| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * Copyright (C) 2017 Texas Instruments Incorporated - https://www.ti.com/ |
| */ |
| |
| #include "dra74x.dtsi" |
| |
| / { |
| compatible = "ti,dra762", "ti,dra7"; |
| |
| ocp { |
| target-module@42c01900 { |
| compatible = "ti,sysc-dra7-mcan", "ti,sysc"; |
| ranges = <0x0 0x42c00000 0x2000>; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| reg = <0x42c01900 0x4>, |
| <0x42c01904 0x4>, |
| <0x42c01908 0x4>; |
| reg-names = "rev", "sysc", "syss"; |
| ti,sysc-mask = <(SYSC_OMAP4_SOFTRESET | |
| SYSC_DRA7_MCAN_ENAWAKEUP)>; |
| ti,syss-mask = <1>; |
| clocks = <&wkupaon_clkctrl DRA7_WKUPAON_ADC_CLKCTRL 0>; |
| clock-names = "fck"; |
| |
| m_can0: mcan@1a00 { |
| compatible = "bosch,m_can"; |
| reg = <0x1a00 0x4000>, <0x0 0x18FC>; |
| reg-names = "m_can", "message_ram"; |
| interrupt-parent = <&gic>; |
| interrupts = <GIC_SPI 67 IRQ_TYPE_LEVEL_HIGH>, |
| <GIC_SPI 68 IRQ_TYPE_LEVEL_HIGH>; |
| interrupt-names = "int0", "int1"; |
| clocks = <&l3_iclk_div>, <&mcan_clk>; |
| clock-names = "hclk", "cclk"; |
| bosch,mram-cfg = <0x0 0 0 32 0 0 1 1>; |
| }; |
| }; |
| }; |
| |
| }; |
| |
| &l4_per3 { |
| target-module@1b0000 { /* 0x489b0000, ap 25 34.0 */ |
| compatible = "ti,sysc-omap4", "ti,sysc"; |
| reg = <0x1b0000 0x4>, |
| <0x1b0010 0x4>; |
| reg-names = "rev", "sysc"; |
| ti,sysc-midle = <SYSC_IDLE_FORCE>, |
| <SYSC_IDLE_NO>; |
| ti,sysc-sidle = <SYSC_IDLE_FORCE>, |
| <SYSC_IDLE_NO>; |
| clocks = <&cam_clkctrl DRA7_CAM_VIP3_CLKCTRL 0>; |
| clock-names = "fck"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| ranges = <0x0 0x1b0000 0x10000>; |
| |
| cal: cal@0 { |
| compatible = "ti,dra76-cal"; |
| reg = <0x0000 0x400>, |
| <0x0800 0x40>, |
| <0x0900 0x40>; |
| reg-names = "cal_top", |
| "cal_rx_core0", |
| "cal_rx_core1"; |
| interrupts = <GIC_SPI 353 IRQ_TYPE_LEVEL_HIGH>; |
| ti,camerrx-control = <&scm_conf 0x6dc>; |
| |
| ports { |
| #address-cells = <1>; |
| #size-cells = <0>; |
| |
| csi2_0: port@0 { |
| reg = <0>; |
| }; |
| csi2_1: port@1 { |
| reg = <1>; |
| }; |
| }; |
| }; |
| }; |
| }; |
| |
| &scm_conf_clocks { |
| dpll_gmac_h14x2_ctrl_ck: dpll_gmac_h14x2_ctrl_ck@3fc { |
| #clock-cells = <0>; |
| compatible = "ti,divider-clock"; |
| clocks = <&dpll_gmac_x2_ck>; |
| ti,max-div = <63>; |
| reg = <0x03fc>; |
| ti,bit-shift=<20>; |
| ti,latch-bit=<26>; |
| assigned-clocks = <&dpll_gmac_h14x2_ctrl_ck>; |
| assigned-clock-rates = <80000000>; |
| }; |
| |
| dpll_gmac_h14x2_ctrl_mux_ck: dpll_gmac_h14x2_ctrl_mux_ck@3fc { |
| #clock-cells = <0>; |
| compatible = "ti,mux-clock"; |
| clocks = <&dpll_gmac_ck>, <&dpll_gmac_h14x2_ctrl_ck>; |
| reg = <0x3fc>; |
| ti,bit-shift = <29>; |
| ti,latch-bit=<26>; |
| assigned-clocks = <&dpll_gmac_h14x2_ctrl_mux_ck>; |
| assigned-clock-parents = <&dpll_gmac_h14x2_ctrl_ck>; |
| }; |
| |
| mcan_clk: mcan_clk@3fc { |
| #clock-cells = <0>; |
| compatible = "ti,gate-clock"; |
| clocks = <&dpll_gmac_h14x2_ctrl_mux_ck>; |
| ti,bit-shift = <27>; |
| reg = <0x3fc>; |
| }; |
| }; |
| |
| &rtctarget { |
| status = "disabled"; |
| }; |
| |
| &usb4_tm { |
| status = "disabled"; |
| }; |
| |
| &mmc3 { |
| /* dra76x is not affected by i887 */ |
| max-frequency = <96000000>; |
| }; |
| |
| &cpu0_opp_table { |
| opp_plus@1800000000 { |
| opp-hz = /bits/ 64 <1800000000>; |
| opp-microvolt = <1250000 950000 1250000>, |
| <1250000 950000 1250000>; |
| opp-supported-hw = <0xFF 0x08>; |
| }; |
| }; |
| |
| &opp_supply_mpu { |
| ti,efuse-settings = < |
| /* uV offset */ |
| 1060000 0x0 |
| 1160000 0x4 |
| 1210000 0x8 |
| 1250000 0xC |
| >; |
| }; |
| |
| &abb_mpu { |
| ti,abb_info = < |
| /*uV ABB efuse rbb_m fbb_m vset_m*/ |
| 1060000 0 0x0 0 0x02000000 0x01F00000 |
| 1160000 0 0x4 0 0x02000000 0x01F00000 |
| 1210000 0 0x8 0 0x02000000 0x01F00000 |
| 1250000 0 0xC 0 0x02000000 0x01F00000 |
| >; |
| }; |