blob: 3eb55dcfa8a61e731b68f289299dcd3719f3ce51 [file] [log] [blame]
# SPDX-License-Identifier: GPL-2.0-only
#
# Solarflare device configuration
#
config NET_VENDOR_SOLARFLARE
bool "Solarflare devices"
default y
help
If you have a network (Ethernet) card belonging to this class, say Y.
Note that the answer to this question doesn't directly affect the
kernel: saying N will just cause the configurator to skip all
the questions about Solarflare devices. If you say Y, you will be asked
for your specific card in the following questions.
if NET_VENDOR_SOLARFLARE
config SFC
tristate "Solarflare SFC9100/EF100-family support"
depends on PCI
depends on PTP_1588_CLOCK_OPTIONAL
select MDIO
select CRC32
select NET_DEVLINK
help
This driver supports 10/40-gigabit Ethernet cards based on
the Solarflare SFC9100-family controllers.
It also supports 10/25/40/100-gigabit Ethernet cards based
on the Solarflare EF100 networking IP in Xilinx FPGAs.
To compile this driver as a module, choose M here. The module
will be called sfc.
config SFC_MTD
bool "Solarflare SFC9100-family MTD support"
depends on SFC && MTD && !(SFC=y && MTD=m)
default y
help
This exposes the on-board flash and/or EEPROM as MTD devices
(e.g. /dev/mtd1). This is required to update the firmware or
the boot configuration under Linux.
config SFC_MCDI_MON
bool "Solarflare SFC9100-family hwmon support"
depends on SFC && HWMON && !(SFC=y && HWMON=m)
default y
help
This exposes the on-board firmware-managed sensors as a
hardware monitor device.
config SFC_SRIOV
bool "Solarflare SFC9100-family SR-IOV support"
depends on SFC && PCI_IOV
depends on INET
default y
help
This enables support for the Single Root I/O Virtualization
features, allowing accelerated network performance in
virtualized environments.
config SFC_MCDI_LOGGING
bool "Solarflare SFC9100-family MCDI logging support"
depends on SFC
default y
help
This enables support for tracing of MCDI (Management-Controller-to-
Driver-Interface) commands and responses, allowing debugging of
driver/firmware interaction. The tracing is actually enabled by
a sysfs file 'mcdi_logging' under the PCI device.
source "drivers/net/ethernet/sfc/falcon/Kconfig"
source "drivers/net/ethernet/sfc/siena/Kconfig"
endif # NET_VENDOR_SOLARFLARE