| // SPDX-License-Identifier: GPL-2.0+ |
| |
| #include <linux/module.h> |
| #include <linux/phylink.h> |
| #include <linux/device.h> |
| #include <linux/netdevice.h> |
| #include <linux/phy/phy.h> |
| |
| #include "lan966x_main.h" |
| |
| static struct phylink_pcs *lan966x_phylink_mac_select(struct phylink_config *config, |
| phy_interface_t interface) |
| { |
| struct lan966x_port *port = netdev_priv(to_net_dev(config->dev)); |
| |
| return &port->phylink_pcs; |
| } |
| |
| static void lan966x_phylink_mac_config(struct phylink_config *config, |
| unsigned int mode, |
| const struct phylink_link_state *state) |
| { |
| } |
| |
| static int lan966x_phylink_mac_prepare(struct phylink_config *config, |
| unsigned int mode, |
| phy_interface_t iface) |
| { |
| struct lan966x_port *port = netdev_priv(to_net_dev(config->dev)); |
| phy_interface_t serdes_mode = iface; |
| int err; |
| |
| if (port->serdes) { |
| err = phy_set_mode_ext(port->serdes, PHY_MODE_ETHERNET, |
| serdes_mode); |
| if (err) { |
| netdev_err(to_net_dev(config->dev), |
| "Could not set mode of SerDes\n"); |
| return err; |
| } |
| } |
| |
| return 0; |
| } |
| |
| static void lan966x_phylink_mac_link_up(struct phylink_config *config, |
| struct phy_device *phy, |
| unsigned int mode, |
| phy_interface_t interface, |
| int speed, int duplex, |
| bool tx_pause, bool rx_pause) |
| { |
| struct lan966x_port *port = netdev_priv(to_net_dev(config->dev)); |
| struct lan966x_port_config *port_config = &port->config; |
| |
| port_config->duplex = duplex; |
| port_config->speed = speed; |
| port_config->pause = 0; |
| port_config->pause |= tx_pause ? MLO_PAUSE_TX : 0; |
| port_config->pause |= rx_pause ? MLO_PAUSE_RX : 0; |
| |
| if (phy_interface_mode_is_rgmii(interface)) |
| phy_set_speed(port->serdes, speed); |
| |
| lan966x_port_config_up(port); |
| } |
| |
| static void lan966x_phylink_mac_link_down(struct phylink_config *config, |
| unsigned int mode, |
| phy_interface_t interface) |
| { |
| struct lan966x_port *port = netdev_priv(to_net_dev(config->dev)); |
| struct lan966x *lan966x = port->lan966x; |
| |
| lan966x_port_config_down(port); |
| |
| /* Take PCS out of reset */ |
| lan_rmw(DEV_CLOCK_CFG_PCS_RX_RST_SET(0) | |
| DEV_CLOCK_CFG_PCS_TX_RST_SET(0), |
| DEV_CLOCK_CFG_PCS_RX_RST | |
| DEV_CLOCK_CFG_PCS_TX_RST, |
| lan966x, DEV_CLOCK_CFG(port->chip_port)); |
| } |
| |
| static struct lan966x_port *lan966x_pcs_to_port(struct phylink_pcs *pcs) |
| { |
| return container_of(pcs, struct lan966x_port, phylink_pcs); |
| } |
| |
| static void lan966x_pcs_get_state(struct phylink_pcs *pcs, |
| struct phylink_link_state *state) |
| { |
| struct lan966x_port *port = lan966x_pcs_to_port(pcs); |
| |
| lan966x_port_status_get(port, state); |
| } |
| |
| static int lan966x_pcs_config(struct phylink_pcs *pcs, unsigned int neg_mode, |
| phy_interface_t interface, |
| const unsigned long *advertising, |
| bool permit_pause_to_mac) |
| { |
| struct lan966x_port *port = lan966x_pcs_to_port(pcs); |
| struct lan966x_port_config config; |
| int ret; |
| |
| config = port->config; |
| config.portmode = interface; |
| config.inband = neg_mode & PHYLINK_PCS_NEG_INBAND; |
| config.autoneg = neg_mode == PHYLINK_PCS_NEG_INBAND_ENABLED; |
| config.advertising = advertising; |
| |
| ret = lan966x_port_pcs_set(port, &config); |
| if (ret) |
| netdev_err(port->dev, "port PCS config failed: %d\n", ret); |
| |
| return ret; |
| } |
| |
| static void lan966x_pcs_aneg_restart(struct phylink_pcs *pcs) |
| { |
| /* Currently not used */ |
| } |
| |
| const struct phylink_mac_ops lan966x_phylink_mac_ops = { |
| .mac_select_pcs = lan966x_phylink_mac_select, |
| .mac_config = lan966x_phylink_mac_config, |
| .mac_prepare = lan966x_phylink_mac_prepare, |
| .mac_link_down = lan966x_phylink_mac_link_down, |
| .mac_link_up = lan966x_phylink_mac_link_up, |
| }; |
| |
| const struct phylink_pcs_ops lan966x_phylink_pcs_ops = { |
| .pcs_get_state = lan966x_pcs_get_state, |
| .pcs_config = lan966x_pcs_config, |
| .pcs_an_restart = lan966x_pcs_aneg_restart, |
| }; |