| // SPDX-License-Identifier: GPL-2.0-or-later |
| /* |
| * SDHCI support for SiRF primaII and marco SoCs |
| * |
| * Copyright (c) 2011 Cambridge Silicon Radio Limited, a CSR plc group company. |
| */ |
| |
| #include <linux/delay.h> |
| #include <linux/device.h> |
| #include <linux/mmc/host.h> |
| #include <linux/module.h> |
| #include <linux/of.h> |
| #include <linux/mmc/slot-gpio.h> |
| #include "sdhci-pltfm.h" |
| |
| #define SDHCI_CLK_DELAY_SETTING 0x4C |
| #define SDHCI_SIRF_8BITBUS BIT(3) |
| #define SIRF_TUNING_COUNT 16384 |
| |
| static void sdhci_sirf_set_bus_width(struct sdhci_host *host, int width) |
| { |
| u8 ctrl; |
| |
| ctrl = sdhci_readb(host, SDHCI_HOST_CONTROL); |
| ctrl &= ~(SDHCI_CTRL_4BITBUS | SDHCI_SIRF_8BITBUS); |
| |
| /* |
| * CSR atlas7 and prima2 SD host version is not 3.0 |
| * 8bit-width enable bit of CSR SD hosts is 3, |
| * while stardard hosts use bit 5 |
| */ |
| if (width == MMC_BUS_WIDTH_8) |
| ctrl |= SDHCI_SIRF_8BITBUS; |
| else if (width == MMC_BUS_WIDTH_4) |
| ctrl |= SDHCI_CTRL_4BITBUS; |
| |
| sdhci_writeb(host, ctrl, SDHCI_HOST_CONTROL); |
| } |
| |
| static u32 sdhci_sirf_readl_le(struct sdhci_host *host, int reg) |
| { |
| u32 val = readl(host->ioaddr + reg); |
| |
| if (unlikely((reg == SDHCI_CAPABILITIES_1) && |
| (host->mmc->caps & MMC_CAP_UHS_SDR50))) { |
| /* fake CAP_1 register */ |
| val = SDHCI_SUPPORT_DDR50 | |
| SDHCI_SUPPORT_SDR50 | SDHCI_USE_SDR50_TUNING; |
| } |
| |
| if (unlikely(reg == SDHCI_SLOT_INT_STATUS)) { |
| u32 prss = val; |
| /* fake chips as V3.0 host conreoller */ |
| prss &= ~(0xFF << 16); |
| val = prss | (SDHCI_SPEC_300 << 16); |
| } |
| return val; |
| } |
| |
| static u16 sdhci_sirf_readw_le(struct sdhci_host *host, int reg) |
| { |
| u16 ret = 0; |
| |
| ret = readw(host->ioaddr + reg); |
| |
| if (unlikely(reg == SDHCI_HOST_VERSION)) { |
| ret = readw(host->ioaddr + SDHCI_HOST_VERSION); |
| ret |= SDHCI_SPEC_300; |
| } |
| |
| return ret; |
| } |
| |
| static int sdhci_sirf_execute_tuning(struct sdhci_host *host, u32 opcode) |
| { |
| int tuning_seq_cnt = 3; |
| int phase; |
| u8 tuned_phase_cnt = 0; |
| int rc = 0, longest_range = 0; |
| int start = -1, end = 0, tuning_value = -1, range = 0; |
| u16 clock_setting; |
| struct mmc_host *mmc = host->mmc; |
| |
| clock_setting = sdhci_readw(host, SDHCI_CLK_DELAY_SETTING); |
| clock_setting &= ~0x3fff; |
| |
| retry: |
| phase = 0; |
| tuned_phase_cnt = 0; |
| do { |
| sdhci_writel(host, |
| clock_setting | phase, |
| SDHCI_CLK_DELAY_SETTING); |
| |
| if (!mmc_send_tuning(mmc, opcode, NULL)) { |
| /* Tuning is successful at this tuning point */ |
| tuned_phase_cnt++; |
| dev_dbg(mmc_dev(mmc), "%s: Found good phase = %d\n", |
| mmc_hostname(mmc), phase); |
| if (start == -1) |
| start = phase; |
| end = phase; |
| range++; |
| if (phase == (SIRF_TUNING_COUNT - 1) |
| && range > longest_range) |
| tuning_value = (start + end) / 2; |
| } else { |
| dev_dbg(mmc_dev(mmc), "%s: Found bad phase = %d\n", |
| mmc_hostname(mmc), phase); |
| if (range > longest_range) { |
| tuning_value = (start + end) / 2; |
| longest_range = range; |
| } |
| start = -1; |
| end = range = 0; |
| } |
| } while (++phase < SIRF_TUNING_COUNT); |
| |
| if (tuned_phase_cnt && tuning_value > 0) { |
| /* |
| * Finally set the selected phase in delay |
| * line hw block. |
| */ |
| phase = tuning_value; |
| sdhci_writel(host, |
| clock_setting | phase, |
| SDHCI_CLK_DELAY_SETTING); |
| |
| dev_dbg(mmc_dev(mmc), "%s: Setting the tuning phase to %d\n", |
| mmc_hostname(mmc), phase); |
| } else { |
| if (--tuning_seq_cnt) |
| goto retry; |
| /* Tuning failed */ |
| dev_dbg(mmc_dev(mmc), "%s: No tuning point found\n", |
| mmc_hostname(mmc)); |
| rc = -EIO; |
| } |
| |
| return rc; |
| } |
| |
| static const struct sdhci_ops sdhci_sirf_ops = { |
| .read_l = sdhci_sirf_readl_le, |
| .read_w = sdhci_sirf_readw_le, |
| .platform_execute_tuning = sdhci_sirf_execute_tuning, |
| .set_clock = sdhci_set_clock, |
| .get_max_clock = sdhci_pltfm_clk_get_max_clock, |
| .set_bus_width = sdhci_sirf_set_bus_width, |
| .reset = sdhci_reset, |
| .set_uhs_signaling = sdhci_set_uhs_signaling, |
| }; |
| |
| static const struct sdhci_pltfm_data sdhci_sirf_pdata = { |
| .ops = &sdhci_sirf_ops, |
| .quirks = SDHCI_QUIRK_BROKEN_TIMEOUT_VAL | |
| SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK | |
| SDHCI_QUIRK_CAP_CLOCK_BASE_BROKEN | |
| SDHCI_QUIRK_RESET_CMD_DATA_ON_IOS, |
| .quirks2 = SDHCI_QUIRK2_PRESET_VALUE_BROKEN, |
| }; |
| |
| static int sdhci_sirf_probe(struct platform_device *pdev) |
| { |
| struct sdhci_host *host; |
| struct sdhci_pltfm_host *pltfm_host; |
| struct clk *clk; |
| int ret; |
| |
| clk = devm_clk_get(&pdev->dev, NULL); |
| if (IS_ERR(clk)) { |
| dev_err(&pdev->dev, "unable to get clock"); |
| return PTR_ERR(clk); |
| } |
| |
| host = sdhci_pltfm_init(pdev, &sdhci_sirf_pdata, 0); |
| if (IS_ERR(host)) |
| return PTR_ERR(host); |
| |
| pltfm_host = sdhci_priv(host); |
| pltfm_host->clk = clk; |
| |
| sdhci_get_of_property(pdev); |
| |
| ret = clk_prepare_enable(pltfm_host->clk); |
| if (ret) |
| goto err_clk_prepare; |
| |
| ret = sdhci_add_host(host); |
| if (ret) |
| goto err_sdhci_add; |
| |
| /* |
| * We must request the IRQ after sdhci_add_host(), as the tasklet only |
| * gets setup in sdhci_add_host() and we oops. |
| */ |
| ret = mmc_gpiod_request_cd(host->mmc, "cd", 0, false, 0, NULL); |
| if (ret == -EPROBE_DEFER) |
| goto err_request_cd; |
| if (!ret) |
| mmc_gpiod_request_cd_irq(host->mmc); |
| |
| return 0; |
| |
| err_request_cd: |
| sdhci_remove_host(host, 0); |
| err_sdhci_add: |
| clk_disable_unprepare(pltfm_host->clk); |
| err_clk_prepare: |
| sdhci_pltfm_free(pdev); |
| return ret; |
| } |
| |
| static const struct of_device_id sdhci_sirf_of_match[] = { |
| { .compatible = "sirf,prima2-sdhc" }, |
| { } |
| }; |
| MODULE_DEVICE_TABLE(of, sdhci_sirf_of_match); |
| |
| static struct platform_driver sdhci_sirf_driver = { |
| .driver = { |
| .name = "sdhci-sirf", |
| .of_match_table = sdhci_sirf_of_match, |
| .pm = &sdhci_pltfm_pmops, |
| }, |
| .probe = sdhci_sirf_probe, |
| .remove = sdhci_pltfm_unregister, |
| }; |
| |
| module_platform_driver(sdhci_sirf_driver); |
| |
| MODULE_DESCRIPTION("SDHCI driver for SiRFprimaII/SiRFmarco"); |
| MODULE_AUTHOR("Barry Song <21cnbao@gmail.com>"); |
| MODULE_LICENSE("GPL v2"); |