blob: 5ffdf37d8e31512b0aaf1ca40288593c51281abc [file] [log] [blame]
// SPDX-License-Identifier: GPL-2.0
#include <dt-bindings/iio/qcom,spmi-vadc.h>
#include <dt-bindings/input/linux-event-codes.h>
#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/spmi/spmi.h>
/ {
thermal-zones {
pm8994 {
polling-delay-passive = <250>;
polling-delay = <1000>;
thermal-sensors = <&pm8994_temp>;
trips {
pm8994_alert0: pm8994-alert0 {
temperature = <95000>;
hysteresis = <2000>;
type = "passive";
};
pm8994_crit: pm8994-crit {
temperature = <125000>;
hysteresis = <2000>;
type = "critical";
};
};
};
};
};
&spmi_bus {
pmic@0 {
compatible = "qcom,pm8994", "qcom,spmi-pmic";
reg = <0x0 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
rtc@6000 {
compatible = "qcom,pm8941-rtc";
reg = <0x6000>, <0x6100>;
reg-names = "rtc", "alarm";
interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
};
pon@800 {
compatible = "qcom,pm8916-pon";
reg = <0x800>;
mode-bootloader = <0x2>;
mode-recovery = <0x1>;
pwrkey {
compatible = "qcom,pm8941-pwrkey";
interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
debounce = <15625>;
bias-pull-up;
linux,code = <KEY_POWER>;
};
};
pm8994_temp: temp-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
reg = <0x2400>;
interrupts = <0x0 0x24 0x0 IRQ_TYPE_EDGE_RISING>;
io-channels = <&pm8994_vadc VADC_DIE_TEMP>;
io-channel-names = "thermal";
#thermal-sensor-cells = <0>;
};
pm8994_vadc: adc@3100 {
compatible = "qcom,spmi-vadc";
reg = <0x3100>;
interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
#address-cells = <1>;
#size-cells = <0>;
#io-channel-cells = <1>;
adc-chan@7 {
reg = <VADC_VSYS>;
qcom,pre-scaling = <1 3>;
label = "vph_pwr";
};
adc-chan@8 {
reg = <VADC_DIE_TEMP>;
label = "die_temp";
};
adc-chan@9 {
reg = <VADC_REF_625MV>;
label = "ref_625mv";
};
adc-chan@a {
reg = <VADC_REF_1250MV>;
label = "ref_1250mv";
};
adc-chan@e {
reg = <VADC_GND_REF>;
};
adc-chan@f {
reg = <VADC_VDD_VADC>;
};
};
pm8994_gpios: gpios@c000 {
compatible = "qcom,pm8994-gpio", "qcom,spmi-gpio";
reg = <0xc000>;
gpio-controller;
gpio-ranges = <&pm8994_gpios 0 0 22>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
pm8994_mpps: mpps@a000 {
compatible = "qcom,pm8994-mpp";
reg = <0xa000>;
gpio-controller;
#gpio-cells = <2>;
interrupts = <0 0xa0 0 IRQ_TYPE_NONE>,
<0 0xa1 0 IRQ_TYPE_NONE>,
<0 0xa2 0 IRQ_TYPE_NONE>,
<0 0xa3 0 IRQ_TYPE_NONE>,
<0 0xa4 0 IRQ_TYPE_NONE>,
<0 0xa5 0 IRQ_TYPE_NONE>,
<0 0xa6 0 IRQ_TYPE_NONE>,
<0 0xa7 0 IRQ_TYPE_NONE>;
};
};
pmic@1 {
compatible = "qcom,pm8994", "qcom,spmi-pmic";
reg = <0x1 SPMI_USID>;
#address-cells = <1>;
#size-cells = <0>;
pm8994_spmi_regulators: regulators {
compatible = "qcom,pm8994-regulators";
};
};
};