| // SPDX-License-Identifier: GPL-2.0 |
| /** |
| * cdns3-ti.c - TI specific Glue layer for Cadence USB Controller |
| * |
| * Copyright (C) 2019 Texas Instruments Incorporated - https://www.ti.com |
| */ |
| |
| #include <linux/bits.h> |
| #include <linux/clk.h> |
| #include <linux/module.h> |
| #include <linux/kernel.h> |
| #include <linux/interrupt.h> |
| #include <linux/platform_device.h> |
| #include <linux/dma-mapping.h> |
| #include <linux/io.h> |
| #include <linux/of_platform.h> |
| #include <linux/pm_runtime.h> |
| |
| /* USB Wrapper register offsets */ |
| #define USBSS_PID 0x0 |
| #define USBSS_W1 0x4 |
| #define USBSS_STATIC_CONFIG 0x8 |
| #define USBSS_PHY_TEST 0xc |
| #define USBSS_DEBUG_CTRL 0x10 |
| #define USBSS_DEBUG_INFO 0x14 |
| #define USBSS_DEBUG_LINK_STATE 0x18 |
| #define USBSS_DEVICE_CTRL 0x1c |
| |
| /* Wrapper 1 register bits */ |
| #define USBSS_W1_PWRUP_RST BIT(0) |
| #define USBSS_W1_OVERCURRENT_SEL BIT(8) |
| #define USBSS_W1_MODESTRAP_SEL BIT(9) |
| #define USBSS_W1_OVERCURRENT BIT(16) |
| #define USBSS_W1_MODESTRAP_MASK GENMASK(18, 17) |
| #define USBSS_W1_MODESTRAP_SHIFT 17 |
| #define USBSS_W1_USB2_ONLY BIT(19) |
| |
| /* Static config register bits */ |
| #define USBSS1_STATIC_PLL_REF_SEL_MASK GENMASK(8, 5) |
| #define USBSS1_STATIC_PLL_REF_SEL_SHIFT 5 |
| #define USBSS1_STATIC_LOOPBACK_MODE_MASK GENMASK(4, 3) |
| #define USBSS1_STATIC_LOOPBACK_MODE_SHIFT 3 |
| #define USBSS1_STATIC_VBUS_SEL_MASK GENMASK(2, 1) |
| #define USBSS1_STATIC_VBUS_SEL_SHIFT 1 |
| #define USBSS1_STATIC_LANE_REVERSE BIT(0) |
| |
| /* Modestrap modes */ |
| enum modestrap_mode { USBSS_MODESTRAP_MODE_NONE, |
| USBSS_MODESTRAP_MODE_HOST, |
| USBSS_MODESTRAP_MODE_PERIPHERAL}; |
| |
| struct cdns_ti { |
| struct device *dev; |
| void __iomem *usbss; |
| unsigned usb2_only:1; |
| unsigned vbus_divider:1; |
| struct clk *usb2_refclk; |
| struct clk *lpm_clk; |
| }; |
| |
| static const int cdns_ti_rate_table[] = { /* in KHZ */ |
| 9600, |
| 10000, |
| 12000, |
| 19200, |
| 20000, |
| 24000, |
| 25000, |
| 26000, |
| 38400, |
| 40000, |
| 58000, |
| 50000, |
| 52000, |
| }; |
| |
| static inline u32 cdns_ti_readl(struct cdns_ti *data, u32 offset) |
| { |
| return readl(data->usbss + offset); |
| } |
| |
| static inline void cdns_ti_writel(struct cdns_ti *data, u32 offset, u32 value) |
| { |
| writel(value, data->usbss + offset); |
| } |
| |
| static int cdns_ti_probe(struct platform_device *pdev) |
| { |
| struct device *dev = &pdev->dev; |
| struct device_node *node = pdev->dev.of_node; |
| struct cdns_ti *data; |
| int error; |
| u32 reg; |
| int rate_code, i; |
| unsigned long rate; |
| |
| data = devm_kzalloc(dev, sizeof(*data), GFP_KERNEL); |
| if (!data) |
| return -ENOMEM; |
| |
| platform_set_drvdata(pdev, data); |
| |
| data->dev = dev; |
| |
| data->usbss = devm_platform_ioremap_resource(pdev, 0); |
| if (IS_ERR(data->usbss)) { |
| dev_err(dev, "can't map IOMEM resource\n"); |
| return PTR_ERR(data->usbss); |
| } |
| |
| data->usb2_refclk = devm_clk_get(dev, "ref"); |
| if (IS_ERR(data->usb2_refclk)) { |
| dev_err(dev, "can't get usb2_refclk\n"); |
| return PTR_ERR(data->usb2_refclk); |
| } |
| |
| data->lpm_clk = devm_clk_get(dev, "lpm"); |
| if (IS_ERR(data->lpm_clk)) { |
| dev_err(dev, "can't get lpm_clk\n"); |
| return PTR_ERR(data->lpm_clk); |
| } |
| |
| rate = clk_get_rate(data->usb2_refclk); |
| rate /= 1000; /* To KHz */ |
| for (i = 0; i < ARRAY_SIZE(cdns_ti_rate_table); i++) { |
| if (cdns_ti_rate_table[i] == rate) |
| break; |
| } |
| |
| if (i == ARRAY_SIZE(cdns_ti_rate_table)) { |
| dev_err(dev, "unsupported usb2_refclk rate: %lu KHz\n", rate); |
| return -EINVAL; |
| } |
| |
| rate_code = i; |
| |
| pm_runtime_enable(dev); |
| error = pm_runtime_get_sync(dev); |
| if (error < 0) { |
| dev_err(dev, "pm_runtime_get_sync failed: %d\n", error); |
| goto err; |
| } |
| |
| /* assert RESET */ |
| reg = cdns_ti_readl(data, USBSS_W1); |
| reg &= ~USBSS_W1_PWRUP_RST; |
| cdns_ti_writel(data, USBSS_W1, reg); |
| |
| /* set static config */ |
| reg = cdns_ti_readl(data, USBSS_STATIC_CONFIG); |
| reg &= ~USBSS1_STATIC_PLL_REF_SEL_MASK; |
| reg |= rate_code << USBSS1_STATIC_PLL_REF_SEL_SHIFT; |
| |
| reg &= ~USBSS1_STATIC_VBUS_SEL_MASK; |
| data->vbus_divider = device_property_read_bool(dev, "ti,vbus-divider"); |
| if (data->vbus_divider) |
| reg |= 1 << USBSS1_STATIC_VBUS_SEL_SHIFT; |
| |
| cdns_ti_writel(data, USBSS_STATIC_CONFIG, reg); |
| reg = cdns_ti_readl(data, USBSS_STATIC_CONFIG); |
| |
| /* set USB2_ONLY mode if requested */ |
| reg = cdns_ti_readl(data, USBSS_W1); |
| data->usb2_only = device_property_read_bool(dev, "ti,usb2-only"); |
| if (data->usb2_only) |
| reg |= USBSS_W1_USB2_ONLY; |
| |
| /* set default modestrap */ |
| reg |= USBSS_W1_MODESTRAP_SEL; |
| reg &= ~USBSS_W1_MODESTRAP_MASK; |
| reg |= USBSS_MODESTRAP_MODE_NONE << USBSS_W1_MODESTRAP_SHIFT; |
| cdns_ti_writel(data, USBSS_W1, reg); |
| |
| /* de-assert RESET */ |
| reg |= USBSS_W1_PWRUP_RST; |
| cdns_ti_writel(data, USBSS_W1, reg); |
| |
| error = of_platform_populate(node, NULL, NULL, dev); |
| if (error) { |
| dev_err(dev, "failed to create children: %d\n", error); |
| goto err; |
| } |
| |
| return 0; |
| |
| err: |
| pm_runtime_put_sync(data->dev); |
| pm_runtime_disable(data->dev); |
| |
| return error; |
| } |
| |
| static int cdns_ti_remove_core(struct device *dev, void *c) |
| { |
| struct platform_device *pdev = to_platform_device(dev); |
| |
| platform_device_unregister(pdev); |
| |
| return 0; |
| } |
| |
| static int cdns_ti_remove(struct platform_device *pdev) |
| { |
| struct device *dev = &pdev->dev; |
| |
| device_for_each_child(dev, NULL, cdns_ti_remove_core); |
| pm_runtime_put_sync(dev); |
| pm_runtime_disable(dev); |
| |
| platform_set_drvdata(pdev, NULL); |
| |
| return 0; |
| } |
| |
| static const struct of_device_id cdns_ti_of_match[] = { |
| { .compatible = "ti,j721e-usb", }, |
| {}, |
| }; |
| MODULE_DEVICE_TABLE(of, cdns_ti_of_match); |
| |
| static struct platform_driver cdns_ti_driver = { |
| .probe = cdns_ti_probe, |
| .remove = cdns_ti_remove, |
| .driver = { |
| .name = "cdns3-ti", |
| .of_match_table = cdns_ti_of_match, |
| }, |
| }; |
| |
| module_platform_driver(cdns_ti_driver); |
| |
| MODULE_ALIAS("platform:cdns3-ti"); |
| MODULE_AUTHOR("Roger Quadros <rogerq@ti.com>"); |
| MODULE_LICENSE("GPL v2"); |
| MODULE_DESCRIPTION("Cadence USB3 TI Glue Layer"); |