| // SPDX-License-Identifier: GPL-2.0 |
| #include "versatile-ab.dts" |
| |
| / { |
| model = "ARM Versatile PB"; |
| compatible = "arm,versatile-pb"; |
| |
| amba { |
| /* The Versatile PB is using more SIC IRQ lines than the AB */ |
| sic: interrupt-controller@10003000 { |
| clear-mask = <0xffffffff>; |
| /* |
| * Valid interrupt lines mask according to |
| * figure 3-30 page 3-74 of ARM DUI 0224B |
| */ |
| valid-mask = <0x7fe003ff>; |
| }; |
| |
| gpio2: gpio@101e6000 { |
| compatible = "arm,pl061", "arm,primecell"; |
| reg = <0x101e6000 0x1000>; |
| interrupts = <8>; |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| clocks = <&pclk>; |
| clock-names = "apb_pclk"; |
| }; |
| |
| gpio3: gpio@101e7000 { |
| compatible = "arm,pl061", "arm,primecell"; |
| reg = <0x101e7000 0x1000>; |
| interrupts = <9>; |
| gpio-controller; |
| #gpio-cells = <2>; |
| interrupt-controller; |
| #interrupt-cells = <2>; |
| clocks = <&pclk>; |
| clock-names = "apb_pclk"; |
| }; |
| |
| pci@10001000 { |
| compatible = "arm,versatile-pci"; |
| device_type = "pci"; |
| reg = <0x10001000 0x1000 |
| 0x41000000 0x10000 |
| 0x42000000 0x100000>; |
| bus-range = <0 0xff>; |
| #address-cells = <3>; |
| #size-cells = <2>; |
| #interrupt-cells = <1>; |
| |
| ranges = <0x01000000 0 0x00000000 0x43000000 0 0x00010000 /* downstream I/O */ |
| 0x02000000 0 0x50000000 0x50000000 0 0x10000000 /* non-prefetchable memory */ |
| 0x42000000 0 0x60000000 0x60000000 0 0x10000000>; /* prefetchable memory */ |
| |
| interrupt-map-mask = <0x1800 0 0 7>; |
| interrupt-map = <0x1800 0 0 1 &sic 28 |
| 0x1800 0 0 2 &sic 29 |
| 0x1800 0 0 3 &sic 30 |
| 0x1800 0 0 4 &sic 27 |
| |
| 0x1000 0 0 1 &sic 27 |
| 0x1000 0 0 2 &sic 28 |
| 0x1000 0 0 3 &sic 29 |
| 0x1000 0 0 4 &sic 30 |
| |
| 0x0800 0 0 1 &sic 30 |
| 0x0800 0 0 2 &sic 27 |
| 0x0800 0 0 3 &sic 28 |
| 0x0800 0 0 4 &sic 29 |
| |
| 0x0000 0 0 1 &sic 29 |
| 0x0000 0 0 2 &sic 30 |
| 0x0000 0 0 3 &sic 27 |
| 0x0000 0 0 4 &sic 28>; |
| }; |
| |
| fpga { |
| mmc@5000 { |
| /* |
| * Overrides the interrupt assignment from |
| * the Versatile AB board file. |
| */ |
| interrupts-extended = <&sic 22 &sic 23>; |
| }; |
| uart@9000 { |
| compatible = "arm,pl011", "arm,primecell"; |
| reg = <0x9000 0x1000>; |
| interrupt-parent = <&sic>; |
| interrupts = <6>; |
| clocks = <&xtal24mhz>, <&pclk>; |
| clock-names = "uartclk", "apb_pclk"; |
| }; |
| sci@a000 { |
| compatible = "arm,primecell"; |
| reg = <0xa000 0x1000>; |
| interrupt-parent = <&sic>; |
| interrupts = <5>; |
| clocks = <&xtal24mhz>; |
| clock-names = "apb_pclk"; |
| }; |
| mmc@b000 { |
| compatible = "arm,pl180", "arm,primecell"; |
| reg = <0xb000 0x1000>; |
| interrupt-parent = <&sic>; |
| interrupts = <1>, <2>; |
| clocks = <&xtal24mhz>, <&pclk>; |
| clock-names = "mclk", "apb_pclk"; |
| }; |
| }; |
| }; |
| }; |