| // SPDX-License-Identifier: GPL-2.0+ | |
| /* | |
| * Copyright 2017 NXP | |
| * | |
| * CORTINA is a registered trademark of Cortina Systems, Inc. | |
| * | |
| */ | |
| #include <linux/module.h> | |
| #include <linux/phy.h> | |
| #define PHY_ID_CS4340 0x13e51002 | |
| #define VILLA_GLOBAL_CHIP_ID_LSB 0x0 | |
| #define VILLA_GLOBAL_CHIP_ID_MSB 0x1 | |
| #define VILLA_GLOBAL_GPIO_1_INTS 0x017 | |
| static int cortina_read_reg(struct phy_device *phydev, u16 regnum) | |
| { | |
| return mdiobus_read(phydev->mdio.bus, phydev->mdio.addr, | |
| MII_ADDR_C45 | regnum); | |
| } | |
| static int cortina_read_status(struct phy_device *phydev) | |
| { | |
| int gpio_int_status, ret = 0; | |
| gpio_int_status = cortina_read_reg(phydev, VILLA_GLOBAL_GPIO_1_INTS); | |
| if (gpio_int_status < 0) { | |
| ret = gpio_int_status; | |
| goto err; | |
| } | |
| if (gpio_int_status & 0x8) { | |
| /* up when edc_convergedS set */ | |
| phydev->speed = SPEED_10000; | |
| phydev->duplex = DUPLEX_FULL; | |
| phydev->link = 1; | |
| } else { | |
| phydev->link = 0; | |
| } | |
| err: | |
| return ret; | |
| } | |
| static int cortina_probe(struct phy_device *phydev) | |
| { | |
| u32 phy_id = 0; | |
| int id_lsb = 0, id_msb = 0; | |
| /* Read device id from phy registers. */ | |
| id_lsb = cortina_read_reg(phydev, VILLA_GLOBAL_CHIP_ID_LSB); | |
| if (id_lsb < 0) | |
| return -ENXIO; | |
| phy_id = id_lsb << 16; | |
| id_msb = cortina_read_reg(phydev, VILLA_GLOBAL_CHIP_ID_MSB); | |
| if (id_msb < 0) | |
| return -ENXIO; | |
| phy_id |= id_msb; | |
| /* Make sure the device tree binding matched the driver with the | |
| * right device. | |
| */ | |
| if (phy_id != phydev->drv->phy_id) { | |
| phydev_err(phydev, "Error matching phy with %s driver\n", | |
| phydev->drv->name); | |
| return -ENODEV; | |
| } | |
| return 0; | |
| } | |
| static struct phy_driver cortina_driver[] = { | |
| { | |
| .phy_id = PHY_ID_CS4340, | |
| .phy_id_mask = 0xffffffff, | |
| .name = "Cortina CS4340", | |
| .features = PHY_10GBIT_FEATURES, | |
| .config_aneg = gen10g_config_aneg, | |
| .read_status = cortina_read_status, | |
| .soft_reset = genphy_no_soft_reset, | |
| .probe = cortina_probe, | |
| }, | |
| }; | |
| module_phy_driver(cortina_driver); | |
| static struct mdio_device_id __maybe_unused cortina_tbl[] = { | |
| { PHY_ID_CS4340, 0xffffffff}, | |
| {}, | |
| }; | |
| MODULE_DEVICE_TABLE(mdio, cortina_tbl); | |
| MODULE_DESCRIPTION("Cortina EDC CDR 10G Ethernet PHY driver"); | |
| MODULE_AUTHOR("NXP"); | |
| MODULE_LICENSE("GPL"); |