blob: 76d649b3a25dc0ae1a42e352a4c506ead6d77a74 [file] [log] [blame]
* Atmel Extensible Direct Memory Access Controller (XDMAC)
* XDMA Controller
Required properties:
- compatible: Should be "atmel,sama5d4-dma", "microchip,sam9x60-dma" or
"microchip,sama7g5-dma" or
"microchip,sam9x7-dma", "atmel,sama5d4-dma".
- reg: Should contain DMA registers location and length.
- interrupts: Should contain DMA interrupt.
- #dma-cells: Must be <1>, used to represent the number of integer cells in
the dmas property of client devices.
- The 1st cell specifies the channel configuration register:
- bit 13: SIF, source interface identifier, used to get the memory
interface identifier,
- bit 14: DIF, destination interface identifier, used to get the peripheral
interface identifier,
- bit 30-24: PERID, peripheral identifier.
Example:
dma1: dma-controller@f0004000 {
compatible = "atmel,sama5d4-dma";
reg = <0xf0004000 0x200>;
interrupts = <50 4 0>;
#dma-cells = <1>;
};
* DMA clients
DMA clients connected to the Atmel XDMA controller must use the format
described in the dma.txt file, using a one-cell specifier for each channel.
The two cells in order are:
1. A phandle pointing to the DMA controller.
2. Channel configuration register. Configurable fields are:
- bit 13: SIF, source interface identifier, used to get the memory
interface identifier,
- bit 14: DIF, destination interface identifier, used to get the peripheral
interface identifier,
- bit 30-24: PERID, peripheral identifier.
Example:
i2c2: i2c@f8024000 {
compatible = "atmel,at91sam9x5-i2c";
reg = <0xf8024000 0x4000>;
interrupts = <34 4 6>;
dmas = <&dma1
(AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1)
| AT91_XDMAC_DT_PERID(6))>,
<&dma1
(AT91_XDMAC_DT_MEM_IF(0) | AT91_XDMAC_DT_PER_IF(1)
| AT91_XDMAC_DT_PERID(7))>;
dma-names = "tx", "rx";
};