| // SPDX-License-Identifier: GPL-2.0 |
| // Copyright (C) STMicroelectronics 2019 |
| // Authors: Gabriel Fernandez <gabriel.fernandez@st.com> |
| // Pascal Paillet <p.paillet@st.com>. |
| |
| #include <linux/io.h> |
| #include <linux/iopoll.h> |
| #include <linux/module.h> |
| #include <linux/of_address.h> |
| #include <linux/of_device.h> |
| #include <linux/platform_device.h> |
| #include <linux/regulator/driver.h> |
| #include <linux/regulator/of_regulator.h> |
| |
| /* |
| * Registers description |
| */ |
| #define REG_PWR_CR3 0x0C |
| |
| #define USB_3_3_EN BIT(24) |
| #define USB_3_3_RDY BIT(26) |
| #define REG_1_8_EN BIT(28) |
| #define REG_1_8_RDY BIT(29) |
| #define REG_1_1_EN BIT(30) |
| #define REG_1_1_RDY BIT(31) |
| |
| /* list of supported regulators */ |
| enum { |
| PWR_REG11, |
| PWR_REG18, |
| PWR_USB33, |
| STM32PWR_REG_NUM_REGS |
| }; |
| |
| static u32 ready_mask_table[STM32PWR_REG_NUM_REGS] = { |
| [PWR_REG11] = REG_1_1_RDY, |
| [PWR_REG18] = REG_1_8_RDY, |
| [PWR_USB33] = USB_3_3_RDY, |
| }; |
| |
| struct stm32_pwr_reg { |
| void __iomem *base; |
| u32 ready_mask; |
| }; |
| |
| static int stm32_pwr_reg_is_ready(struct regulator_dev *rdev) |
| { |
| struct stm32_pwr_reg *priv = rdev_get_drvdata(rdev); |
| u32 val; |
| |
| val = readl_relaxed(priv->base + REG_PWR_CR3); |
| |
| return (val & priv->ready_mask); |
| } |
| |
| static int stm32_pwr_reg_is_enabled(struct regulator_dev *rdev) |
| { |
| struct stm32_pwr_reg *priv = rdev_get_drvdata(rdev); |
| u32 val; |
| |
| val = readl_relaxed(priv->base + REG_PWR_CR3); |
| |
| return (val & rdev->desc->enable_mask); |
| } |
| |
| static int stm32_pwr_reg_enable(struct regulator_dev *rdev) |
| { |
| struct stm32_pwr_reg *priv = rdev_get_drvdata(rdev); |
| int ret; |
| u32 val; |
| |
| val = readl_relaxed(priv->base + REG_PWR_CR3); |
| val |= rdev->desc->enable_mask; |
| writel_relaxed(val, priv->base + REG_PWR_CR3); |
| |
| /* use an arbitrary timeout of 20ms */ |
| ret = readx_poll_timeout(stm32_pwr_reg_is_ready, rdev, val, val, |
| 100, 20 * 1000); |
| if (ret) |
| dev_err(&rdev->dev, "regulator enable timed out!\n"); |
| |
| return ret; |
| } |
| |
| static int stm32_pwr_reg_disable(struct regulator_dev *rdev) |
| { |
| struct stm32_pwr_reg *priv = rdev_get_drvdata(rdev); |
| int ret; |
| u32 val; |
| |
| val = readl_relaxed(priv->base + REG_PWR_CR3); |
| val &= ~rdev->desc->enable_mask; |
| writel_relaxed(val, priv->base + REG_PWR_CR3); |
| |
| /* use an arbitrary timeout of 20ms */ |
| ret = readx_poll_timeout(stm32_pwr_reg_is_ready, rdev, val, !val, |
| 100, 20 * 1000); |
| if (ret) |
| dev_err(&rdev->dev, "regulator disable timed out!\n"); |
| |
| return ret; |
| } |
| |
| static const struct regulator_ops stm32_pwr_reg_ops = { |
| .enable = stm32_pwr_reg_enable, |
| .disable = stm32_pwr_reg_disable, |
| .is_enabled = stm32_pwr_reg_is_enabled, |
| }; |
| |
| #define PWR_REG(_id, _name, _volt, _en, _supply) \ |
| [_id] = { \ |
| .id = _id, \ |
| .name = _name, \ |
| .of_match = of_match_ptr(_name), \ |
| .n_voltages = 1, \ |
| .type = REGULATOR_VOLTAGE, \ |
| .fixed_uV = _volt, \ |
| .ops = &stm32_pwr_reg_ops, \ |
| .enable_mask = _en, \ |
| .owner = THIS_MODULE, \ |
| .supply_name = _supply, \ |
| } \ |
| |
| static const struct regulator_desc stm32_pwr_desc[] = { |
| PWR_REG(PWR_REG11, "reg11", 1100000, REG_1_1_EN, "vdd"), |
| PWR_REG(PWR_REG18, "reg18", 1800000, REG_1_8_EN, "vdd"), |
| PWR_REG(PWR_USB33, "usb33", 3300000, USB_3_3_EN, "vdd_3v3_usbfs"), |
| }; |
| |
| static int stm32_pwr_regulator_probe(struct platform_device *pdev) |
| { |
| struct stm32_pwr_reg *priv; |
| void __iomem *base; |
| struct regulator_dev *rdev; |
| struct regulator_config config = { }; |
| int i, ret = 0; |
| |
| base = devm_platform_ioremap_resource(pdev, 0); |
| if (IS_ERR(base)) { |
| dev_err(&pdev->dev, "Unable to map IO memory\n"); |
| return PTR_ERR(base); |
| } |
| |
| config.dev = &pdev->dev; |
| |
| for (i = 0; i < STM32PWR_REG_NUM_REGS; i++) { |
| priv = devm_kzalloc(&pdev->dev, sizeof(struct stm32_pwr_reg), |
| GFP_KERNEL); |
| if (!priv) |
| return -ENOMEM; |
| priv->base = base; |
| priv->ready_mask = ready_mask_table[i]; |
| config.driver_data = priv; |
| |
| rdev = devm_regulator_register(&pdev->dev, |
| &stm32_pwr_desc[i], |
| &config); |
| if (IS_ERR(rdev)) { |
| ret = PTR_ERR(rdev); |
| dev_err(&pdev->dev, |
| "Failed to register regulator: %d\n", ret); |
| break; |
| } |
| } |
| return ret; |
| } |
| |
| static const struct of_device_id __maybe_unused stm32_pwr_of_match[] = { |
| { .compatible = "st,stm32mp1,pwr-reg", }, |
| {}, |
| }; |
| MODULE_DEVICE_TABLE(of, stm32_pwr_of_match); |
| |
| static struct platform_driver stm32_pwr_driver = { |
| .probe = stm32_pwr_regulator_probe, |
| .driver = { |
| .name = "stm32-pwr-regulator", |
| .probe_type = PROBE_PREFER_ASYNCHRONOUS, |
| .of_match_table = of_match_ptr(stm32_pwr_of_match), |
| }, |
| }; |
| module_platform_driver(stm32_pwr_driver); |
| |
| MODULE_DESCRIPTION("STM32MP1 PWR voltage regulator driver"); |
| MODULE_AUTHOR("Pascal Paillet <p.paillet@st.com>"); |