93xx i2c peripheral handling |
| *************************************************************************/ |
| static struct i2c_gpio_platform_data edb93xx_i2c_gpio_data = { |
| .sda_pin = EP93XX_GPIO_LINE_EEDAT, |
| .sda_is_open_drain = 0, |
| .scl_pin = EP93XX_GPIO_LINE_EECLK, |
| .scl_is_open_drain = 0, |
| .udelay = 0, /* default to 100 kHz */ |
| .timeout = 0, /* default to 100 ms */ |
| }; |
| |
| static struct i2c_board_info __initdata edb93xxa_i2c_board_info[] = { |
| { |
| I2C_BOARD_INFO("isl1208", 0x6f), |
| }, |
| }; |
| |
| static struct i2c_board_info __initdata edb93xx_i2c_board_info[] = { |
| { |
| I2C_BOARD_INFO("ds1337", 0x68), |
| }, |
| }; |
| |
| static void __init edb93xx_register_i2c(void) |
| { |
| if (machine_is_edb9302a() || machine_is_edb9307a() || |
| machine_is_edb9315a()) { |
| ep93xx_register_i2c(&edb93xx_i2c_gpio_data, |
| edb93xxa_i2c_board_info, |
| ARRAY_SIZE(edb93xxa_i2c_board_info)); |
| } else if (machine_is_edb9307() || machine_is_edb9312() || |
| machine_is_edb9315()) { |
| ep93xx_register_i2c(&edb93xx_i2c_gpio_data, |
| edb93xx_i2c_board_info, |
| ARRAY_SIZE(edb93xx_i2c_board_info)); |
| } |
| } |
| |
| |
| /************************************************************************* |
| * EDB93xx pwm |
| *************************************************************************/ |
| static void __init edb93xx_register_pwm(void) |
| { |
| if (machine_is_edb9301() || |
| machine_is_edb9302() || machine_is_edb9302a()) { |
| /* EP9301 and EP9302 only have pwm.1 (EGPIO14) */ |
| ep93xx_register_pwm(0, 1); |
| } else if (machine_is_edb9307() || machine_is_edb9307a()) { |
| /* EP9307 only has pwm.0 (PWMOUT) */ |
| ep93xx_register_pwm(1, 0); |
| } else { |
| /* EP9312 and EP9315 have both */ |
| ep93xx_register_pwm(1, 1); |
| } |
| } |
| |
| |
| static void __init edb93xx_init_machine(void) |
| { |
| ep93xx_init_devices(); |
| edb93xx_register_flash(); |
| ep93xx_register_eth(&edb93xx_eth_data, 1); |
| edb93xx_register_i2c(); |
| edb93xx_register_pwm(); |
| } |
| |
| |
| #ifdef CONFIG_MACH_EDB9301 |
| MACHINE_START(EDB9301, "Cirrus Logic EDB9301 Evaluation Board") |
| /* Maintainer: H Hartley Sweeten <hsweeten@visionengravers.com> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE3_PHYS_BASE_SYNC + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
| |
| #ifdef CONFIG_MACH_EDB9302 |
| MACHINE_START(EDB9302, "Cirrus Logic EDB9302 Evaluation Board") |
| /* Maintainer: George Kashperko <george@chas.com.ua> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE3_PHYS_BASE_SYNC + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
| |
| #ifdef CONFIG_MACH_EDB9302A |
| MACHINE_START(EDB9302A, "Cirrus Logic EDB9302A Evaluation Board") |
| /* Maintainer: Lennert Buytenhek <buytenh@wantstofly.org> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE0_PHYS_BASE + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
| |
| #ifdef CONFIG_MACH_EDB9307 |
| MACHINE_START(EDB9307, "Cirrus Logic EDB9307 Evaluation Board") |
| /* Maintainer: Herbert Valerio Riedel <hvr@gnu.org> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE3_PHYS_BASE_SYNC + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
| |
| #ifdef CONFIG_MACH_EDB9307A |
| MACHINE_START(EDB9307A, "Cirrus Logic EDB9307A Evaluation Board") |
| /* Maintainer: H Hartley Sweeten <hsweeten@visionengravers.com> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE0_PHYS_BASE + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
| |
| #ifdef CONFIG_MACH_EDB9312 |
| MACHINE_START(EDB9312, "Cirrus Logic EDB9312 Evaluation Board") |
| /* Maintainer: Toufeeq Hussain <toufeeq_hussain@infosys.com> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE3_PHYS_BASE_SYNC + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
| |
| #ifdef CONFIG_MACH_EDB9315 |
| MACHINE_START(EDB9315, "Cirrus Logic EDB9315 Evaluation Board") |
| /* Maintainer: Lennert Buytenhek <buytenh@wantstofly.org> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE3_PHYS_BASE_SYNC + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
| |
| #ifdef CONFIG_MACH_EDB9315A |
| MACHINE_START(EDB9315A, "Cirrus Logic EDB9315A Evaluation Board") |
| /* Maintainer: Lennert Buytenhek <buytenh@wantstofly.org> */ |
| .phys_io = EP93XX_APB_PHYS_BASE, |
| .io_pg_offst = ((EP93XX_APB_VIRT_BASE) >> 18) & 0xfffc, |
| .boot_params = EP93XX_SDCE0_PHYS_BASE + 0x100, |
| .map_io = ep93xx_map_io, |
| .init_irq = ep93xx_init_irq, |
| .timer = &ep93xx_timer, |
| .init_machine = edb93xx_init_machine, |
| MACHINE_END |
| #endif |
