blob: 7775c5edaeefd464ead77e9ced917b89f576feea [file] [log] [blame]
/* SPDX-License-Identifier: GPL-2.0 */
#ifndef _BMC150_ACCEL_H_
#define _BMC150_ACCEL_H_
#include <linux/atomic.h>
#include <linux/iio/iio.h>
#include <linux/mutex.h>
#include <linux/regulator/consumer.h>
#include <linux/workqueue.h>
struct regmap;
struct i2c_client;
struct bmc150_accel_chip_info;
struct bmc150_accel_interrupt_info;
* We can often guess better than "UNKNOWN" based on the device IDs
* but unfortunately this information is not always accurate. There are some
* devices where ACPI firmware specifies an ID like "BMA250E" when the device
* actually has a BMA222E. The driver attempts to detect those by reading the
* chip ID from the registers but this information is not always enough either.
* Therefore, this enum should be only used when the chip ID detection is not
* enough and we can be reasonably sure that the device IDs are reliable
* in practice (e.g. for device tree platforms).
enum bmc150_type {
struct bmc150_accel_interrupt {
const struct bmc150_accel_interrupt_info *info;
atomic_t users;
struct bmc150_accel_trigger {
struct bmc150_accel_data *data;
struct iio_trigger *indio_trig;
int (*setup)(struct bmc150_accel_trigger *t, bool state);
int intr;
bool enabled;
enum bmc150_accel_interrupt_id {
enum bmc150_accel_trigger_id {
struct bmc150_accel_data {
struct regmap *regmap;
struct regulator_bulk_data regulators[2];
struct bmc150_accel_interrupt interrupts[BMC150_ACCEL_INTERRUPTS];
struct bmc150_accel_trigger triggers[BMC150_ACCEL_TRIGGERS];
struct mutex mutex;
u8 fifo_mode, watermark;
s16 buffer[8];
* Ensure there is sufficient space and correct alignment for
* the timestamp if enabled
struct {
__le16 channels[3];
s64 ts __aligned(8);
} scan;
u8 bw_bits;
u32 slope_dur;
u32 slope_thres;
u32 range;
int ev_enable_state;
int64_t timestamp, old_timestamp; /* Only used in hw fifo mode. */
const struct bmc150_accel_chip_info *chip_info;
enum bmc150_type type;
struct i2c_client *second_device;
void (*resume_callback)(struct device *dev);
struct delayed_work resume_work;
struct iio_mount_matrix orientation;
int bmc150_accel_core_probe(struct device *dev, struct regmap *regmap, int irq,
enum bmc150_type type, const char *name,
bool block_supported);
void bmc150_accel_core_remove(struct device *dev);
extern const struct dev_pm_ops bmc150_accel_pm_ops;
extern const struct regmap_config bmc150_regmap_conf;
#endif /* _BMC150_ACCEL_H_ */