| Simple display panel |
| ==================== |
| |
| panel node |
| ---------- |
| |
| Required properties: |
| - power-supply: See panel-common.txt |
| |
| Optional properties: |
| - ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing |
| - enable-gpios: GPIO pin to enable or disable the panel |
| - backlight: phandle of the backlight device attached to the panel |
| - no-hpd: This panel is supposed to communicate that it's ready via HPD |
| (hot plug detect) signal, but the signal isn't hooked up so we should |
| hardcode the max delay from the panel spec when powering up the panel. |
| |
| Example: |
| |
| panel: panel { |
| compatible = "cptt,claa101wb01"; |
| ddc-i2c-bus = <&panelddc>; |
| |
| power-supply = <&vdd_pnl_reg>; |
| enable-gpios = <&gpio 90 0>; |
| |
| backlight = <&backlight>; |
| }; |
