| // SPDX-License-Identifier: GPL-2.0 |
| /* |
| * Driver for the NXP ISP1760 chip |
| * |
| * Copyright 2014 Laurent Pinchart |
| * Copyright 2007 Sebastian Siewior |
| * |
| * Contacts: |
| * Sebastian Siewior <bigeasy@linutronix.de> |
| * Laurent Pinchart <laurent.pinchart@ideasonboard.com> |
| */ |
| |
| #ifndef _ISP1760_CORE_H_ |
| #define _ISP1760_CORE_H_ |
| |
| #include <linux/ioport.h> |
| |
| #include "isp1760-hcd.h" |
| #include "isp1760-udc.h" |
| |
| struct device; |
| struct gpio_desc; |
| |
| /* |
| * Device flags that can vary from board to board. All of these |
| * indicate the most "atypical" case, so that a devflags of 0 is |
| * a sane default configuration. |
| */ |
| #define ISP1760_FLAG_BUS_WIDTH_16 0x00000002 /* 16-bit data bus width */ |
| #define ISP1760_FLAG_OTG_EN 0x00000004 /* Port 1 supports OTG */ |
| #define ISP1760_FLAG_ANALOG_OC 0x00000008 /* Analog overcurrent */ |
| #define ISP1760_FLAG_DACK_POL_HIGH 0x00000010 /* DACK active high */ |
| #define ISP1760_FLAG_DREQ_POL_HIGH 0x00000020 /* DREQ active high */ |
| #define ISP1760_FLAG_ISP1761 0x00000040 /* Chip is ISP1761 */ |
| #define ISP1760_FLAG_INTR_POL_HIGH 0x00000080 /* Interrupt polarity active high */ |
| #define ISP1760_FLAG_INTR_EDGE_TRIG 0x00000100 /* Interrupt edge triggered */ |
| |
| struct isp1760_device { |
| struct device *dev; |
| |
| void __iomem *regs; |
| unsigned int devflags; |
| struct gpio_desc *rst_gpio; |
| |
| struct isp1760_hcd hcd; |
| struct isp1760_udc udc; |
| }; |
| |
| int isp1760_register(struct resource *mem, int irq, unsigned long irqflags, |
| struct device *dev, unsigned int devflags); |
| void isp1760_unregister(struct device *dev); |
| |
| void isp1760_set_pullup(struct isp1760_device *isp, bool enable); |
| |
| static inline u32 isp1760_read32(void __iomem *base, u32 reg) |
| { |
| return readl(base + reg); |
| } |
| |
| static inline void isp1760_write32(void __iomem *base, u32 reg, u32 val) |
| { |
| writel(val, base + reg); |
| } |
| |
| #endif |