| * Mediatek Universal Asynchronous Receiver/Transmitter (UART) |
| |
| Required properties: |
| - compatible should contain: |
| * "mediatek,mt8135-uart" for MT8135 compatible UARTS |
| * "mediatek,mt8127-uart" for MT8127 compatible UARTS |
| * "mediatek,mt8173-uart" for MT8173 compatible UARTS |
| * "mediatek,mt6589-uart" for MT6589 compatible UARTS |
| * "mediatek,mt6582-uart" for MT6582 compatible UARTS |
| * "mediatek,mt6577-uart" for all compatible UARTS (MT8173, MT6589, MT6582, |
| MT6577) |
| |
| - reg: The base address of the UART register bank. |
| |
| - interrupts: A single interrupt specifier. |
| |
| - clocks : Must contain an entry for each entry in clock-names. |
| See ../clocks/clock-bindings.txt for details. |
| - clock-names: |
| - "baud": The clock the baudrate is derived from |
| - "bus": The bus clock for register accesses (optional) |
| |
| For compatibility with older device trees an unnamed clock is used for the |
| baud clock if the baudclk does not exist. Do not use this for new designs. |
| |
| Example: |
| |
| uart0: serial@11006000 { |
| compatible = "mediatek,mt6589-uart", "mediatek,mt6577-uart"; |
| reg = <0x11006000 0x400>; |
| interrupts = <GIC_SPI 51 IRQ_TYPE_LEVEL_LOW>; |
| clocks = <&uart_clk>, <&bus_clk>; |
| clock-names = "baud", "bus"; |
| }; |
