| Motorola CPCAP PMIC USB PHY binding |
| |
| Required properties: |
| compatible: Shall be either "motorola,cpcap-usb-phy" or |
| "motorola,mapphone-cpcap-usb-phy" |
| #phy-cells: Shall be 0 |
| interrupts: CPCAP PMIC interrupts used by the USB PHY |
| interrupt-names: Interrupt names |
| io-channels: IIO ADC channels used by the USB PHY |
| io-channel-names: IIO ADC channel names |
| vusb-supply: Regulator for the PHY |
| |
| Optional properties: |
| pinctrl: Optional alternate pin modes for the PHY |
| pinctrl-names: Names for optional pin modes |
| mode-gpios: Optional GPIOs for configuring alternate modes |
| |
| Example: |
| cpcap_usb2_phy: phy { |
| compatible = "motorola,mapphone-cpcap-usb-phy"; |
| pinctrl-0 = <&usb_gpio_mux_sel1 &usb_gpio_mux_sel2>; |
| pinctrl-1 = <&usb_ulpi_pins>; |
| pinctrl-2 = <&usb_utmi_pins>; |
| pinctrl-3 = <&uart3_pins>; |
| pinctrl-names = "default", "ulpi", "utmi", "uart"; |
| #phy-cells = <0>; |
| interrupts-extended = < |
| &cpcap 15 0 &cpcap 14 0 &cpcap 28 0 &cpcap 19 0 |
| &cpcap 18 0 &cpcap 17 0 &cpcap 16 0 &cpcap 49 0 |
| &cpcap 48 1 |
| >; |
| interrupt-names = |
| "id_ground", "id_float", "se0conn", "vbusvld", |
| "sessvld", "sessend", "se1", "dm", "dp"; |
| mode-gpios = <&gpio2 28 GPIO_ACTIVE_HIGH |
| &gpio1 0 GPIO_ACTIVE_HIGH>; |
| io-channels = <&cpcap_adc 2>, <&cpcap_adc 7>; |
| io-channel-names = "vbus", "id"; |
| vusb-supply = <&vusb>; |
| }; |
