| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * Copyright (C) 2012 Invensense, Inc. |
| */ |
| |
| #include <linux/pm_runtime.h> |
| #include "inv_mpu_iio.h" |
| |
| static unsigned int inv_scan_query_mpu6050(struct iio_dev *indio_dev) |
| { |
| struct inv_mpu6050_state *st = iio_priv(indio_dev); |
| unsigned int mask; |
| |
| st->chip_config.gyro_fifo_enable = |
| test_bit(INV_MPU6050_SCAN_GYRO_X, |
| indio_dev->active_scan_mask) || |
| test_bit(INV_MPU6050_SCAN_GYRO_Y, |
| indio_dev->active_scan_mask) || |
| test_bit(INV_MPU6050_SCAN_GYRO_Z, |
| indio_dev->active_scan_mask); |
| |
| st->chip_config.accl_fifo_enable = |
| test_bit(INV_MPU6050_SCAN_ACCL_X, |
| indio_dev->active_scan_mask) || |
| test_bit(INV_MPU6050_SCAN_ACCL_Y, |
| indio_dev->active_scan_mask) || |
| test_bit(INV_MPU6050_SCAN_ACCL_Z, |
| indio_dev->active_scan_mask); |
| |
| st->chip_config.temp_fifo_enable = |
| test_bit(INV_MPU6050_SCAN_TEMP, indio_dev->active_scan_mask); |
| |
| mask = 0; |
| if (st->chip_config.gyro_fifo_enable) |
| mask |= INV_MPU6050_SENSOR_GYRO; |
| if (st->chip_config.accl_fifo_enable) |
| mask |= INV_MPU6050_SENSOR_ACCL; |
| if (st->chip_config.temp_fifo_enable) |
| mask |= INV_MPU6050_SENSOR_TEMP; |
| |
| return mask; |
| } |
| |
| static unsigned int inv_scan_query_mpu9x50(struct iio_dev *indio_dev) |
| { |
| struct inv_mpu6050_state *st = iio_priv(indio_dev); |
| unsigned int mask; |
| |
| mask = inv_scan_query_mpu6050(indio_dev); |
| |
| /* no magnetometer if i2c auxiliary bus is used */ |
| if (st->magn_disabled) |
| return mask; |
| |
| st->chip_config.magn_fifo_enable = |
| test_bit(INV_MPU9X50_SCAN_MAGN_X, |
| indio_dev->active_scan_mask) || |
| test_bit(INV_MPU9X50_SCAN_MAGN_Y, |
| indio_dev->active_scan_mask) || |
| test_bit(INV_MPU9X50_SCAN_MAGN_Z, |
| indio_dev->active_scan_mask); |
| if (st->chip_config.magn_fifo_enable) |
| mask |= INV_MPU6050_SENSOR_MAGN; |
| |
| return mask; |
| } |
| |
| static unsigned int inv_scan_query(struct iio_dev *indio_dev) |
| { |
| struct inv_mpu6050_state *st = iio_priv(indio_dev); |
| |
| switch (st->chip_type) { |
| case INV_MPU9150: |
| case INV_MPU9250: |
| case INV_MPU9255: |
| return inv_scan_query_mpu9x50(indio_dev); |
| default: |
| return inv_scan_query_mpu6050(indio_dev); |
| } |
| } |
| |
| static unsigned int inv_compute_skip_samples(const struct inv_mpu6050_state *st) |
| { |
| unsigned int gyro_skip = 0; |
| unsigned int magn_skip = 0; |
| unsigned int skip_samples; |
| |
| /* gyro first sample is out of specs, skip it */ |
| if (st->chip_config.gyro_fifo_enable) |
| gyro_skip = 1; |
| |
| /* mag first sample is always not ready, skip it */ |
| if (st->chip_config.magn_fifo_enable) |
| magn_skip = 1; |
| |
| /* compute first samples to skip */ |
| skip_samples = gyro_skip; |
| if (magn_skip > skip_samples) |
| skip_samples = magn_skip; |
| |
| return skip_samples; |
| } |
| |
| int inv_mpu6050_prepare_fifo(struct inv_mpu6050_state *st, bool enable) |
| { |
| uint8_t d; |
| int ret; |
| |
| if (enable) { |
| st->it_timestamp = 0; |
| /* reset FIFO */ |
| d = st->chip_config.user_ctrl | INV_MPU6050_BIT_FIFO_RST; |
| ret = regmap_write(st->map, st->reg->user_ctrl, d); |
| if (ret) |
| return ret; |
| /* enable sensor output to FIFO */ |
| d = 0; |
| if (st->chip_config.gyro_fifo_enable) |
| d |= INV_MPU6050_BITS_GYRO_OUT; |
| if (st->chip_config.accl_fifo_enable) |
| d |= INV_MPU6050_BIT_ACCEL_OUT; |
| if (st->chip_config.temp_fifo_enable) |
| d |= INV_MPU6050_BIT_TEMP_OUT; |
| if (st->chip_config.magn_fifo_enable) |
| d |= INV_MPU6050_BIT_SLAVE_0; |
| ret = regmap_write(st->map, st->reg->fifo_en, d); |
| if (ret) |
| return ret; |
| /* enable FIFO reading */ |
| d = st->chip_config.user_ctrl | INV_MPU6050_BIT_FIFO_EN; |
| ret = regmap_write(st->map, st->reg->user_ctrl, d); |
| if (ret) |
| return ret; |
| /* enable interrupt */ |
| ret = regmap_write(st->map, st->reg->int_enable, |
| INV_MPU6050_BIT_DATA_RDY_EN); |
| } else { |
| ret = regmap_write(st->map, st->reg->int_enable, 0); |
| if (ret) |
| return ret; |
| ret = regmap_write(st->map, st->reg->fifo_en, 0); |
| if (ret) |
| return ret; |
| /* restore user_ctrl for disabling FIFO reading */ |
| ret = regmap_write(st->map, st->reg->user_ctrl, |
| st->chip_config.user_ctrl); |
| } |
| |
| return ret; |
| } |
| |
| /** |
| * inv_mpu6050_set_enable() - enable chip functions. |
| * @indio_dev: Device driver instance. |
| * @enable: enable/disable |
| */ |
| static int inv_mpu6050_set_enable(struct iio_dev *indio_dev, bool enable) |
| { |
| struct inv_mpu6050_state *st = iio_priv(indio_dev); |
| struct device *pdev = regmap_get_device(st->map); |
| unsigned int scan; |
| int result; |
| |
| if (enable) { |
| scan = inv_scan_query(indio_dev); |
| result = pm_runtime_get_sync(pdev); |
| if (result < 0) { |
| pm_runtime_put_noidle(pdev); |
| return result; |
| } |
| /* |
| * In case autosuspend didn't trigger, turn off first not |
| * required sensors. |
| */ |
| result = inv_mpu6050_switch_engine(st, false, ~scan); |
| if (result) |
| goto error_power_off; |
| result = inv_mpu6050_switch_engine(st, true, scan); |
| if (result) |
| goto error_power_off; |
| st->skip_samples = inv_compute_skip_samples(st); |
| result = inv_mpu6050_prepare_fifo(st, true); |
| if (result) |
| goto error_power_off; |
| } else { |
| result = inv_mpu6050_prepare_fifo(st, false); |
| if (result) |
| goto error_power_off; |
| pm_runtime_mark_last_busy(pdev); |
| pm_runtime_put_autosuspend(pdev); |
| } |
| |
| return 0; |
| |
| error_power_off: |
| pm_runtime_put_autosuspend(pdev); |
| return result; |
| } |
| |
| /** |
| * inv_mpu_data_rdy_trigger_set_state() - set data ready interrupt state |
| * @trig: Trigger instance |
| * @state: Desired trigger state |
| */ |
| static int inv_mpu_data_rdy_trigger_set_state(struct iio_trigger *trig, |
| bool state) |
| { |
| struct iio_dev *indio_dev = iio_trigger_get_drvdata(trig); |
| struct inv_mpu6050_state *st = iio_priv(indio_dev); |
| int result; |
| |
| mutex_lock(&st->lock); |
| result = inv_mpu6050_set_enable(indio_dev, state); |
| mutex_unlock(&st->lock); |
| |
| return result; |
| } |
| |
| static const struct iio_trigger_ops inv_mpu_trigger_ops = { |
| .set_trigger_state = &inv_mpu_data_rdy_trigger_set_state, |
| }; |
| |
| int inv_mpu6050_probe_trigger(struct iio_dev *indio_dev, int irq_type) |
| { |
| int ret; |
| struct inv_mpu6050_state *st = iio_priv(indio_dev); |
| |
| st->trig = devm_iio_trigger_alloc(&indio_dev->dev, |
| "%s-dev%d", |
| indio_dev->name, |
| indio_dev->id); |
| if (!st->trig) |
| return -ENOMEM; |
| |
| ret = devm_request_irq(&indio_dev->dev, st->irq, |
| &iio_trigger_generic_data_rdy_poll, |
| irq_type, |
| "inv_mpu", |
| st->trig); |
| if (ret) |
| return ret; |
| |
| st->trig->dev.parent = regmap_get_device(st->map); |
| st->trig->ops = &inv_mpu_trigger_ops; |
| iio_trigger_set_drvdata(st->trig, indio_dev); |
| |
| ret = devm_iio_trigger_register(&indio_dev->dev, st->trig); |
| if (ret) |
| return ret; |
| |
| indio_dev->trig = iio_trigger_get(st->trig); |
| |
| return 0; |
| } |