| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * Dove thermal sensor driver |
| * |
| * Copyright (C) 2013 Andrew Lunn <andrew@lunn.ch> |
| */ |
| #include <linux/device.h> |
| #include <linux/err.h> |
| #include <linux/io.h> |
| #include <linux/kernel.h> |
| #include <linux/of.h> |
| #include <linux/module.h> |
| #include <linux/platform_device.h> |
| #include <linux/thermal.h> |
| |
| #define DOVE_THERMAL_TEMP_OFFSET 1 |
| #define DOVE_THERMAL_TEMP_MASK 0x1FF |
| |
| /* Dove Thermal Manager Control and Status Register */ |
| #define PMU_TM_DISABLE_OFFS 0 |
| #define PMU_TM_DISABLE_MASK (0x1 << PMU_TM_DISABLE_OFFS) |
| |
| /* Dove Theraml Diode Control 0 Register */ |
| #define PMU_TDC0_SW_RST_MASK (0x1 << 1) |
| #define PMU_TDC0_SEL_VCAL_OFFS 5 |
| #define PMU_TDC0_SEL_VCAL_MASK (0x3 << PMU_TDC0_SEL_VCAL_OFFS) |
| #define PMU_TDC0_REF_CAL_CNT_OFFS 11 |
| #define PMU_TDC0_REF_CAL_CNT_MASK (0x1FF << PMU_TDC0_REF_CAL_CNT_OFFS) |
| #define PMU_TDC0_AVG_NUM_OFFS 25 |
| #define PMU_TDC0_AVG_NUM_MASK (0x7 << PMU_TDC0_AVG_NUM_OFFS) |
| |
| /* Dove Thermal Diode Control 1 Register */ |
| #define PMU_TEMP_DIOD_CTRL1_REG 0x04 |
| #define PMU_TDC1_TEMP_VALID_MASK (0x1 << 10) |
| |
| /* Dove Thermal Sensor Dev Structure */ |
| struct dove_thermal_priv { |
| void __iomem *sensor; |
| void __iomem *control; |
| }; |
| |
| static int dove_init_sensor(const struct dove_thermal_priv *priv) |
| { |
| u32 reg; |
| u32 i; |
| |
| /* Configure the Diode Control Register #0 */ |
| reg = readl_relaxed(priv->control); |
| |
| /* Use average of 2 */ |
| reg &= ~PMU_TDC0_AVG_NUM_MASK; |
| reg |= (0x1 << PMU_TDC0_AVG_NUM_OFFS); |
| |
| /* Reference calibration value */ |
| reg &= ~PMU_TDC0_REF_CAL_CNT_MASK; |
| reg |= (0x0F1 << PMU_TDC0_REF_CAL_CNT_OFFS); |
| |
| /* Set the high level reference for calibration */ |
| reg &= ~PMU_TDC0_SEL_VCAL_MASK; |
| reg |= (0x2 << PMU_TDC0_SEL_VCAL_OFFS); |
| writel(reg, priv->control); |
| |
| /* Reset the sensor */ |
| reg = readl_relaxed(priv->control); |
| writel((reg | PMU_TDC0_SW_RST_MASK), priv->control); |
| writel(reg, priv->control); |
| |
| /* Enable the sensor */ |
| reg = readl_relaxed(priv->sensor); |
| reg &= ~PMU_TM_DISABLE_MASK; |
| writel(reg, priv->sensor); |
| |
| /* Poll the sensor for the first reading */ |
| for (i = 0; i < 1000000; i++) { |
| reg = readl_relaxed(priv->sensor); |
| if (reg & DOVE_THERMAL_TEMP_MASK) |
| break; |
| } |
| |
| if (i == 1000000) |
| return -EIO; |
| |
| return 0; |
| } |
| |
| static int dove_get_temp(struct thermal_zone_device *thermal, |
| int *temp) |
| { |
| unsigned long reg; |
| struct dove_thermal_priv *priv = thermal->devdata; |
| |
| /* Valid check */ |
| reg = readl_relaxed(priv->control + PMU_TEMP_DIOD_CTRL1_REG); |
| if ((reg & PMU_TDC1_TEMP_VALID_MASK) == 0x0) { |
| dev_err(&thermal->device, |
| "Temperature sensor reading not valid\n"); |
| return -EIO; |
| } |
| |
| /* |
| * Calculate temperature. According to Marvell internal |
| * documentation the formula for this is: |
| * Celsius = (322-reg)/1.3625 |
| */ |
| reg = readl_relaxed(priv->sensor); |
| reg = (reg >> DOVE_THERMAL_TEMP_OFFSET) & DOVE_THERMAL_TEMP_MASK; |
| *temp = ((3220000000UL - (10000000UL * reg)) / 13625); |
| |
| return 0; |
| } |
| |
| static struct thermal_zone_device_ops ops = { |
| .get_temp = dove_get_temp, |
| }; |
| |
| static const struct of_device_id dove_thermal_id_table[] = { |
| { .compatible = "marvell,dove-thermal" }, |
| {} |
| }; |
| |
| static int dove_thermal_probe(struct platform_device *pdev) |
| { |
| struct thermal_zone_device *thermal = NULL; |
| struct dove_thermal_priv *priv; |
| struct resource *res; |
| int ret; |
| |
| priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 0); |
| priv->sensor = devm_ioremap_resource(&pdev->dev, res); |
| if (IS_ERR(priv->sensor)) |
| return PTR_ERR(priv->sensor); |
| |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 1); |
| priv->control = devm_ioremap_resource(&pdev->dev, res); |
| if (IS_ERR(priv->control)) |
| return PTR_ERR(priv->control); |
| |
| ret = dove_init_sensor(priv); |
| if (ret) { |
| dev_err(&pdev->dev, "Failed to initialize sensor\n"); |
| return ret; |
| } |
| |
| thermal = thermal_zone_device_register("dove_thermal", 0, 0, |
| priv, &ops, NULL, 0, 0); |
| if (IS_ERR(thermal)) { |
| dev_err(&pdev->dev, |
| "Failed to register thermal zone device\n"); |
| return PTR_ERR(thermal); |
| } |
| |
| platform_set_drvdata(pdev, thermal); |
| |
| return 0; |
| } |
| |
| static int dove_thermal_exit(struct platform_device *pdev) |
| { |
| struct thermal_zone_device *dove_thermal = |
| platform_get_drvdata(pdev); |
| |
| thermal_zone_device_unregister(dove_thermal); |
| |
| return 0; |
| } |
| |
| MODULE_DEVICE_TABLE(of, dove_thermal_id_table); |
| |
| static struct platform_driver dove_thermal_driver = { |
| .probe = dove_thermal_probe, |
| .remove = dove_thermal_exit, |
| .driver = { |
| .name = "dove_thermal", |
| .of_match_table = dove_thermal_id_table, |
| }, |
| }; |
| |
| module_platform_driver(dove_thermal_driver); |
| |
| MODULE_AUTHOR("Andrew Lunn <andrew@lunn.ch>"); |
| MODULE_DESCRIPTION("Dove thermal driver"); |
| MODULE_LICENSE("GPL"); |